Didn't find any results in this catalog!
But we have some results in other catalogs.Filters
total: 5140
-
Catalog
- Publications 3674 available results
- Journals 12 available results
- Publishing Houses 1 available results
- People 40 available results
- Inventions 14 available results
- Projects 4 available results
- Laboratories 3 available results
- Research Teams 1 available results
- Research Equipment 3 available results
- e-Learning Courses 27 available results
- Events 1 available results
- Open Research Data 1360 available results
displaying 1000 best results Help
Search results for: CALCINATION TEMPERATURE
-
Temperature
Journals -
The Effect of Calcination Temperature on Structure and Photocatalytic Properties of WO3/TiO2 Nanocomposites
PublicationSeries ofWO3/TiO2 nanocompositeswere obtained by hydrothermal method followed by calcination in the temperature range from 400∘C to 900∘C. The characteristics of photocatalysts by X-ray diffractometry (XRD), scanning electron microscope (SEM), and diffuse reflectance spectroscopy (DRS) showed that increasing the calcination temperature from 400 to 900∘C resulted in change of photocatalytic activity under UV-Vis light.Moreover,...
-
TiO2 photoactivity in vis and UV light: The influence of calcination temperature and surface properties
PublicationPrzygotowano serię fotokatalizatorów w postaci tlenku tytanu (IV) kalcynowanych w różnych temperaturach od 350 do 750˚C. Charakterystyka fotokatalizatorów za pomocą metod XRD, UV-Vis/DRS, FTIR, XPS, BET oraz BJH wykazała, że próbka TiO2 aktywna w świetle widzialnym posiadała strukturę anatazu, powierzchnię właściwą ok. 200 m2/g, absorbowała światło o długości fali λ>400 nm oraz zawierała 10,1 % at. węgla (wiązanie C-C). Aktywność...
-
The effect of calcination temperature on structure and photocatalytic properties of Au/Pd nanoparticles supported on TiO2
PublicationBimetallic nanoparticles, composed of two different metal elements, can exhibit peculiar electronic, optical, and catalytic or photocatalytic properties that are absent in the corresponding monometallic nanoparticles. We show the effect of calcination temperature (from 350 to 700°C) on the structure and the photocatalytic properties of Au/Pd-modified TiO2. The composition of the bimetallic Au/Pd nanoparticles in relation to their...
-
HIGH TEMPERATURE
Journals -
The measurement and calculation of gas temperature inside a switchgear during fault arc period.
PublicationW artykule przedstawiono metodę obliczania temperatury gazu wewnątrz rozdzielnicy szczelnej z izolacją powietrzną podczas zwarć łukowych w oparciu o równanie przewodnictwa cieplnego. Przedstawiono wyniki badań eksperymentalnych temperatury gazów podczas zwarć z łukiem wędrującym. Opisano model do badań, układ probierczy i warunki badań. Wyniki obliczeń porównano z wynikami badań eksperymentalnych.
-
A new viscoelastic method of calculation of low-temperature thermal stresses in asphalt layers of pavements
PublicationThe paper presents a new method of calculation of thermal stresses in asphalt layers of pavements induced by cooling or heating. The method, developed by the author, is based on the analytical solution for the linear viscoelastic Burgers model extended numerically for the case of asphalt layers whose rheological parameters are strongly dependent on temperature. The coefficient of thermal expansion and Poisson’s ratio may optionally...
-
Analytical method for calculation of heat source temperature drop for the Organic Rankine Cycle application
PublicationIn the paper presented are considerations on the cooperation of the limited capacity heat source with the Organic Rankine Cycle unit. Usually the heat source providing thermal energy to the Organic Rankine Cycle (ORC) may have twofold characteristics. It can be in the form of a single phase fluid, i.e. as hot exhaust gas or hot liquid, or in some cases it may be available as a phase changing fluid, as for example, technological...
-
Photocatalytic activity of boron-modified TiO2 under visible light: The effect of boron content, calcination temperature and TiO2 matrix
PublicationPrzedstawiono wpływ temperatury kalcynacji (200, 300, 350, 400, 450 oraz 600oC) na fotoaktywność w świetle widzialnym (l> 400 nm) oraz właściwości powierzchniowe TiO2 modyfikowanego borem. B-TiO2 został przygotowany metodą impregnacji powierzchniowej. Jako prekursor bory wykorzystano ester trietylowy kwasu borowego (BATE). Charakterystyka otrzymywanych fotokatalizatorów obejmowała wyznaczenie powierzchni właściwej, właściwości...
-
Maciej Wierzbowski dr inż.
People