Search
Abstract
This paper presents an experimental study of heat pipes supported by phase change materials (PCMs) coated at their adiabatic sections in application for electronics cooling. The PCMs investigated in this research were palmitic acid and beeswax, the latter being considered as a more cost-effective alternative. The study focused on three powers: 20W, 25W, and 30W. The experimental results revealed that the incorporation of palmitic acid as a PCM led to a reduction in component’s maximum temperature by 13.3%, 12.6%, and 11.8% for the respective powers. Utilization of beeswax resulted in temperature reductions of 5%, 5.2%, and 8.4%. Notably, for higher heat flux conditions, the influence of beeswax on temperature control was comparable to that of palmitic acid. Furthermore, beeswax demonstrated a significantly higher capability to mitigate temperature decrease during cooldown, serving as a superior measure against overcooling. Moreover, during the thermal cycling scenario considered in this study, beeswax reduced the peak-valley temperature by 25%, while palmitic acid achieved a reduction of 14.6%. These findings suggest that beeswax has the potential to serve as an alternative to traditional organic PCMs in electronics cooling applications that utilize heat pipes.
Citations
-
1
CrossRef
-
0
Web of Science
-
1
Scopus
Cite as
Full text
full text is not available in portal
Keywords
Details
- Category:
- Articles
- Type:
- artykuły w czasopismach
- Published in:
-
ADVANCED ENGINEERING MATERIALS
no. 26,
pages 1 - 10,
ISSN: 1438-1656 - Language:
- English
- Publication year:
- 2024
- Bibliographic description:
- Szymański P., Paluch R.: Beeswax And Palmitic Acid Utilization With Heat Pipes For Electronics Cooling// ADVANCED ENGINEERING MATERIALS -Vol. 26,iss. 6 (2024), s.1-10
- DOI:
- Digital Object Identifier (open in new tab) 10.1002/adem.202301704
- Sources of funding:
-
- Free publication
- Verified by:
- Gdańsk University of Technology
seen 108 times