dr hab. inż. Marian Piwowarski
Employment
- Head of Section at Zakład Maszyn Przepływowych
- Associate professor at Institute of Energy
Social media
Contact
- marian.piwowarski@pg.edu.pl
Associate professor
- Workplace
-
Budynek Laborat. Masz.
room 2 open in new tab - Phone
- +48583471429
- marian.piwowarski@pg.edu.pl
Publication showcase
-
Design analysis of Tesla micro-turbine operating on a low-boiling medium
This paper presents results of the design analysis of a Tesla bladeless turbine intended for a co-generating micro-power plantof heat capacity 20 kW, which operates in an organic Rankine cycle on a low-boiling medium. Numerical calculations of flowin several Tesla turbine models were performed for a range of design parameters. Results of investigations exhibit interestingfeatures in the distribution of flow parameters within the...
-
Thermodynamic Cycle Concepts for High-Efficiency Power Plants. Part B: Prosumer and Distributed Power Industry
An analysis was carried out for different thermodynamic cycles of power plants with air turbines. A new modification of a gas turbine cycle with the combustion chamber at the turbine outlet has been described in the paper. A special air by-pass system of the combustor was applied, and in this way, the efficiency of the turbine cycle was increased by a few points. The proposed cycle equipped with an effective heat exchanger could...
-
Gas Turbine Cycle with External Combustion Chamber for Prosumer and Distributed Energy Systems
The use of various biofuels, usually of relatively small Lower Heating Value (LHV), affects the gas turbine efficiency. The present paper shows that applying the proposed air by-pass system of the combustor at the turbine exit causes tan increase of efficiency of the turbine cycle increased by a few points. This solution appears very promising also in combined gas/steam turbine power plants. The comparison of a turbine set operating...
Obtained scientific degrees/titles
-
2014-12-04
Obtained science degree
dr hab. inż. Mechanical engineering (Technology)Instytut MAszyn Przepływowych Polskiej Akademi Nauk w Gdańsku -
2002-06-25
Obtained science degree
dr inż. Mechanical engineering (Technology)
seen 3216 times