Wyszukiwarka
Predicting cutting power for band sawing process of pine and beech wood dried with the use of four different methods
Abstrakt
Wood drying is an important stage in the woodworking process. After drying, wood is subject to a re-sawing process, for which a high quality surface, low material loss, and high efficiency are often required. In this paper, forecasted values were presented of cutting power for the re-sawing process of pine and beech wood that were dried with four different methods. Forecasting of cutting power for an industrial band saw machine that works daily in a Polish sawmill was determined. Values of cutting power were forecasted for a full range of feed speeds of the analyzed band saw machine. The achieved results allowed the observation of noticeable changes in the forecasted cutting power for a given sawing process as a function of the wood drying method applied. Significant changes were observed for pine wood, especially between air-dried pine wood and wood dried with warm air-steam mixture, and between pine wood dried in a conventional kiln and with warm air-steam mixture.
Cytowania
-
5
CrossRef
-
0
Web of Science
-
1 3
Scopus
Autorzy (5)
-
Tomasz Ochrymiuk
-
Marcin Lackowski
-
Piotr Taube
Cytuj jako
Pełna treść
- Wersja publikacji
- Accepted albo Published Version
- DOI:
- Cyfrowy identyfikator dokumentu elektronicznego (otwiera się w nowej karcie) 10.15376/biores.15.1.1844-1860
- Licencja
- Copyright (2020 NC State University)
Słowa kluczowe
Informacje szczegółowe
- Kategoria:
- Publikacja w czasopiśmie
- Typ:
- artykuły w czasopismach
- Opublikowano w:
-
BIORESOURCES
nr 15,
strony 1844 - 1860,
ISSN: 1930-2126 - Język:
- angielski
- Rok wydania:
- 2020
- Opis bibliograficzny:
- Chuchała D., Ochrymiuk T., Orłowski K., Lackowski M., Taube P.: Predicting cutting power for band sawing process of pine and beech wood dried with the use of four different methods// BIORESOURCES -Vol. 15,iss. 1 (2020), s.1844-1860
- DOI:
- Cyfrowy identyfikator dokumentu elektronicznego (otwiera się w nowej karcie) 10.15376/biores.15.1.1844-1860
- Weryfikacja:
- Politechnika Gdańska
wyświetlono 121 razy
Publikacje, które mogą cię zainteresować
Influence of drying mode and feed per tooth rate on the fine dust creation in pine and beech sawing on a mini sash gang saw
- T. Rogoziński,
- D. Chuchała,
- M. Pędzik
- + 3 autorów