Diagnostyka - Czasopismo - MOST Wiedzy

Wyszukiwarka

Diagnostyka

ISSN:

1641-6414

eISSN:

2449-5220

Wydawca:

Polskie Towarzystwo Diagnostyki Technicznej

Dyscypliny:

  • Automatyka, elektronika, elektrotechnika i technologie kosmiczne (Dziedzina nauk inżynieryjno-technicznych)
  • Informatyka techniczna i telekomunikacja (Dziedzina nauk inżynieryjno-technicznych)
  • Inżynieria biomedyczna (Dziedzina nauk inżynieryjno-technicznych)
  • Inżynieria lądowa, geodezja i transport (Dziedzina nauk inżynieryjno-technicznych)
  • Inżynieria materiałowa (Dziedzina nauk inżynieryjno-technicznych)
  • Inżynieria mechaniczna (Dziedzina nauk inżynieryjno-technicznych)

Punkty Ministerialne: Pomoc

Punkty Ministerialne - aktualny rok
Rok Punkty Lista
Rok 2024 40 Ministerialna lista czasopism punktowanych 2024
Punkty Ministerialne - lata ubiegłe
Rok Punkty Lista
2024 40 Ministerialna lista czasopism punktowanych 2024
2023 70 Lista ministerialna czasopism punktowanych 2023
2022 40 Lista ministerialna czasopism punktowanych (2019-2022)
2021 40 Lista ministerialna czasopism punktowanych (2019-2022)
2020 40 Lista ministerialna czasopism punktowanych (2019-2022)
2019 40 Lista ministerialna czasopism punktowanych (2019-2022)
2018 11 B
2017 11 B
2016 11 B
2015 11 B
2014 7 B
2013 7 B
2012 5 B
2011 5 B
2010 6 B

Model czasopisma:

Open Access

Punkty CiteScore:

Punkty CiteScore - aktualny rok
Rok Punkty
Rok 2022 2.1
Punkty CiteScore - lata ubiegłe
Rok Punkty
2022 2.1
2021 1.7
2020 1.6
2019 1.6
2018 1.3
2017 1.5

Impact Factor:

brak danych

Polityka wydawnicza:

Licencja: CC BY 4.0
Licencja
Creative Commons: BY 4.0 otwiera się w nowej karcie
Informacja o polityce wydawniczej
http://www.diagnostyka.net.pl/Open-Access,845.html otwiera się w nowej karcie
Informacja o warunkach samoarchiwizacji
Zawarta w licencji
Czy czasopismo pozwala na samoarchiwizację
Tak - bez ograniczeń
Submitted Version Pomoc
tak
Accepted Version Pomoc
tak
Published Version Pomoc
tak
Informacje o polityce dot. danych badawczych
brak danych
Embargo w miesiącach
brak embargo
Informacje dodatkowe
Przy udostępnianiu/rozpowszechnianiu należy podać źródło oryginału i DOI.

Filtry

wszystkich: 42

  • Kategoria
  • Rok
  • Opcje

wyczyść Filtry wybranego katalogu niedostępne

Katalog Czasopism

Rok 2020
Rok 2019
  • Modeling of the process of selected fire signaling systems
    Publikacja

    - Diagnostyka - Rok 2019

    Pełny tekst do pobrania w serwisie zewnętrznym

  • Numerical investigation of the core eccentricity effect on wave propagation in embedded waveguide
    Publikacja

    The paper presents results of theoretical and numerical investigation of guided wave propagation in two-layer bars with geometric imperfections in the form of eccentric location of steel core. Steel rod of diameter equal to 1 cm embedded in composite mortar-type cover with external diameter equal to 5 cm has been taken into consideration. Several different rods with variable size of eccentricity are analysed. Results for rods with...

    Pełny tekst do pobrania w portalu

  • RMS-based damage detection in reinforced concrete beams: numerical simulations
    Publikacja

    Image-based damage detection methods using guided waves are well known and widely applied approaches in structural diagnostics. They are usually utilized in detection of surface damages or defects of plate-like structures. The article presents results of the study of applicability of imaging wave-based methods in detection in miniscule internal damage in the form of debonding. The investigations were carried out on numerical models...

    Pełny tekst do pobrania w portalu

  • The study of Arduino Uno feasibility for DAQ purposes
    Publikacja

    - Diagnostyka - Rok 2019

    Using microcontroller systems becomes a routine in various measurement and control tasks. Their wide availability together with a huge potential of extending their functionality by additional modules allows developing advanced measuring and monitoring systems by non-specialists. However, using popular example codes often leads the user to pass over or not to be aware of the limitations of the system and drawing too far-reaching...

    Pełny tekst do pobrania w portalu

Rok 2018
Rok 2017
  • Analysis of guided wave propagation in adhesive joints of steel rods
    Publikacja

    The aim of the study is the elastic wave propagation in adhesive joints of metal rods that are one of the simplest kind of glue connections. They are consisted of two metal members and an adhesive layer joining two parts together. The analysis is directed to technical diagnostics of such type of connections. Longitudinal and transversal guided waves were excited in prepared joints. Signals of propagating waves were registered in...

    Pełny tekst do pobrania w portalu

  • Elastic wave propapagation in diagnostics of self-drilling system of grouted anchors
    Publikacja

    The paper presents an experimental investigation of elastic wave propagation in a self-drilling hollow bar system, which is commonly used in geotechnical industry as the element of grouted ground anchors and soil nails. The single self-drilling hollow bar and self-drilling system of two bars connected by a coupler were considered. Longitudinal waves were excited at one end of the bar and registered at both ends, by means of PZT...

    Pełny tekst do pobrania w portalu

  • SIMPLY AND LOW COAST ELECTROMYOGRAPHY SIGNAL AMPLIFIER
    Publikacja

    - Diagnostyka - Rok 2017

    Recently, there has been a noticeable increase in interest in solu tions utilizing electrical signals accompanying muscle activity. Electromyography (EMG) is a technique for recording, analysis and evaluating the electrical activity produced by striated muscle. Its great popularity is due, among other, to the ability to measure with non-invasive electrodes (calle d as sEMG surface electromyography)....

    Pełny tekst do pobrania w portalu

Rok 2016
  • DETECTION OF DEBONDING IN STEEL BARS EMBEDDED IN CONCRETE USING GUIDED WAVE PROPAGATION
    Publikacja

    The paper presents a non-destructive diagnostic technique based on guided wave propagation phenomenon used to assess the adhesive bonding between a steel bar and a concrete cover. Double-layered cylindrical specimens with different levels of debonding and its location were investigated. The influence of bonding length on the excitation of multiple modes of longitudinal guided waves was analysed. Numerical simulations of guided...

    Pełny tekst do pobrania w portalu

  • Numerical modeling of GPR field in damage detection of a reinforced concrete footbridge
    Publikacja

    The paper presents a study on the use of the ground penetrating radar (GPR) method in diagnostics of a footbridge. It contains experimental investigations and numerical analyses of the electromagnetic field propagation using the finite difference time domain method (FDTD). The object of research was a reinforced concrete footbridge over a railway line. The calculations of the GPR field propagation were performed on a selected cross-section...

    Pełny tekst do pobrania w portalu

Rok 2015
  • Application of gpr method in diagnostics of reinforced concrete structures
    Publikacja

    This paper presents an application of the ground penetration method (GPR) for diagnostics of reinforced concrete structures. In situ measurements were conducted for three civil engineering structures: the ground floor structure, the abutment of the railway viaduct and the concrete well. The dual polarized ground penetrating radar with the antenna operating at a center frequency of 2 GHz was used for GPR surveys. Three different...

    Pełny tekst do pobrania w portalu

  • Application of wavelet transform in analysis of guided wave propagation signals for damage detection in a steel plate
    Publikacja

    The paper presents results of experimental investigations on damage detection using guided wave propagation technique. The tested specimen was a steel plate with a defect in the form of a rectangular notch. Lamb waves were excited by a PZT actuator and sensed by a laser vibrometer. Since reflections from damage in registered signals are often masked by measurement noise, for identification of time of reflections from damage, continuous...

    Pełny tekst do pobrania w portalu

  • Identification of dynamic parameters in the context of diagnostics of steel tank with different level of liquid.
    Publikacja

    The paper presents an experimental study to identify the dynamic parameters of a water-filled tank model. The experimental modal analysis approach involving the excitation at one point of the structure and acquisition of vibra tions at selected points distri buted over the tank surface allowed to determine the resonance frequencies, mode shapes and damping ratios. The main aim of the research was to examine the influence of...

    Pełny tekst do pobrania w portalu

  • Problems in estimation of hand grip force based on EMG signal
    Publikacja

    - Diagnostyka - Rok 2015

    There has recently been a significant increase in the number of publications on and applications of bioelectric signals for diagnostic purposes. While the use of ECG (electrocardiography) is not surprising, the use of signals from registration of brain activity (EEG) and muscles activity (EMG) still finds new applications in various fields. The authors focus on the use of EMG signals for estimating hand grip force. Currently,...

    Pełny tekst do pobrania w portalu

Rok 2014
  • Diagnostics of bolted lap joint using guided wave propagation
    Publikacja

    The paper presents numerical and experimental analyses of elastic waves propagation in a bolted lap joint. In experimental investigations condition assessment of the joint was performed with the use of symmetric waves excited by a piezoactuator. Numerical calculations were conducted in commercial finite element method software Abaqus. The influence of number of bolts and the value of the initial stress on recorded signals was examined....

    Pełny tekst do pobrania w portalu

Rok 2013
  • Dynamic state assessment of the water turbine with the power of 600 kW
    Publikacja

    - Diagnostyka - Rok 2013

    The article discusses the results of experimental studies to assess the dynamic state of the turbine set with the Kaplan turbine. The dynamic assessment was made on the basis of appropriate standards, based on the measurement results of selected parameters of vibration, which have been measured for several states of the machine load. In addition, we attempted to identify the causes of the increased vibration levels based on the...

    Pełny tekst do pobrania w portalu

  • DYNWIR S-70 program for modal analysis of multisupported and multimass rotors
    Publikacja

    - Diagnostyka - Rok 2013

    The article provides a brief description of the program Dynwir-S-70 (currently being developed in the Rotor Dynamics and Slide Bearings Department in the Institute of Fluid-Flow Machinery Polish Academy of Sciences in Gdansk) which is a program for analysis of multi-supported and multi-mass rotors. Used algorithms and the construction of mass and stiffness matrix were presented. Damping matrix structure based on Rayleigh damping...

    Pełny tekst do pobrania w portalu

  • Hybrid model of geared rotor system
    Publikacja

    In the paper a hybrid model of a geared multirotor system has been developed. The model is obtained by application of both the modal decomposition methodology and the spatial discretization method. Reduced modal model was constructed for the system without gyroscopic and damping effects. The gyroscopic interaction, damping and other phenomena which are difficult to include in the modal approach were modeled by application of simply...

    Pełny tekst do pobrania w portalu

  • SELECTION OF DIAGNOSTIC FUNCTIONS IN A WHEELED TRACTOR
    Publikacja

    - Diagnostyka - Rok 2013

    In a classical approach to damage diagnosis, the technical condition of an analyzed machine is identified based on the measured symptoms, such as performance, thermal state or vibration parameters. In wheeled tractor the fundamental importance has monitoring and diagnostics during exploitation concerning technical inspection and fault element localizations. The main functions of a diagnostic system are: monitoring tractor components...

    Pełny tekst do pobrania w portalu

  • SIMPLIFIED DYNAMIC MODEL OF ROTATING BEAM
    Publikacja

    In the paper a hybrid model of rotating beam is presented. It was obtained by using two methods: modal decomposition and spatial discretization. Reduced modal model was built for the system without the load related to inertia forces that occur during beam rotation. This inertia load was next modeled by using the method of simply spatial discretization and combined with reduced modal model. This approach allows to obtain accurate...

    Pełny tekst do pobrania w portalu

  • STRUCTURE AND ALGORITHMS OF A DIAGNOSTIC DEVICE IN A WHEELED TRACTOR
    Publikacja

    - Diagnostyka - Rok 2013

    Diagnostic device monitors the tractor’s technical condition and identifies the location of damaged components during operation. The diagnostic device detects and identifies the following types of defects: functional defects (uf) which affect performance, exhaust defects (ue) which increase toxic emissions and fuel consumption, defects that jeopardize driving safety (us), defects that affect engine performance (ud). The key component...

    Pełny tekst do pobrania w portalu

  • Topological model of aptitude of the measurement circuits of main subassemblies of an internal combustion engine crankshaft-piston assembly
    Publikacja

    - Diagnostyka - Rok 2013

    The paper presents a topological model allowing to determine the probability of aptitude of the diagnosing system (SDG) individual measuring circuits and also to determine to what degree they influence the assessment of the technical condition of an arbitrary main subassembly of crankshaft-piston assemblies as a diagnosed system (SDN).

    Pełny tekst do pobrania w portalu

Rok 2010
Rok 2008
Rok 2006
Rok 2003
  • VI Krajowa Konferencja Naukowo - Techniczna Diagnostyka Procesów Przemysłowych DPP´2003.
    Publikacja

    - Diagnostyka - Rok 2003

    W dniach 15-17 września 2003 roku odbyła się we Władysławowie Konferencja Naukowo Techniczna DPP´2003. Ma ona już 10 letnią tradycję. Konferencja jest organizowana cyklicznie począwszy od 1996 roku przez trzy ośrodki akademickie Politechnikę Gdańską, Politechnikę Warszawską oaz Uniwersytet Zielonogórski. Patronat nad Konferencją objęła PAN, Komitet Automatyki i Robotyki oraz Towarzystwo Konsultantów Polskich. Tegoroczna edycja...

    Pełny tekst do pobrania w portalu

Rok 2002

wyświetlono 1017 razy