The Effect of Wood Provenance and Density on Cutting Forces While Sawing Scots Pine (Pinus sylvestris L.)
Abstrakt
Several properties of wood including the cutting power requirements can be correlated to wood density. Therefore, according to the literature, the cutting power requirements (and/or cutting forces) could be computed as a function of the wood specific gravity. This research shows that such an approach, based solely on specific gravity, may be considered a rather rough and imperfect estimate of cutting power. Samples of Scots pine (Pinus sylvestris L.) wood from different provinces in Poland with varying densities were machined on a sash gang saw. The average cutting force versus average wood density (estimated with the standard gravimetric method) was calculated, and the local cutting forces correlated to the local wood density. The average values of the cutting forces measured at selected points along the sample’s length were calculated by linear regression to the X-ray absorbance (density) estimated by means of X-ray radiography.
Autorzy (6)
Cytuj jako
Pełna treść
- Wersja publikacji
- Accepted albo Published Version
- Licencja
- Copyright (2014 NC State University)
Słowa kluczowe
Informacje szczegółowe
- Kategoria:
- Publikacja w czasopiśmie
- Typ:
- artykuł w czasopiśmie wyróżnionym w JCR
- Opublikowano w:
-
BIORESOURCES
nr 9,
strony 5349 - 5361,
ISSN: 1930-2126 - Język:
- angielski
- Rok wydania:
- 2014
- Opis bibliograficzny:
- Chuchała D., Orłowski K., Sandak a., Sandak J., Pauliny D., Barański J.: The Effect of Wood Provenance and Density on Cutting Forces While Sawing Scots Pine (Pinus sylvestris L.)// BIORESOURCES. -Vol. 9, nr. 3 (2014), s.5349-5361
- Weryfikacja:
- Politechnika Gdańska
wyświetlono 175 razy
Publikacje, które mogą cię zainteresować
Is It Right To Predict Cutting Forces On The Basis Of Wood Density?
- D. Chuchała,
- K. Orłowski,
- D. Pauliny
- + 2 autorów
The effect of the wood temperature upon specific cutting resistance during machining with narrow-kerf saws
- K. Orłowski,
- J. Sandak,
- L. Dzurenda