ISSN:
eISSN:
Dyscypliny:
- inżynieria biomedyczna (Dziedzina nauk inżynieryjno-technicznych)
- inżynieria chemiczna (Dziedzina nauk inżynieryjno-technicznych)
- inżynieria materiałowa (Dziedzina nauk inżynieryjno-technicznych)
- biologia medyczna (Dziedzina nauk medycznych i nauk o zdrowiu)
- nauki farmaceutyczne (Dziedzina nauk medycznych i nauk o zdrowiu)
- biotechnologia (Dziedzina nauk ścisłych i przyrodniczych)
- nauki chemiczne (Dziedzina nauk ścisłych i przyrodniczych)
- nauki fizyczne (Dziedzina nauk ścisłych i przyrodniczych)
Punkty Ministerialne: Pomoc
Rok | Punkty | Lista |
---|---|---|
Rok 2024 | 70 | Ministerialna lista czasopism punktowanych 2024 |
Rok | Punkty | Lista |
---|---|---|
2024 | 70 | Ministerialna lista czasopism punktowanych 2024 |
2023 | 70 | Lista ministerialna czasopism punktowanych 2023 |
2022 | 70 | Lista ministerialna czasopism punktowanych (2019-2022) |
2021 | 70 | Lista ministerialna czasopism punktowanych (2019-2022) |
2020 | 70 | Lista ministerialna czasopism punktowanych (2019-2022) |
2019 | 70 | Lista ministerialna czasopism punktowanych (2019-2022) |
2018 | 35 | A |
2017 | 35 | A |
2016 | 30 | A |
2015 | 35 | A |
2014 | 35 | A |
2013 | 35 | A |
2012 | 35 | A |
2011 | 35 | A |
2010 | 32 | A |
Model czasopisma:
Punkty CiteScore:
Rok | Punkty |
---|---|
Rok 2023 | 8.7 |
Rok | Punkty |
---|---|
2023 | 8.7 |
2022 | 7.7 |
2021 | 7 |
2020 | 5.6 |
2019 | 4.9 |
2018 | 4.2 |
2017 | 3.9 |
2016 | 3.7 |
2015 | 4.1 |
2014 | 4.4 |
2013 | 3.9 |
2012 | 3.8 |
2011 | 3.8 |
Impact Factor:
Sherpa Romeo:
Prace opublikowane w tym czasopiśmie
Filtry
wszystkich: 20
Katalog Czasopism
Rok 2025
-
Investigation of structural, thermal, and electrical properties of sodium-doped oxynitride glass-ceramics
PublikacjaThis study aimed to investigate the influence of Na2O addition on the structural, thermal, and electrical characteristics of oxynitride glass-ceramics within the Na–K–Mg–Ca–Al–Si–O–N system. Oxynitride glass-ceramic samples were prepared via spark plasma sintering (SPS) with sodium oxide doping levels ranging from 0 wt% to 12 wt%. FESEM analysis revealed changes in sample morphology with increasing sodium content, indicating the...
-
The influence of chitosan's molecular weight, concentration, and dissolution method on the properties of electrophoretically deposited coatings on the Ti13Nb13Zr alloy surface
PublikacjaIn this study, the effects of molecular weight (high, medium, and low), concentration (0.1 and 0.5 %) and dissolution method (in a rarely used hydroxyacetic acid and utilizing a novel CO2 saturation) of chitosan on the microstructure, chemical composition, wettability, surface roughness, adhesion, corrosion resistance and antibacterial activity of chitosan coatings electrophoretically deposited (10 V, 1 min) on β titanium alloy...
Rok 2024
-
Research of chitosan coatings deposited by electrophoretic deposition method at various voltage and time parameters
PublikacjaThe aim of this research is to estimate the electrophoretic deposition main parameters, such as voltage and time duration, that will provide optimal characteristics of the surface layer. Chitosan coatings were synthesized on biomedical Ti13Zr13Nb alloys at 20 V and 30 V and with deposit times of 2min, 5 min, 10 min, and 15 min. Evaluation of the coating was performed by using Scanning Electron Microscope (SEM), Energy-Dispersive...
Rok 2023
-
The effect of PEDOT morphology on hexavalent chromium reduction over 2D TiO2/PEDOT photocatalyst under UV–vis light
PublikacjaThe present study represents an approach to apply organic-inorganic hybrid materials for photocatalytic removal of heavy metals from the aqueous environment. The photocatalytic activity of the semiconductor modified with the conjugated polymer may depends on the conjugated polymer type, its amount and morphology. Therefore, in the present study the effect of poly (3, 4-ethylenedioxythiophene) (PEDOT) morphology on adsorption and photoreduction...
Rok 2021
-
A comparison of tribological properties of nanolubricants containing carbon nanotori and additional additives
Publikacja -
Cationic distribution of nickel doped NixCoX-1Fe2O4 nanparticles prepared by hydrothermal approach: Effect of doping on dielectric properties
Publikacja
Rok 2020
-
Impact of chitosan/noble metals-based coatings on the plasmochemically activated surface of NiTi alloy
Publikacja -
The effect of morphology and crystalline structure of Mo/MoO3 layers on photocatalytic degradation of water organic pollutants
PublikacjaMolybdenum oxide layers were formed by anodization of the Mo metallic foil in a water/ethylene glycol-based electrolyte containing fluoride ions. The as-prepared, amorphous samples were annealed in air at different temperatures in a range from 100 �C to 700 �C. The crystal phase and morphology of anodized and annealed MoO3 layers were investigated using X-ray diffraction, Raman spectroscopy, and scanning electron microscopy. The...
Rok 2019
-
High-temperature oxidation of the Crofer 22 H ferritic steel with Mn1.45Co1.45Fe0.1O4 and Mn1.5Co1.5O4 spinel coatings under thermal cycling conditions and its properties
PublikacjaThe aim of the presented study was to deposit protective-conducting Mn1.45Co1.45Fe0.1O4 and Mn1.5Co1.5O4 spinel coatings on the Crofer 22 H ferritic steel by means of electrophoresis and to evaluate their physicochemical properties after high-temperature oxidation under thermal cycling conditions. When the Crofer 22 H steel – whether uncoated or coated with the two spinels – was oxidized in 48-h cycles involving a temperature of...
Rok 2018
-
Fabrication, structural and electrical properties of Sr(V,Nb)O 3-δ perovskite materials
PublikacjaThe SrV1-xNbxO3-δ materials with different niobium content in perovskite B-sublattice were prepared by a solid-state reaction process. The microstructure and phase compositions of obtained samples were analyzed by the X-ray diffraction technique (XRD) and scanning electron microscopy (SEM). The electrical conductivity of samples was measured by a DC 4-wire method in range of 100–600 °C in different gas conditions. The oxidation...
-
Laser operated nonlinear optical studies of BiFe0,9Cr0,1O3 and BiFe0,9Al0,1O3 multiferroics
Publikacja -
Polyrhodanine cobalt ferrite (PRHD@CoFe2O4) hybrid nanomaterials - Synthesis, structural, magnetic, cytotoxic and antibacterial properties
Publikacja
Rok 2017
-
Lyotropic liquid crystal based on zinc oxide nanoparticles obtained by microwave solvothermal synthesis
Publikacja -
Novel inorganic xerogels doped with CaWO 4 :xDy: Synthesis, characterization and luminescence properties
PublikacjaA series of novel phosphors based on silica xerogel doped with CaWO4:xDy(III) with various concentration of dysprosium ion was synthesized over a temperature of 800 C. The thermal analysis, XRD measurement and spectroscopic investigations of these materials are presented in this study. Steady state luminescence, luminescence excitation spectra as well as emission spectra have been measured. Under the ultraviolet light, the prepared...
-
The influence of ammonia and selcted amines on the characteristics of calcium carbonate precipitated from calcium chloride solutions via carbonation
PublikacjaThe precipitation of calcium carbonate was carried out by passing a gasous mixture of carbon dioxide and air into a calcium chloride solution. The selected compounds enhancing carbon dioxide absorption were used as additives which promote the formation of carbonate ions in the solution. The additives were ammonia, monoethanolamine, triethylamine and triethanolamine. The resulting calcium carbonate particles varied in polymorphic...
Rok 2016
-
Thermoelectric properties of bismuth-antimony-telluride alloys obtained by reduction of oxide reagents
PublikacjaThe BieSbeTe alloys with different Bi/Sb/Te ratio were fabricated by an innovative method. For that purpose the oxide reagents were melted at high temperature, then quenched to form pellets, milled to a powder and finally reduced in hydrogen at various temperatures. Complex structures consisting of connected thin layers forming a continuous path between nano- and micrometer size grains have been obtained. The electrical conductivity,...
Rok 2015
-
Thermostability and photophysical properties of mixed-ligand carboxylate/benzimidazole Zn(II)-coordination polymers
PublikacjaThe reaction between Zn(NO3)2*6H2O or Zn(CH3COO)2*2H2O and isophthalic acid (1,3-H2bdc) in the presence of benzimidazole (Hbzim) in dimethylformamide (DMF)/ethanol (EtOH)/H2O solvent mixture at room temperature yielded two structurally different coordination polymers: [Zn2(1,3-bdc)2(Hbzim)2] (1) and [Zn2(1,3-bdc)(bzim)2] (2). (1) is a 2D-layered framework with a molecule of benzimidazole coordinated to the Zn center, whereas (2)...
Rok 2014
-
Benzene-induced hydro(solvo)thermal synthesis of Cu2+ and Zn2+ coordination polymers based on 1,3-benzenedicarboxylate
PublikacjaHydro(solvo)thermal reactions of Cu(NO3)2·2.5H2O or Zn(NO3)2·6H2O with 1,3-H2bdc provided two structurally different coordination polymers; a 2D network “metallacalixarene” based on the paddlewheel-type cluster with the formula [Cu(1,3-bdc)·H2O]·H2O (1) and a 3D framework [Zn(1,3-bdc)] (2), respectively. The use of a base was unnecessary in this synthesis; however, the presence of benzene played a crucial role in the crystallization...
Rok 2013
Rok 2001
wyświetlono 2233 razy