ISSN:
Publisher:
Disciplines
(Field of Science):
- mechanical engineering (Engineering and Technology)
Ministry points: Help
Year | Points | List |
---|---|---|
Year 2024 | 70 | Ministry scored journals list 2024 |
Year | Points | List |
---|---|---|
2024 | 70 | Ministry scored journals list 2024 |
2023 | 100 | Ministry Scored Journals List |
2022 | 70 | Ministry Scored Journals List 2019-2022 |
2021 | 70 | Ministry Scored Journals List 2019-2022 |
2020 | 70 | Ministry Scored Journals List 2019-2022 |
2019 | 70 | Ministry Scored Journals List 2019-2022 |
2018 | 13 | B |
2017 | 13 | B |
2016 | 13 | B |
2015 | 13 | B |
2014 | 7 | B |
2013 | 7 | B |
2012 | 6 | B |
2011 | 6 | B |
2010 | 9 | B |
Model:
Impact Factor:
Publishing policy:
- License
- open in new tab
- Information on publishing policy
- n/a
- Information on the conditions of self-archiving
- n/a
- Is self-archiving allowed by the journal?
- Yes - without restrictions
- Information on research data policy
- n/a
- Months of embargo
- no embargo
- Additional information
- Must link to journal homepage with DOI.
Sherpa Romeo:
Papers published in journal
Filters
total: 81
Catalog Journals
Year 2012
-
Diagnosing marine turbine engines through energy characteristics of their flow section
PublicationThe aim of the performed research was to develop of diagnostic method of the flow section of a marine turbine combustion engine based on the level of delamination of its energy characteristics. The here adopted diagnostic model provides for a formulation of the evaluation of the technical conditions based on the measurements of the parameters of the thermodynamic medium in the characteristic control cross-sections of the engine...
-
Dichotomous design of real-time systems
PublicationW pracy prezentuje się i analizuje dwie podstawowe metody projektowania komputerowych systemów czasu rzeczywistego, spełniających rozmaite zadania z zakresu automatyki, sterowania, nadzoru i diagnostyki, w których następuje interakcja komputera z obiektami i procesami przemysłowymi, które posiadają naturę ciągłą (pozwalającą na ścisłą matematyczną charakteryzację w czasie ciągłym). Definiuje się podejście uwarunkowane kontekstowo...
Year 2013
-
Diagnosis in the power piston machines
PublicationW artykule przedstawiono obecne techniki monitorowania pracy silników i sprężarek dużej mocy. Ze względu na znaczne koszty ewentualnego wyłączenia z ruchu tego typu maszyn są one poddane obserwacji dla przewidywania ewentualnych awarii oraz planowych zatrzymań. Rośnie liczba zaawansowanych systemów pomiarowych z indykowaniem cylindrów. Dawne metody wibroakustyczne zastępowane są pomiarami parametrów procesu termodynamicznego. Słowa...
-
Diagnostic testing of marine propulsion systems with internal combustion engines by means of vibration measurement and results analysis
PublicationIn this paper selected issues concerning vibration diagnosis of the mechanical system within marine propulsion units have been presented, carried out on the basis of experimental examinations of a real object in which an exceedance of the allowable vibration’s level had been observed. Used diagnosing system has been characterised. A procedure of longitudinal and transverse vibrations shaft lines of the mechanical system within...
-
Dual fuelling of truck CI engine with diesel oil and mixture of propane and butane
PublicationW artykule przedstawiono zasadę działania dwupaliwowego zasilania jednocześnie olejem napędowym i odparowanym LPG silnika samochodu ciężarowego. Pokazano korzyści wynikające ze zużycia tańszego paliwa zbadane doświadczalnie.
-
Effect of the absence of clear contractual conditions for the pur-chase of combined heat and power systems through public tenders
PublicationW artykule przedstawiono dyskusję konsekwencji stosowania różnych podejść do obliczeń kontraktowych parametrów technicznych zespołów kogeneracyjnych. Obliczenia te wykonywane są na potrzeby oferty przygotowywanej w związku z ogłoszeniem przetargu publicznego na zakup siłowni kogeneracyjnej. Brak precyzyjnych zasad określających warunk, i jakie należy przyjąć do wyznaczania parametrów kontraktowych zespołów kogeneracyjnych umożliwia...
Year 2011
-
Diagnostic tolerances' evaluation method of the start-up exhaust temperature of a naval gas turbine
PublicationThe conducted investigations aimed to elaborate the method of marking diagnostic tolerances of the exhaust temperature of a gas turbine observed during engine's start-up process. The diagnostic tolerances were determined by means of statistical inference by creating the hypothesis about a normal distribution of the start-up exhaust temperature's dispersion in the initial operation moment, which was subsequently verified applying...
-
Identification analysis of dynamic changes in the composition of biogas and their impact on the operation of internal combustion engines
PublicationW pracy zamieszczono wyniki badań składu biogazu pozyskiwanego na komunalnym wysypisku śmieci. Pozyskiwany biogaz jest wykorzystywany do zasilania biogazowych zespołów prądotwórczych wyposażonych w silniki o zapłonie iskrowym dostosowanych do zasilania tym paliwem. Pozyskiwany biogaz powstaje w sposób naturalny w procesie beztlenowej fermentacji zachodzącej przez ok. 20 lat, w organicznej części pryzmy odpadów składowanych na wysypisku...
Year 2019
-
DME as alternative fuel for compression ignition engines – a review
PublicationThe ecological issues and the depletion of crude oil, has led the researchers to seeking for non-petroleum based alternative fuels, along with more advanced combustion technologies, and after-treatment systems. The use of clean alternative fuels is the one of the most perspective method that aiming at resolving of the said issues. One of the promising alternative fuels that can be used as a clean highefficiency compression ignition...
-
Identification of damages in the inlet air duct of a diesel engine based on exhaust gas temperature measurements
PublicationThe temperature of the exhaust gas of a diesel piston engine, measured in the characteristic control sections of its thermo-flow system, can be a valuable source of diagnostic information about the technical condition of the elements limiting the working spaces thus separated, including the turbocharging system, but also its fuel supply system and replacement of the medium. In standard marine engine measurement systems equipped...
Year 2020
-
ECU calibration for gaseous dual fuel supply system in compression ignition engines
PublicationThe dual fuel (DF) combustion mode is proven solution that allows to improve or get at the same level engine performance and reduce toxic compounds in exhaust gases which is confirmed by researchers and end-users. DF combustion mode uses two fuels gaseous fuel as a primary energy source and a pilot quantity of diesel fuel as ignition source. However, in order, to fully take advantage of the potential of the dual fuel mode, DF system...
-
Evaluation of the significance of the effect of the active cross-sectional area of the inlet air channel on the specific enthalpy of the exhaust gas of a diesel engine using statistics F of the Fisher-Snedecor distribution
PublicationThis paper presents the application of Fisher-Snedecor distribution F statistics to assess the significance of the influence of changes in the active cross-sectional area of the inlet air channel (Adol) flow in a diesel engine on the observed diagnostic parameter determined on the basis of measurements of the quick changing exhaust gas temperature in the outlet channel, which is the specific enthalpy of the exhaust gas stream within...
Year 2009
-
Energetuc aspect of diesel engine operotion
PublicationW artykule zaproponowano interpretację wartościującą działania, które (podobnie jak przedstawione mechanice klasycznej działania Hamiltona i Maupertiusa oraz działanie wynikające ze zmiany pędu ciała) jest rozpatrywane jako wielkość fizyczna o jednostce miary zwanej dżulosekundą [dżulsekunda]. Przedstawiono oryginalną metodę analizy i oceny działania silników o zapłonie samoczynnym w ujęciu energetycznym dla potrzeb eksploatacyjnych....
Year 2010
-
Estimation of vehicle operational fuel consumption
PublicationW pracy przedstawiono metodę umożliwiającą wyznaczenie referencyjnego zużycia paliwa dla zarejestrowanych warunków eksploatacji. Warunki eksploatacji opisane są rozkładem energochłonności jednostkowej, która obejmuje zarówno wpływ warunków zewnętrznych jak również styl jazdy kierowcy. W pracy przedstawiono zestawienie wyników uzyskanych dla przejazdów wykonanych na terenie Gdańska, w regularnym ruchu miejskim. Przedstawiono także...
Year 2023
-
Evaluation of the energy efficiency of electric vehicle drivetrains under urban operating conditions
PublicationIn electric vehicles, as in hybrids vehicles, a very important factor affecting the energy efficiency of the powertrain is the ability to use the regenerative braking energy. Depending on the settings available in electric vehicles, the driver can choose different modes of operation: switch off the regenerative braking mode altogether, select the intensity of regenerative braking, or leave the control system in automatic mode....
-
Evaluation of the influence of the opening pressure of a marine Diesel engine injector on the results of numerical simulation of the working cycle and their comparison with the results of the laboratory experiment
PublicationThe article presents the results of a numerical simulation of the working process carried out in a diesel engine. In the applied utility program DIESEL-RK, the laboratory engine Farymann Diesel type D10 was implemented. A selected inoperability of its functional fuel supply system - reduced opening pressure of the injector pinj - was introduced. The values of adequate diagnostic parameters were determined: working gas temperature...
-
Fuel systems of high power stationary engine
PublicationThe use of alternative fuels and, in the future, synthetic fuels has forced changes in the design of fuel supply systems in internal combustion engines. When operating a stationary engine at constant load, the possibility of using lean fuel mixtures appears. The selection of a precise operating mixture ignition system requires changes in traditional fuel systems. The article presents the current designs of fuel supply systems and...
Year 2022
-
Experiments on compression ignition engine powered by nano-fuels
PublicationThe use of nanoparticles in fuels provides new opportunities for modification of fuel properties, which may affect the operational parameters of engines, in particular the efficiency and fuel consumption. The paper presents comparison of compression ignition engine performance fuelled with neat diesel and nano-diesel. Alumina (Al2O3) was used as nanoparticles. Surface-active substances, including Span 80 surfactant, as well as...
Year 2016
-
Gas turbines – technological development and potential use in CAES systems
PublicationThis article briefly describes Compressed Air Energy Storage (CAES), focusing on the technological development of one of the key elements of such systems – the gas turbines. It presents the basic parameters and features of gas turbines, as well as turbine classes with example models. Main tendencies in the structural and technological development are discussed. Changes and trends on electric energy markets are becoming more and...
Year 2015
-
Identification of diagnostic parameter sensitivity during dynamic processes of a marine engine
PublicationChanging some parameters of the engine structure alters the emission of harmful components in the exhaust gas. This applies in particular to the damage of charge exchange system as well as fuel system and engine supercharger. These changes are much greater during the dynamic states and their accompanying transitional processes. The different sensitivity of diagnostic parameters to the same force, coming from the engine structure, but...
seen 2307 times