Filtry
wszystkich: 169
Wyniki wyszukiwania dla: rotor dynamic
-
Effect of presence of lifting pocket on the THD performance of a large tilting-pad thrust bearing
PublikacjaHydrostatic assistance is a commonly used method to improve limited load carrying ability of tiltingpad thrust bearings during transient states of operation of vertical shaft hydro-generators. Despite of special hydraulic equipment (as pumps, valves, etc.), it also requires manufacturing of special recesses/pockets at pad sliding surfaces, into which oil is injected under high pressure. It allows to lift the rotor before start-up...
-
Multi-objective optimization of the cavitation generation unit structure of an advanced rotational hydrodynamic cavitation reactor
PublikacjaHydrodynamic cavitation (HC) has been widely considered a promising technique for industrial-scale process intensifications. The effectiveness of HC is determined by the performance of hydrodynamic cavitation reactors (HCRs). The advanced rotational HCRs (ARHCRs) proposed recently have shown superior performance in various applications, while the research on the structural optimization is still absent. The present study, for the...
-
A Concept for Safe and Less Expensive Acceleration of a Marine Steam Turbine Start-up
PublikacjaThis paper analyses the issue of accelerated start-up of a marine steam turbine, which is an important problem because the start-up of a steam machine involves the combustion of fuel that is not transformed into useful energy. To find novel technologies that offer improvements in this aspect is essential due to restrictions on reducing ship emissions. Thus, the shorter the start-up time, the better for the environment and economy....
-
An electric ring thruster as auxiliary manoeuvring propulsion system for watercraft - construction analysis
PublikacjaThe reported project aimed at examining properties and purposefulness of use of modern electromagneticbearings for a screw propeller in a prototype version of a synchronous ring motor with rare earths magnets.Bearings of this type generate electromagnetic forces which keep the rotor in a state of levitation. Therotating machine with magnetic bearings can work in any environment which reveals diamagnetic properties(air, vacuum,...
-
Ecological bearing systems for water turbines – research and development at Gdansk University of Technology
PublikacjaIncreasing requirements for environmental protection make it necessary to introduce new materials and designs. Hydroelectric power plants operating in direct contact with water reservoirs and rivers are potentially endangering water cleanliness, hence they should also be modernized in the way minimizing the environmental hazards. A lot of progress in this field has been achieved in last decades, but still there is much work to...
-
Analysis of diagnostic informativeness of the exhaust temperature of a naval gas turbine
PublikacjaThe conducted investigations aimed to carry out an analysis of the possibility that the failures identification in the automatic control system of a gas turbine engine could be worked out on the basis of measurements of the exhaust stream temperature behind the gas generator. The exhaust temperature represents a basic control parameter, enabling technical state evaluation of the engine within the operation process, which is observed...
-
Control Strategy of a Five-Phase Induction Machine Supplied by the Current Source Inverter With the Third Harmonic Injection
PublikacjaIn the five-phase induction machine (IM), it is possible to better use the electromagnetic circuit than in the three-phase IM. This requires the use of an adequate converter system which will be supplied by an induction machine. The electric drive system described, in this article, includes the five-phase induction machine supplied by the current source inverter (CSI). The proposed novelty—not presented previously—is the control...
-
Porównanie właściwości dynamicznych wirnika mikroturbiny łożyskowanego ślizgowo i tocznie
PublikacjaW artykule omówiono wyniki badań symulacyjnych małogabarytowegowirnika mikroturbiny osiowej łożyskowanego ślizgowo oraz tocznie.Obiektem badań był układ wirujący mikroturbiny zaprojektowanej dlapowstającej w IMP PAN w Gdańsku mikrosiłowni kogeneracyjnej małejmocy, pracującej w obiegu ORC. Prezentowane badania zostały wykonaneprzy wykorzystaniu własnych programów serii MESWIR oraz programówkomercyjnych: MADYN 2000 i ABAQUS. W artykule...
-
Porównanie właściwości dynamicznych wirnika mikroturbiny łożyskowanego ślizgowo i tocznie
PublikacjaW artykule omówiono wyniki badań symulacyjnych małogabarytowegowirnika mikroturbiny osiowej łożyskowanego ślizgowo oraz tocznie.Obiektem badań był układ wirujący mikroturbiny zaprojektowanej dlapowstającej w IMP PAN w Gdańsku mikrosiłowni kogeneracyjnej małejmocy, pracującej w obiegu ORC. Prezentowane badania zostały wykonaneprzy wykorzystaniu własnych programów serii MESWIR oraz programówkomercyjnych: MADYN 2000 i ABAQUS. W artykule...