Search results for: mikroturbina
-
Design and investigations of the ethanol microturbine
PublicationThe paper presents the results of the design analysis and experimental investigations of the microturbine set consisting of the microturbine with partial admission and permanent magnet generator. The microturbine was designed for operation with the vapour of ethanol as a working fluid. Microturbine unit was tested for different parameters of the working fluid and varying the electrical load. The examples and the comparison between...
-
Performance Characteristics of a Micro-turbine, International
Publication. In the paper a design of a multi-stage micro-turbine with partial admission of all the stages is described in detail and the results of particular experimental investigations and numerical calculations are shown, followed by conclusions. The co-generative micro-power plant with the HFE7100 as a working medium was designed and built for experimental investigations. The values of the main cycle parameters were as follows:- heat...
-
Control of a vapour microturbine set in cogeneration applications
PublicationSystems with microturbines are implemented for local generation of heat and electricity. This paper presents the analysis of control concepts for a vapour microturbine set with a generator with permanent magnets, intended to work in small heat and power plants. Control system variants differed by the selection of controlled signals and set parameters. Possible ways of control were discussed and compared with experimentally determined...
-
Partial Admission Stages of High Efficiency for a Microturbine
PublicationThe paper presents the results of a design analysis of a microturbine for a cogeneration micro-power plant working in accordance with organic Rankine cycle. The heat power of the plant is assumed equal to 20kW and the corresponding available electric output is estimated to be about 3 kW. After the design analysis, the axial turbine with partial admission in all stages was built and tested experimentally. Special attentionwas paid...
-
Partial Admission Stages of High Efficiency for a Microturbine
PublicationThe paper presents the results of a design analysis of a micro-turbine for a co-generation micro-power plant working in accordance with organic Rankine cycle. The heat power of the plant is assumed equal to 20kW and the corresponding available electric output is estimated to be about 3kW. After the design analysis, the axial turbine with partial admission in all stages was built and tested experimentally. Special attention was...
-
Porównanie właściwości dynamicznych wirnika mikroturbiny łożyskowanego ślizgowo i tocznie
PublicationW artykule omówiono wyniki badań symulacyjnych małogabarytowegowirnika mikroturbiny osiowej łożyskowanego ślizgowo oraz tocznie.Obiektem badań był układ wirujący mikroturbiny zaprojektowanej dlapowstającej w IMP PAN w Gdańsku mikrosiłowni kogeneracyjnej małejmocy, pracującej w obiegu ORC. Prezentowane badania zostały wykonaneprzy wykorzystaniu własnych programów serii MESWIR oraz programówkomercyjnych: MADYN 2000 i ABAQUS. W artykule...
-
Porównanie właściwości dynamicznych wirnika mikroturbiny łożyskowanego ślizgowo i tocznie
PublicationW artykule omówiono wyniki badań symulacyjnych małogabarytowegowirnika mikroturbiny osiowej łożyskowanego ślizgowo oraz tocznie.Obiektem badań był układ wirujący mikroturbiny zaprojektowanej dlapowstającej w IMP PAN w Gdańsku mikrosiłowni kogeneracyjnej małejmocy, pracującej w obiegu ORC. Prezentowane badania zostały wykonaneprzy wykorzystaniu własnych programów serii MESWIR oraz programówkomercyjnych: MADYN 2000 i ABAQUS. W artykule...
-
Design and testing of a radial-axial microturbine for domestic applications
PublicationIn the paper presented is a new design of the radial-axial microturbine of 3-4kW capacity for operation with ethanol as working fluid
-
Analiza poprawy sprawności części przepływowej mikroturbiny osiowej z niepełnym zasilaniem
Publication -
Experimental investigations and simulations of the microturbine unit with permanent magnet generator
PublicationIn dispersed power generation, low power devices are used for local combined generating of heat end electric power. There are developing concepts of micropower plants with electric generators driven by steam or gas microturbines. The paper presents the results of an experimental investigations of the microturbine set consists of the turbine with partial admission, permanent magnet generator and three phase AC-to-DC rectifier. The...
-
Design and investigations of a micro-turbine flow part
Publication-generative micro-power plant with the HFE7100 as a working medium was designed and built for experimental investigations. The heat output of the plant was assumed equal to 20 kW, while the electric output amounted to about 3kW.In the paper a multi-stage micro-turbine with partial admission of all the stages is described in detail and the results of the particular experimental investigations and numerical calculations are shown,...
-
Thermodynamic Cycles of Air Microturbine Power Plants Working on Biomass Fuels
PublicationThe gas turbine engine is modified to work as an air turbine set which consists, in the simplest arrangement, of a compressor, a heat exchanger and a turbine. Air is a working medium for both: the compressor and the turbine. This kind of air turbine set can be applied in power plants working on biomass fuels. In this solution we can burn fuels of varying parameters in the external combustion chamber without any harmful effects...
-
Specyfika regulacji automatycznej mikroturbin parowych w rozproszonym wytwarzaniu energii elektrycznej i ciepła
PublicationZmierzając do zwiększenia udziału odnawialnych źródeł energii w wytwarzaniu energij elektrycznej i ciepła, oczekuje się w Polsce rozwoju m.in. mikro elektrociepłowni zasilanych biomasą. biogazem, gazem ze źródeł lokalnych, wodą ze źródeł geotermalnych. W rozproszonym wytwarzaniu energii elektrycznej i ciepła występują specyficzne problemy regulacji automatycznej, związane z wymaganą pewnością zasilania oraz jakością dostarczanej...
-
Analiza obiegów kogeneracyjnych z silnikami tłokowymi i mikroturbi-nami
PublicationPrzeprowadzono analizę dla układów kogeneracyjnych z mikroturbinami wykorzystującymi ciepło odpadowe z silników tłokowych. Rozważono cztery główne źródła ciepła odpadowego z silników tłokowych: spaliny wylotowe, woda chłodząca silnik, olej smarny i ciepło z systemu turbodaładowania. Obliczenia przeprowadzono dla silników General Electric Jerbacher typów: J320 GS-C25 i J416 GS-B05. Uwzględniono różne czynniki robocze siłowni (zarówno...
-
Numerical analysis of high temperature minichannel heat exchanger for recuperative microturbine system
PublicationConsidering the development of energy sector, distributed small-scale power generation, e.g., gas micro-CHP, is attracting considerable interest. In such installations, the heat exchanger is one of the key components possessing a significant influence on overall performance. Most studies concentrate on units operating below 900C, which do not fulfil the requirements of gas micro-CHP. Therefore, there remains a challenge to design...
-
A model development and experimental verification for a vapour microturbine with a permanent magnet synchronous generator
PublicationVapour microturbines with permanent magnet synchronous generators are implemented in micropower plants for dispersed power generation systems. The dynamic model of such a microturbine set was developed and presented. The developed relations result from the generic equations. Experimental data for two different working medium were used for model verification. A microturbine set model was tested during the changes in the parameters...
-
Some Aspects of Designing Nozzle Segments of Axial Microturbines,
PublicationIn the paper a multi-stage micro-turbine with partial admission of all the stages is described in detail and the results of the numerical calculations and experimental investigations are presented, followed by an appropriate discussion and conclusions.
-
Application of microturbines in CHP systems with reciprocating engines
PublicationThe analysis was carried out for Combined Heat and Power generation systems with micro-turbines power plants working on heat rejected from the reciprocating engine. The calculations were performed for GE Jerbacher engines of J320 GS- C05, J320 GS- C25 and J416 GS- B05 types. We considered different working media (both wet and dry fluids): water, ammonia, ethanol, methanol, methylacetylene (propyne), dimethyloether, sulphur dioxide,...
-
Dobór czynnika roboczego oraz korzystnych wartości podstawowych parametrów projektowych mikroturbiny do przetwarzania energii ze źródeł niskotemperaturowych
PublicationPraca poświęcona jest analizom termodynamicznym obiegów mikrosiłowni turbinowych, dla których, ze względu na bardzo małe wartości natężenia przepływu, szczególnie ważnym zadaniem jest dobór głównych parametrów obiegu cieplnego. Zastosowana metoda określania optymalnych parametrów obiegu łącznie z uwzględnieniem ich wpływu na geometrię mikroturbiny daje możliwość przeprowadzenia optymalizacji uwzględniającej jednocześnie rodzaj...
-
Modelowanie i analiza hydrodynamicznych łożysk foliowych
Publicationstreszczenie: w artykule omówiono zagadnienia związane z modelowaniem i analizą symulacyjną łożysk foliowych. badane łożyska zostały zaprojektowane do pracy w mikroturbinach energetycznych będących kluczowym elementem mikrosiłowni kogeneracyjnych orc. w kolejnych częściach pracy omówiono warunki pracy łożysk foliowych, opracowanie modelu numerycznego oraz analizę łożysk w zakresie obciążeń statycznych i dynamicznych. przedstawiono...