dr inż. Jacek Czyżewicz
- Adiunkt at Department of Machine Design and Vehicles
- refuse collection vehicle, drive system, reducing fuel consumption
- mechanizm prasujacy smieciarki
- zuzycie paliwa
- can bus
- charakterystyka ogolna
- cold-formed thin-walled sections
- combustion engine
- energy consumption, fuel consumption, working cycle efficiency, waste collection vehicle, refuse collection vehicle
In machine industry, stresses are often calculated using simple linear FEM analysis. Occasional failures of elements designed in such a way require recomputation by means of more sophisticated methods, eg. including plasticity and non-linear effects. It usually leads to investigation of failure causes and improvement of an element in order to prevent its unwanted behavior in the future. The study presents the case where both linear...
Evaluation of the efficiency of the duty cycle of refuse collection vehicle based on real-world data
In this paper a method of the efficiency evaluation of the duty cycle of Refuse Collection Vehicle is presented. Using real world data, two representative duty cycles were analysed. Total cycle efficiency was calculated, as well as the efficiency of particular cycle phases. Then, energy needed to collect and compact the waste and energy from fuel were compared. Measured and calculated values were shown on the diagrams illustrating...
Energetic model of hydraulic system of refuse collection vehicle based on simulation and experimental data
This paper presents an energetic model of hydraulic system of a refuse collection vehicle. First, benefits resulting from implementation of an energetic model in the industry and operation of a Refuse Collection Vehicle are briefly explained. Then, components of the energy consumption in hydraulic circuits of compactor and lifting device are described and combined into a comprehensive model that can be evaluated using basic measurement...
seen 832 times