mgr inż. Kamil Trzebiatowski
Employment
- IT Specialist at Department of Microwave and Antenna Engineering
- 2018 - present Researcher at Department of Microwave and Antenna Engineering
Keywords Help
- chipless radio-frequency identification (rfid)
- internet-of-things
- millimeter wave identification (mmid)
- radar cross-section (rcs)
- van atta array
- 3-d printing
- 3d printing , additive manufacturing , cubesat , fifth-generation (5 g) communication , internet-of-things , millimeter-wave antenna , passive multi-beam antennas , reconfigurable antennas , switched-beam antennas
- 5g
- 5g, switched-beam antenna, reconfigurable antenna, beam control, lens antenna, antenna array, direction-of- arrival estimation, internet-of-things, wireless sensor networks, espar antenna, eres antenna, 3d printing.
- additive manufacturing
Social media
Contact
IT Specialist
- Department of Microwave and Antenna Engineering
- Faculty of Electronics, Telecommunications and Informatics
- Workplace
-
Budynek A Elektroniki
room EA 716 open in new tab - Phone
- +48 58 348 61 57
- kamil.trzebiatowski@pg.edu.pl
Publication showcase
-
Simple 60 GHz Switched Beam Antenna for 5G Millimeter-Wave Applications
A new 60 GHz band single-input switched beam antenna is proposed for the fifth-generation (5G) millimeter-wave network applications. The presented design is capable of electronically switching the main beam in two different directions via a proposed microstrip-line-to-slotline single-pole dual-throw (SPDT) switch based on commercially available p-i-n diodes. The antenna is fabricated in a low-cost printed circuit board process...
-
Simple 60 GHz Switched Beam Antenna for 5G Millimeter-Wave Applications
-
Multi-Beam Antenna for Ka-Band CubeSat Connectivity Using 3-D Printed Lens and Antenna Array
In this paper, the design of a passive multi-beam lens antenna is proposed for the CubeSat space communication system as an alternative application of a 2-D microstrip antenna array that has originally been designed for a 39 GHz 5 G MU-MIMO system. The half-ellipsoid lens is 3-D printed using stereolithography (SLA) technology. The antenna prototype is capable of selecting the main beam between 16 different directions with a gain...
seen 841 times