Analysis of the instantaneous power signal for bearing diagnostics - bearing undamaged - Open Research Data - Bridge of Knowledge

Your account

login

Search

Analysis of the instantaneous power signal for bearing diagnostics - bearing undamaged

Description

The attached dataset contains the measurement results of the instantaneous values of current and voltage, recorded during the diagnostics of an undamaged bearing. Bearing diagnostics can be carried out based on the method, which relies on the measurement and analysis of the variability of the signal instantaneous power, defined as the product of instantaneous current and voltage power supplied to the engines.

Bearing damage causes the appearance of deformations, which are in the form of additional harmonic components of the spectrum. These components are formed as a result of waveform distortions by signals with frequencies specific for a given type of bearing damage. Relationships for determining these frequencies are known in the literature. Therefore, in the instantaneous power spectrum, there are components that can be used as a diagnostic symptom, on the basis of which it is possible to assess the technical condition of bearings in induction motors.

The method of performing diagnostic tests of bearing failures is based on the use of the product of the instantaneous current and voltage, spectral analysis of the resulting signal, and determining the frequency characteristic of the damage and identify them in the spectrum of instantaneous power. In the described method, the measurement is carried out by taking the signal, which is a measure of the current and voltage supplied to the machine.

The measuring stand used for bearing diagnostics consists of a tested engine, magnetic clutch, vibroacoustic dampers, whose task is to isolate the tested machines from the base on which the load is mounted, and a laser system for accurate shaft alignment. The laboratory stand allows measurements to be made for induction motors up to 5.0 kW.

The process of conditioning the current signal is performed using the current-voltage transducer LEM CT-5T (conversion ratio 5A/5V, and conditioning of the voltage signal is done by a voltage transducer LEM CV3-500 (conversion ratio 500V/10V). Then, both signals are fed to the measurement system, whose main component is the NI PXI 4462 data acquisition card installed in the NI PXI 1031 cassette measuring. Signals from the measurement cassette are transferred to a PC, where they are analyzed.

Machines STG80X-4C type were studied of the following parameters: Pn = 1.1 kW, Un = 400/230 V, In = 2.9/5.0 A. The measurements were performed for undamaged bearing. 6204 type of bearings were used in the tested machines.

Sample measurement results for the engine with undamaged bearing are presented. Measurements made for the rotational speed of the tested machine n = 1465 rpm, load 68% of nominal current In, sampling frequency 16384 Hz and spectrum resolution 1/32 Hz.

Dataset file

Analysis of the instantaneous power signal for bearing diagnostics bearing undamaged.xlsx
24.2 MB, S3 ETag 3b88e70c5c987bda97f1f5fe6a4bf3b9-1, downloads: 96
The file hash is calculated from the formula
hexmd5(md5(part1)+md5(part2)+...)-{parts_count} where a single part of the file is 512 MB in size.

Example script for calculation:
https://github.com/antespi/s3md5

File details

License:
Creative Commons: by-nc 4.0 open in new tab
CC BY-NC
Non-commercial

Details

Year of publication:
2020
Verification date:
2020-12-17
Creation date:
2010
Dataset language:
English
Fields of science:
  • Automation, electronic and electrical engineering (Engineering and Technology)
DOI:
DOI ID 10.34808/cwyx-br19 open in new tab
Verified by:
Gdańsk University of Technology

Keywords

References

Cite as

Authors

seen 257 times