Abstrakt
When bonded joint is subjected to mode I fracture loading, the adhesive joints analytical solutions treats the adhesive layer, usually, as not existing or 1D Hooke elastic layer. In the case of 1D elastic layer, represented as Hookes spring element, is acting, only, in direction contrary to the applied load. Basing on the information yielded from sensitive laser profilometry technique, where deflections of bonded part of the joint were measured, within this contribution, 2D Finite Element Method model is introduced. The FEM allows adhesive layer to be simulated as two perpendicular-acting Hook's springs, thus in-plane shear compliance is enabled. Subsequently, appropriate analysis were carried out. Results, in terms of plate deflection, were compared with laser profilometry technique and common analytical solutions. It is concluded that linear 1D model is not sufficient for the asymmetric bonded joint configuration since the adhesive resists actively also in the in-plane shearing direction. Omitting shearing compliance effect can lead to valuable misinterpretation of the fracture energy, up to 20% in cases studied, and thus, cannot be ignored. Finally, power law based, correction factors are given promising fast and reliable data correction.
Autorzy (3)
Cytuj jako
Pełna treść
- Wersja publikacji
- Accepted albo Published Version
- DOI:
- Cyfrowy identyfikator dokumentu elektronicznego (otwiera się w nowej karcie) 10.2478/v10077-010-0008-y
- Licencja
- otwiera się w nowej karcie
Słowa kluczowe
Informacje szczegółowe
- Kategoria:
- Publikacja w czasopiśmie
- Typ:
- artykuły w czasopismach recenzowanych i innych wydawnictwach ciągłych
- Opublikowano w:
-
Advances in Materials Science
nr 10,
strony 4 - 16,
ISSN: 1730-2439 - Język:
- angielski
- Rok wydania:
- 2010
- Opis bibliograficzny:
- Budzik M., Jumel J., Shanahan M.: Fracture Energy of Bonded Joints with 2D Elastic Adhesive Layer// Advances in Materials Science. -Vol. 10., iss. 3 (2010), s.4-16
- Źródła finansowania:
-
- Publikacja bezkosztowa
- Weryfikacja:
- Politechnika Gdańska
wyświetlono 109 razy
Publikacje, które mogą cię zainteresować
Adhesive compliance effect in mode I separation:Profilometry approach
- M. Budzik,
- J. Jumel,
- M. Shanahan
An in situ technique for the assessment of adhesive properties of a joint under load
- M. Budzik,
- J. Jumel,
- M. Shanahan
Reliable method of assessing fracture properties of asymmetric bonded joints
- J. Tysarczyk,
- M. Budzik,
- J. Jumel
- + 2 autorów
Process zone in the Single Cantilever Beam under transverse loading. - Part II: Experimental
- M. Budzik,
- J. Jumel,
- M. Shanahan