Filters
total: 5795
-
Catalog
displaying 1000 best results Help
Search results for: finite-difference methods
-
Comment on "Quantitative comparison of analysis methods for spectroscopic optical coherence tomography"
PublicationIn a recent paper by Bosschaart et al. [Biomed. Opt. Express 4, 2570 (2013)] various algorithms of time-frequency signal analysis have been tested for their performance in blood analysis with spectroscopic optical coherence tomography sOCT). The measurement of hemoglobin concentration and oxygen saturation based on blood absorption spectra have been considered. Short time Fourier transform (STFT) was found as the best method for...
-
Comparison of the characteristics of journal bearings determined according to ISO 7902:2020 and obtained by other methods
PublicationThe article presents selected characteristics of journal bearings calculated with the use of various methods and compared to the results obtained with application of the basic bearing characteristics calculation procedure, as described in the ISO 7902:2020 standard. Additionally, the presented calculation results were compared with the parameters measured during experimental tests of the sliding bearings, working under loads and...
-
Comparison of noise reduction methods in radiometric correlation measurements of two-phase liquid-gas flows
PublicationTwo-phase liquid-gas flows occur frequently in the mining, energy, chemical, and petrochemical industries. One of non-contact methods used to analyse these flows is the gamma ray absorption method. However, the signals received from radiation detectors contain a significant stochastic noise, which makes them difficult to analyse. The article describes four methods of noise reduction in cross-correlation measurements of water-air...
-
Application of Multiplicative Drift Correction and Component Correction methods on simulated gas sensor array responses
PublicationSensor response drift is one of the most challenging problems in gas-analyzing systems. Such systems, commonly called electronic noses, are expected to be reliable and reproducible in the long term. Due to the drift phenomena, electronic noses usability is limited to the relatively short period of time, and frequent recalibrations of device are required. Because it is very hard to fabricate sensors without drift, this phenomenon...
-
Mariusz Kaczmarek dr hab. inż.
PeopleReceived M.Sc., Eng. in Electronics in 1995 from Gdansk University of Technology, Ph.D. in Medical Electronics in 2003 and habilitation in Biocybernetics and Biomedical Engineering in 2017. He was an investigator in about 13 projects receiving a number of awards, including four best papers, practical innovations (7 medals and awards) and also the Andronicos G. Kantsios Award and Siemens Award. Main research activities: the issues...
-
Ireneusz Czarnowski Prof.
PeopleIRENEUSZ CZARNOWSKI is a graduate of the Faculty of Electrical Engineering at Gdynia Maritime University. He gained a doctoral degree in the field of computer science at Poznan University of Technology and a postdoctoral degree in the field of computer science at Wroclaw University of Science and Technology. Since 1998 is associated with Gdynia Maritime University, currently is a professor of computer science in the Department...
-
Elastic waves in the railroad track substructures and its surroundings analyzed with non-classical operational methods
PublicationWe analyze the propagation of the waves generated by the rolling stock and the interaction of those waves on the medium and its surroundings. We use non-classical operational methods for monitoring construction of the railway infrastructure and for noise damping.
-
Radiative lifetime of a BODIPY dye as calculated by TDDFT and EOM-CCSD methods: solvent and vibronic effects
PublicationThe radiative emission lifetime and associated S1 excited state properties of a BODIPY dye are investigated with TDDFT and EOM-CCSD calculations. The effects of a solvent are described with the polarizable continuum model using the linear response (LR) approach as well as state-specific methods. The Franck–Condon (FC), Herzberg–Teller (HT) and Duschinsky vibronic effects are evaluated for the absorption and emission spectra, and...
-
Comprehensive analysis of low-temperature methods for reclaiming of ground tire rubber
PublicationManagement of waste tires has become an important topic for decades. The lack of an effective method to manage the materials as mentioned above leads to illegal landfills. This problematic waste can be divided into two main categories depending on the physical condition of the waste: (i) partially used tires; (ii) end-of-life tires. While the first group can be reused or retreaded, the second group requires special measures to...
-
Comparison of various flow maldistribution quantification methods in mini heat exchangers
PublicationThe aim of study is to compare various flow maldistribution quantification methods, using velocity, mass flow rate, pressure, and temperature. An experimentally validated numerical study has been prepared and a heat exchanger with 34 semi-circular channels with a diameter of 3.1 mm has been tested. The minichannels were heated from the bottom with a heat flux of 50, 60, 70, and 80 kW/m2. The cases for various inlet velocities of...
-
Conceptual methods of old-timer vehicles inspection tests based on current technical inspection methods at vehicle inspection stations
PublicationPrzedstawiono koncepcję metodyki okresowych badań technicznych pojazdów zabytkowych w stacjach kontroli pojazdów.
-
[AEiE] Introduction to advanced numerical methods in engineering
e-Learning Courses{mlang pl} Dyscyplina: automatyka, elektronika i elektrotechnika Zajęcia obowiązkowe dla doktorantów II roku Prowadzący: dr hab. inż. Robert Bogdanowicz, prof. PG, dr inż. Grzegorz Fotyga, dr hab. inż. Piotr Kowalczyk, prof. PG, dr hab. inż. Rafał Lech, prof. PG, dr hab. inż. Paweł Wierzba, prof. PG Liczba godzin: 15 Forma zajęć: wykład Kurs realizowany w zakładce WETI: https://enauczanie.pg.edu.pl/moodle/course/view.php?id=10126 Na...
-
[IMa] Electrical methods of materials and structures characterization
e-Learning Courses{mlang pl} Dyscyplina: inżynieria materiałowa Zajęcia fakultatywne dla doktorantów I i II roku Prowadzący: prof. dr hab. inż. Piotr Jasiński Liczba godzin: 15 Forma zajęć: wykład/seminarium {mlang} {mlang en} Discipline: materials engineering Facultative course for 1st and 2nd year PhD students Academic teachers: prof. dr hab. inż. Piotr Jasiński Total hours of training: 15 teaching hours Course type: lecture/seminar {mlang}
-
Numerical methods in heat and fluid flow, PG_00057408
e-Learning CoursesReiteration of information on thermodynamic cycles and extension of information on their modelling using commercial software tools. Presentation of balances, constitutive equations, how to set up conditions in CFD type codes. Equipment regulation and control in the context of heat exchangers.Presentation of the computational capabilities of the CFD calculation code ANSYS Fluent. Mass, momentum and energy balances in 0D and 3D terms.Analysis...
-
Scientific methods of computer data analysis and presentation
e-Learning Courses -
Assessment of image processing methods for the determination of propagation of squat-type defects in rails
PublicationWe demonstrate the idea of squat-type defect measurement in the rail and the concept of tracking of the defect development using the techniques of image acquisition and image processing as well as the methods of metric spaces. We introduce the concepts of a set diameter δ(A) and the metric ρ1, which come from the properties of plane figures, to compare and to observe the development of the defects. We characterize the feasibility...
-
PODEJŚCIE WARIANTOWE WE WSTĘPNYM PROJEKTOWANIU STATKÓW Variant methods approach to the preliminary ship design.
PublicationKlasyczna metoda projektowania okrętów jest metodą iteracyjną, bazującą na zgromadzonym doświadczeniu ze statków już zbu-dowanych. Natomiast w przypadku statku całkowicie nowego typu, bez „posagu wcześniejszych doświadczeń”, projektowanie polega na opracowaniu szeregu równoległych, wariantowych rozwiązań z wykorzystaniem optymalizacji. Artykuł wskazuje wybrane metody projektowe wykorzystujące optymalizacje, używane we wstępnym...
-
Exploring DAD and ADD Methods for Dealing with Urban Heat Island Effect
PublicationThe Urban Heat Island (UHI) effect in the context of climate change and temperature fluctuations is an increasing challenge for contemporary cities. Numerous activities focus on mitigation and adaptation to the UHI effect using both appropriately selected design strategies and technological solutions. However, not all of these technologies support the postulates of ecological and low-carbon cities. Their design, implementation,...
-
Alternative methods for dark fermentation course analysis
PublicationDark fermentation course analysis is crucial, as complexed matrix of gaseous components may be formed and revealed during the process. The paper considers key issues related to the microbiological process in which complex organic substances are transformed into hydrogen. For the purposes of hydrogen generation, the application of wastewater mixed sludge pre-treated according to Faloye method (Faloye et al. in Int J Hydrog Energy...
-
Modern methods of process management at healthcare facilities
Publication