Wyszukiwarka
ISSN:
eISSN:
Dyscypliny:
- inżynieria biomedyczna (Dziedzina nauk inżynieryjno-technicznych)
- inżynieria lądowa, geodezja i transport (Dziedzina nauk inżynieryjno-technicznych)
- inżynieria materiałowa (Dziedzina nauk inżynieryjno-technicznych)
- inżynieria mechaniczna (Dziedzina nauk inżynieryjno-technicznych)
- biologia medyczna (Dziedzina nauk medycznych i nauk o zdrowiu)
- nauki farmaceutyczne (Dziedzina nauk medycznych i nauk o zdrowiu)
- nauki leśne (Dziedzina nauk rolniczych)
- technologia żywności i żywienia (Dziedzina nauk rolniczych)
- biotechnologia (Dziedzina nauk ścisłych i przyrodniczych)
- nauki chemiczne (Dziedzina nauk ścisłych i przyrodniczych)
Punkty Ministerialne: Pomoc
| Rok | Punkty | Lista |
|---|---|---|
| Rok 2024 | 100 | Ministerialna lista czasopism punktowanych 2024 |
| Rok | Punkty | Lista |
|---|---|---|
| 2024 | 100 | Ministerialna lista czasopism punktowanych 2024 |
| 2023 | 100 | Lista ministerialna czasopism punktowanych 2023 |
| 2022 | 100 | Lista ministerialna czasopism punktowanych (2019-2022) |
| 2021 | 100 | Lista ministerialna czasopism punktowanych (2019-2022) |
| 2020 | 100 | Lista ministerialna czasopism punktowanych (2019-2022) |
| 2019 | 100 | Lista ministerialna czasopism punktowanych (2019-2022) |
| 2018 | 30 | A |
| 2017 | 30 | A |
| 2016 | 30 | A |
| 2015 | 30 | A |
| 2014 | 30 | A |
| 2013 | 30 | A |
| 2012 | 30 | A |
| 2011 | 30 | A |
| 2010 | 27 | A |
Model czasopisma:
Punkty CiteScore:
| Rok | Punkty |
|---|---|
| Rok 2022 | 7.7 |
| Rok | Punkty |
|---|---|
| 2022 | 7.7 |
| 2021 | 7.4 |
| 2020 | 6.7 |
| 2019 | 6.2 |
| 2018 | 4.9 |
| 2017 | 4.6 |
| 2016 | 4.6 |
| 2015 | 4.7 |
| 2014 | 4.3 |
| 2013 | 3.9 |
| 2012 | 3.5 |
| 2011 | 3.2 |
Impact Factor:
Sherpa Romeo:
Prace opublikowane w tym czasopiśmie
Filtry
wszystkich: 19
Katalog Czasopism
Rok 2023
-
Increasing the conductivity of V2O5 -TeO2 glass by crystallization: structure and charge transfer studies
PublikacjaIn the present paper, V2O5-TeO2 glass...
-
Increasing the conductivity of V2O5-TeO2 glass by crystallization: structure and charge transfer studies
PublikacjaIn the present paper, V 2 O 5 -TeO 2 glass was prepared by the melt-quenching technique. Crystallization of glass with a vanadium content higher than 35%mol results in an increase in electrical conductivity by a few orders of magnitude and a decrease in activation energy from ~0.40 to ~0.12 eV. In this work, a critical review of existing charge transfer models was presented on the example of V 2 O 5 -TeO 2 glass and glass–ceramics....
-
Ionic thermoelectric effect in Cu2-δSe during phase transition
PublikacjaThe ionic Seebeck coefficient was studied in copper selenide with Cu1.99Se, Cu1.95Se and Cu1.8Se stoichiometry which was synthesized with a melt crystallization method. To measure the ionic Seebeck coefficient of copper ions, 0.15C6H12N4CH3I + 0.85CuI solid-state electrolyte was prepared. Electrolyte layers were pressed with copper selenide powder into a sandwich-like structure. At the temperature of 410 K, the materials have ionic...
Rok 2022
-
Electrocatalytic oxidation of methanol, ethylene glycol and glycerine in alkaline media on TiO2 nanotubes decorated with AuCu nanoparticles for an application in fuel cells
PublikacjaIn this work, we present the catalytic and photocatalytic activity of AuCu nanostructures obtained on TiO2 nanotubes toward methanol, ethylene glycol and glycerine oxidation. The electrode material is prepared by anodization of Ti foil, thin AuCu layer sputtering and rapid thermal treatment under argon atmosphere. Scanning electron microscopy images confirmed the presence of ordered tubular architecture of TiO2 as well as nanoparticles...
-
Mechanism of hopping conduction in Be–Fe–Al–Te–O semiconducting glasses and glass–ceramics
PublikacjaElectrical properties of beryllium-alumino-tellurite glasses and glass–ceramics doped with iron ions were studied using impedance spectroscopy. The conductivity was measured over a wide frequency range from 10 mHz to 1 MHz and the temperature range from 213 to 473 K. The D.C. conductivity values showed a correlation with the Fe-ion concentration and ratio of iron ions on different valence states in the samples. On the basis of...
-
Optimization of biocorrosion resistance and mechanical properties of PM Ti–XAl–2Fe–3Cu alloys by response surface methodology
PublikacjaIn the current study, the biocorrosion resistance and mechanical properties of the Ti–XAl–2Fe–3Cu (wt%) (X = 6, 4, 2 wt%) alloy produced by powder compact extrusion of blended elemental powders were optimized by using the response surface methodology in order to gain the best combination of processing parameters. To run the optimization process, central composite design with three equal levels of oxygen, hydrogen and aluminum was...
Rok 2021
-
Structure, thermal and mechanical properties of copoly(ester amide)s based on 2,5‐furandicarboxylic acid
Publikacja -
The unstable thermoelectric effect in non-stoichiometric Cu2Se during the non-equilibrium phase transition
PublikacjaThe superionic α ↔ β phase transition in Cu1.96Se thermoelectric material is investigated by means of thermal analysis (DSC) and measurements of Seebeck coefficient and electrical conductivity. Results of the DSC measurements with 1–10 K/min heating and cooling rates show that the material is close to the equilibrium phase composition during the transformation. However, the kinetic limitation of the process exists, which is indicated...
-
Two-step synthesis of niobium doped Na–Ca–(Mg)–P–Si–O glasses
PublikacjaNiobium doped biosolubility glasses in the Na–Ca–(Mg)–P–Si–O system were prepared by using an untypical two-step synthesis route. The parent glass was melted in air atmosphere at 1350 °C followed by re-melting the glass in Nb crucible with the addition of metallic Mg/Ca powder in the nitrogen atmosphere. The second melting step was carried out at 1450–1650 °C, using an induction furnace. The topography and structure of the obtained...
Rok 2020
-
New synthesis route of highly porous InxCo4Sb12 with strongly reduced thermal conductivity
PublikacjaHighly porous, In-filled CoSb3 skutterudite materials with an attractive thermoelectric figure of merit (ZT * 1) and corresponding dense samples were fabricated through the cost-effective method of reduction in oxides in dry hydrogen and the pulsed electric current sintering (PECS) method, respectively. The reduction process was described in detail using in situ thermogravimetric analysis of Co2O3, Sb2O3 and In(NO3)35H2O separately...
Rok 2019
-
Crystal structure, chemical bonding, and physical properties of layered AIrSn2 (A = Sr and Ba)
PublikacjaWe report the experimental and theoretical investigation of structure, chemical bonding interactions, and physical properties of new ternary stannides AIrSn2 (A = Sr and Ba). AIrSn2 (A = Sr and Ba) crystallizes in the orthorhombic Re3B-type structure with the space group Cmcm (No. 64). According to single-crystal X-ray diffraction results, the structure of AIrSn2 (A = Sr and Ba) can be considered as a Zintl-type compound with heterogeneous...
-
DFT modelling of the edge dislocation in 4H-SiC
Publikacja -
Symmetrical and unsymmetrical azomethines with thiophene core: structure–properties investigations
Publikacja
Rok 2017
-
Charge-based deep level transient spectroscopy of B-doped and undoped polycrystalline diamond films
PublikacjaThe undoped and B-doped polycrystalline diamond thin film was synthesized by hot filament chemical vapor deposition and microwave plasma, respectively. The structural characterization was performed by scanning electron microscopy, X-ray diffraction and Raman spectroscopy. The electrical properties of synthesized diamond layer were characterized by dc-conductivity method and charge deep level transient spectroscopy. The B-doped...
-
Oxygen release from BaLnMn2O6 (Ln: Pr, Nd, Y) under reducing conditions as studied by neutron diffraction
Publikacja
Rok 2014
Rok 2012
Rok 2008
Rok 2003
-
The effect of low energy impact on the tensile strength of coated and uncoated glass particulate composites.
PublikacjaPrzedstawiono model teoretyczny pozwalający przewidywać poudarową wytrzymałość na rozciąganie w funkcji parametrów materiałowych i budowy kompozytu. Określono eksperymentalnie poudarową wytrzymałość na ściskanie kompozytów zbrojonych ciągłym włóknem szklanym w osnowie żywicy epoksydowej napełnianej mikrokulkami szklanymi w celu obniżenia skłonności do powstawania dużych zniszczeń przy udarze o niskiej energii. Wyniki eksperymentalnie...
wyświetlono 1996 razy