Effect of plasma sprayed and laser re-melted Al2O3 coatings on hardness and wear properties of stainless steel - Publikacja - MOST Wiedzy

Twoje konto

zaloguj

Wyszukiwarka

Effect of plasma sprayed and laser re-melted Al2O3 coatings on hardness and wear properties of stainless steel

Abstrakt

Commercially available austenic stainless steel substrate was coated with commercially available, raw Al2O3 powder applied by means of plasma spraying method and then re-melted with CO2 laser beam of various parameters. Tribological and mechanical properties of the 120 J/mm and 160 J/mm laser re-melted coatings were compared with the tribological and mechanical properties of the “as-sprayed” coating. The influence of the laser beam of various parameters on the microstructure, phase constituents, and mechanical and tribological properties of the ceramic coating was investigated by means of scanning electron microscopy, light microscopy, computer tomography, X-ray diffraction technique and nanoindentation tests. The micro sliding wear performance of the coatings was tested using a nanoindenter. The study showed an improvement of the mechanical and tribological properties caused by the laser treatment. The best results were achieved for coating re-melted with 120 J/mm laser beam.

Cytowania

  • 4 8

    CrossRef

  • 0

    Web of Science

  • 5 0

    Scopus

Autorzy (3)

Cytuj jako

Pełna treść

pobierz publikację
pobrano 38 razy
Wersja publikacji
Accepted albo Published Version
DOI:
Cyfrowy identyfikator dokumentu elektronicznego (otwiera się w nowej karcie) 10.1016/j.ceramint.2016.04.044
Licencja
Creative Commons: CC-BY-NC-ND otwiera się w nowej karcie

Słowa kluczowe

Informacje szczegółowe

Kategoria:
Publikacja w czasopiśmie
Typ:
artykuł w czasopiśmie wyróżnionym w JCR
Opublikowano w:
CERAMICS INTERNATIONAL nr 42, wydanie 9, strony 11275 - 11284,
ISSN: 0272-8842
Język:
angielski
Rok wydania:
2016
Opis bibliograficzny:
Szkodo M., Bień A., Antoszkiewicz M.: Effect of plasma sprayed and laser re-melted Al2O3 coatings on hardness and wear properties of stainless steel// CERAMICS INTERNATIONAL. -Vol. 42, iss. 9 (2016), s.11275-11284
DOI:
Cyfrowy identyfikator dokumentu elektronicznego (otwiera się w nowej karcie) 10.1016/j.ceramint.2016.04.044
Weryfikacja:
Politechnika Gdańska

wyświetlono 145 razy

Publikacje, które mogą cię zainteresować

Mechanical Properties and Wear Susceptibility Determined by Nanoindentation Technique of Ti13Nb13Zr Titanium Alloy after “Direct Laser Writing”

2023

Effect of pulse laser treatment at different process variables on mechanical behavior of carbon nanotubes electrophoretically deposited on titanium alloy

2023

The Influence of Laser Alloying of Ti13Nb13Zr on Surface Topography and Properties

2019

Mechanical and Corrosion Properties of Laser Surface-Treated Ti13Nb13Zr Alloy with MWCNTs Coatings

2020
Meta Tagi