Abstrakt
FEM (Finite Element Method) is well-suited and widely used tool for simulating a range of phenomena: from these with simple and static behaviour, up to those complicated, highly nonlinear and involving many contacts. In present paper we use one of the advantages of FEM: parametric study could be easily performed and is more economical than series of in-situ tests. If recommended practices is carefully followed, results obtained from simulations may be considered as reliable. Current research is a part of scientific project RID 3A, some previous results could be found in paper. TB 11 standard test was analysed in few papers. In particular, we simulate TB11 test performed on short section of typical road barrier. Even thou typical polygon test is performed on e.g. 60 m long barrier section, few circumstances necessitate use of shorter sections, e.g. existence of intersections close to each other or point obstacle on the road side which need to be protected. In this study we try to throw some light on general question: are short section barriers as secure as their full-length parent? This paper do not aspire to give unequivocal answer to this question, we intend to show FEM and LS-DYNA in particular as reasonable tool to investigate this and similar cases.
Autorzy (5)
Cytuj jako
Pełna treść
- Wersja publikacji
- Accepted albo Published Version
- Licencja
- Copyright (2017 by DYNAmore GmbH)
Słowa kluczowe
Informacje szczegółowe
- Kategoria:
- Aktywność konferencyjna
- Typ:
- publikacja w wydawnictwie zbiorowym recenzowanym (także w materiałach konferencyjnych)
- Tytuł wydania:
- 11th European LS-DYNA Conference strony 1 - 10
- Język:
- angielski
- Rok wydania:
- 2017
- Opis bibliograficzny:
- Wilde K., Burzyński S., Bruski D., Chróścielewski J., Witkowski W.: TB11 test for short w-beam road barrier// 11th European LS-DYNA Conference/ Salzburg: , 2017, s.1-10
- Bibliografia: test
-
- Jamroz K., Burzyński S., Witkowski W., Wilde K.: "Numerical methods for the assessment of bridge safety barriers." In: Kleiber M, editor. Adv. Mech. Theor. Comput. Interdiscip. Issues, London: Taylor & Francis Group; 2016, p. 231-4. otwiera się w nowej karcie
- Goubel C., Di Pasquale E., Massenzio M., Ronel S.: "Comparison of crash tests and simulations for various vehicle restraint systems", 7th European LS-DYNA Conference, Salzburg, Austria, DYNAmore GmbH, 2009, s. 1-12. otwiera się w nowej karcie
- Vasenjak M., Borovinšek M., Ren Z.: "Computational simulations of road safety barriers using LS-DYNA", 6. LS-DYNA Anwenderforum, Frankenthal, DYNAmore GmbH, 2007, s. 1-8.
- Teng T., Liang C., Tran T.: "Effect of various W-beam guardrail post spacing and rail heights on safety performance", Advances in Mechanical Engineering, Vol. 7, No. 11, 2015, s. 1-16. otwiera się w nowej karcie
- Ren Z., Vesenjak M.: "Computational and experimental crash analysis of the road safety barrier", Engineering Failure Analysis, 12, 2005, s. 963-973. otwiera się w nowej karcie
- BS EN 1317-1,2:2010, "Road restraint systems", European Standard, 2010. otwiera się w nowej karcie
- DET NORSKE VERITAS AS. "Determination of Structural Capacity by Non-linear FE analysis Methods" 2013. otwiera się w nowej karcie
- Weryfikacja:
- Politechnika Gdańska
wyświetlono 103 razy