Analysis of Roughness, the Material Removal Rate, and the Acoustic Emission Signal Obtained in Flat Grinding Processes - Publikacja - MOST Wiedzy

Twoje konto

zaloguj

Wyszukiwarka

Analysis of Roughness, the Material Removal Rate, and the Acoustic Emission Signal Obtained in Flat Grinding Processes

Abstrakt

In this work, the analysis of the acoustic emission (AE) signal in grinding processes is addressed. The proposed analysis method decomposes the acoustic signal into three frequency ranges. The total energy of each range is determined, as well as the highest frequency. Different grinding experiments were carried out, according to a full factorial design of experiments (DOE), in which feed speed, depth of cut, and transversal step (table cross feed) were varied. Arithmetic average roughness Ra and the material removal rate (MRR) were determined. It was observed that Ra depends mainly on the transversal step, followed by feed speed and the interaction between the transversal step and depth of cut, while MRR is greatly influenced by the transversal step. According to multi-objective optimization with the Derringer–Suich function, in order to simultaneously minimize Ra and maximize MRR, a transversal step of 9 mm per longitudinal pass, feed speed of 20 m/min, and depth of cut of 0.020 mm should be selected.

Cytowania

  • 1

    CrossRef

  • 0

    Web of Science

  • 1

    Scopus

Autorzy (3)

Cytuj jako

Pełna treść

pobierz publikację
pobrano 59 razy
Wersja publikacji
Accepted albo Published Version
DOI:
Cyfrowy identyfikator dokumentu elektronicznego (otwiera się w nowej karcie) 10.3390/machines12020110
Licencja
Creative Commons: CC-BY otwiera się w nowej karcie

Słowa kluczowe

Informacje szczegółowe

Kategoria:
Publikacja w czasopiśmie
Typ:
artykuły w czasopismach
Opublikowano w:
Machines nr 12,
ISSN: 2075-1702
Język:
angielski
Rok wydania:
2024
Opis bibliograficzny:
Sender P., Buj - Corral I., Álvarez-Flórez J.: Analysis of Roughness, the Material Removal Rate, and the Acoustic Emission Signal Obtained in Flat Grinding Processes// Machines -Vol. 12,iss. 2 (2024), s.110-
DOI:
Cyfrowy identyfikator dokumentu elektronicznego (otwiera się w nowej karcie) 10.3390/machines12020110
Źródła finansowania:
  • IDUB
Weryfikacja:
Politechnika Gdańska

wyświetlono 111 razy

Publikacje, które mogą cię zainteresować

Method of Monitoring of the Grinding Process with Lapping Kinematics Using Audible Sound Analysis

2022

The Impact of Material Selection on Durability of Exhaust Valve Faces of a Ship Engine – A Case Study

2020

The Influence of the Depth of Cut in Single-Pass Grinding on the Microstructure and Properties of the C45 Steel Surface Layer

2020

Influence of Flat Lapping Kinematics on Machinability of Ceramics

2013
Meta Tagi