Przedstawiono przegląd sposobów poprawy tolerancji udarów w nowoczesnych laminatach polimerowych. Są to: wytrzymalsze i bardziej ciągliwe materiały osnowy, dobieranie odpowiedniego powiązania osnowy i włókien, stosowanie włókien w postaci tkanin, zszywanie preform z wielu warstw tkanin, łączenie włókien ciągłych w preformy za pomocą kompozytowych szpilek, stosowanie tkanin NCF z włókien ciągłych łączonych na grubości dodatkowym...

This work presents some numerical results concerning simulation of failure of laminate composite specimens. In the article two tests to determine ultimate strength in an orthotropic layer, are considered: tension (TT1) and compression (TC1) test. The outcome is compared with experimental data provided by [9,10].

Mechanical behaviour was compared for glass/ polyester laminates manufactured in the boatbuilding plant using three methods: hand lay-up, vacuum bagging, infusion. Specimens were tested in dry condition and following accelerated water immersion test (70°C- corresponding to the exposure of 30 years at 19°C). In three point bending test 40-50% reduction in laminate strength was observed due to water immersion. The highest degradation...

The contribution is focused on derivation of the Ultimate Limit State (ULS) and Serviceability Limit State (SLS) design criteria for footbridges built of fibre-reinforced polymer matrix (FRP) laminates. The ULS design criterion is based on the design guidelines for above-ground, pressure, FRP composite tanks and the Tsai-Wu failure criterion, which is used to predict the onset of FRP laminates damage. The SLS criterion is based...