Experimental study of the impact of notches and holes made in the front edge of adherends on the properties of static and fatigue strength of adhesive joints

Andrzej Kubit; Wojciech Macek; Władysław Zielecki; Paulina Szawara; Piotr Myśliwiec

doi:10.1016/j.ijadhadh.2023.103596

Experimental study of the impact of notches and holes made in the front edge of adherends on the properties of static and fatigue strength of adhesive joints

Abstract

The paper presents the results of experimental studies aimed at determining the effect of holes and notches at the front edge of adherends on the strength of adhesive joints. Single-lap joints made of S235JR steel sheets joined with Araldite 2014-2 epoxy adhesive were tested. Comparative tests of static strength in the shear test as well as high-cycle fatigue strength tests were carried out. Joints with three holes with a diameter of 3 mm filled with adhesive and notches 3 mm wide and 4 mm long also filled with adhesive were tested and compared with reference joints, i.e. without modification. The assumption was that the structural changes applied were to contribute to the reduction of the peak of peel and shear stresses that typically occur in this type of joint. Based on the static strength tests, no significant effect of the applied modifications on the strength of the connections was demonstrated. However, in the case of fatigue strength, a significant improvement in fatigue lifetime was demonstrated, which in the area of low cycle fatigue increased by 328.6 % for the joint with notches and by 640.8 % for the variant with holes. For the fatigue fracture surfaces, a topography analysis was carried out by determining the roughness parameters. Significant differences were exposed since at the leading edge, the selected parameters were significantly lower for the reference variant than for variants with notches and holes.

Citations

1

CrossRef
0

Web of Science
1

Scopus

Authors (5)

Cite as

Full text

full text is not available in portal

full content of the article see on external site open in new tab

Keywords

Details

Category:

Articles

Type:

artykuły w czasopismach

Published in:

INTERNATIONAL JOURNAL OF ADHESION AND ADHESIVES no. 129,
ISSN: 0143-7496

Language:

English

Publication year:

2024

Bibliographic description:

Kubit A., Macek W., Zielecki W., Szawara P., Myśliwiec P.: Experimental study of the impact of notches and holes made in the front edge of adherends on the properties of static and fatigue strength of adhesive joints// INTERNATIONAL JOURNAL OF ADHESION AND ADHESIVES -Vol. 129, (2024), s.103596-

DOI: