ISSN:
Punkty Ministerialne: Pomoc
Rok | Punkty | Lista |
---|---|---|
Rok 2024 | 5 | Czasopisma spoza wykazu ministerialnego 2024 |
Rok | Punkty | Lista |
---|---|---|
2024 | 5 | Czasopisma spoza wykazu ministerialnego 2024 |
2023 | 5 | Czasopisma spoza wykazu ministerialnego 2023 |
2022 | 5 | Czasopisma spoza wykazu ministerialnego (2019-2022) |
2021 | 5 | Czasopisma spoza wykazu ministerialnego (2019-2022) |
2020 | 5 | Czasopisma spoza wykazu ministerialnego (2019-2022) |
2019 | 5 | Czasopisma spoza wykazu ministerialnego (2019-2022) |
2018 | 8 | B |
2017 | 8 | B |
2014 | 8 | B |
2013 | 8 | B |
2012 | 8 | B |
2011 | 8 | B |
2010 | 20 | A |
Punkty CiteScore:
Rok | Punkty |
---|---|
Rok 2022 | 0.9 |
Rok | Punkty |
---|---|
2022 | 0.9 |
2021 | 0.9 |
2020 | 0.8 |
2019 | 0.8 |
2018 | 0.7 |
2017 | 0.6 |
2016 | 0.5 |
2015 | 0.5 |
2014 | 0.4 |
2013 | 0.4 |
2012 | 0.3 |
2011 | 0.3 |
Impact Factor:
Sherpa Romeo:
Prace opublikowane w tym czasopiśmie
Filtry
wszystkich: 85
Katalog Czasopism
Rok 2012
-
Problems of analytical determination of journal bearing bush fatigue strength estimates
PublikacjaProblems connected with determination of stress distribution in sliding layer of thinwalled bearing bushes, investigated in bearing fatigue test rigs, have been presented. Using an example of plain bearings tested in the fatigue machine SMOK (built at the Gdask University of Technology) problems with obtaining a convergence of iterative procedure for determining the fatigue strength estimators of bearing alloy surface layer are...
-
Relieving the Measuring System of the Trailer for Tyre/Road Rolling Resistance Measurements from the Inertia Force
PublikacjaIn the article the principle of measuring of tyre/road rolling resistance tyres in road conditions applied in a special measuring trailer is presented. This trailer was built in Faculty of Mechanical Engineering at Gdansk University of Technology. The construction of two special devices used in this trailer was discussed. These devices eliminate the influence of some chosen confounding measurements factors such as: the inertia...
-
Shaft Misalignment Influence on Water Lubricated Turbine Sliding Bearings with Various Bush Modules of Elasticity
PublikacjaW artykule przeanalizowano wpływ wielkości przenoszenia osi wału względem panwi na nośność łożyska. Analizie poddano łożyska z odmiennymi rodzajami panwi o różnej sztywności.
-
The Influence of Gas Mixture in the Glow-Discharge Nitriding Process of Austenitic Stainless Steel on Characteristic of Nitrided Cases
PublikacjaAustenitic stainless steels characterize with excellent corrosion resistance, although low mechanical properties. In many cases that limits their exploitation in industrial applications. Moreover, austenitic stainless steel is susceptible to local corrosion in the presence of halide ions. In present works, it was emphasized that the nitriding of austenitic stainless steels gives some potential abilities to obtain beneficial effect...
-
The Rolling Contact Fatigue of PVD Coated Spur Gears
Publikacja
Rok 2014
-
Road texture influence on tire rolling resistance
PublikacjaTire rolling resistance is one of the most important resistive forces acting on road vehicles. It depends on tire and surface characteristics as well as vehicle operating parameters. This paper deals with the influence of road surface texture on rolling resistance of passenger car tires. Results of road measurements performed on variety of road surfaces are presented.
-
The analysis of turbine propulsion systems in nuclear submarines
PublikacjaThe article systematises submarines, which are presently in service, according to their propulsion types (both conventional and nuclear), power output, and submersion depth. Contemporary types of propulsion systems installed and used in submarines are discussed. Calculations were performed for the PWR (Pressurized Water Reactor) type nuclear propulsion system and the supercritical turbine propulsion system (supercritical reactor...
-
The initial selection of parameters for dynamic brake for car engine test dynamometer
PublikacjaThe article presents an analysis of the car engine loads. The aim of the analysis was to determine the parameters of the brake / electric motor on an engine test bad. Analysis of loads on the driving tests concerned on chassis dynamo to simulate them on an engine dynamometer. To check the range of dynamometer shaft angular acceleration inertial mass of a car was reduced on the crankshaft axis. The calculations of maximum shaft...
-
The Scuffing Resistance of WC/C Coated Spiral Bevel Gears
Publikacja
Rok 2013
-
Selected Problems of Cogeneration Energy Systems Designing, Fueled with Landfill Biogas
PublikacjaThe article discusses the impact of the quality of biogas fuel for operation of generating sets with internal combustion engines. There are presented selected investigation results of landfill biogas fueled gensets operation. The article includes also discussion of the possibility of increasing the efficiency of biogas fuelled cogeneration systems. It also presents guidelines for the optimal design of landfill biogas fueled engines,...
-
The Effect of Long-Term Annealing on Microstructure of Aluminide Coatings Deposited on MAR M200 Superalloy by CVD Method
Publikacja -
The Influence of Long-Term Heat Treatment on Microstructure of Zr-Modified Aluminide Coating Deposited by CVD Method on MAR M200+Hf Nickel Superalloy
Publikacja
Rok 2011
-
Shaking table experimental study on damage mechanism of the disconnecting switch under seismic excitation
PublikacjaThe efficiency of the energetic network is a very import safety issue in the region experienced by the earthquake. High voltage disconnecting switches are important elements of the energetic infrastructure used to separate electric circuits (i.e. during repairs), which should not be damaged remaining fully operational. The aim of the paper is to show the results of the shaking table experimental investigation focused on damage...
Rok 2010
-
Shaking table experimental study on diagnosis of damage and its evaluation in steel structure
PublikacjaCelem artykułu jest pokazanie wyników badań eksperymentalnych przeprowadzonych na stole sejsmicznym dotyczących identyfikacji uszkodzeń modelu dwukondygnacyjnej konstrukcji stalowej. Uszkodzenie zdefiniowano poprzez spadek sztywności i symulowano poprzez zamianę słupów modelu na elementy o mniejszym przekroju poprzecznym. Wyniki badań pokazują charakterystyczny spadek wartości naturalnych częstotliwości konstrukcji wraz ze wzrostem...
Rok 2016
-
Structure and Interactions in Chitosan Composites
Publikacja -
The Effect of Temperature on Wear Mechanism of the AlCrN Coated Components
Publikacja -
The Effectiveness of Polymer Damper in Damage Reduction of Temporary Steel Grandstand
PublikacjaA large number of accidents involving damage of temporary grandstands during different types of events were observed in the past. The aim of the paper is to analyse numerically the effectiveness of a polymer damper in damage reduction of a temporary steel scaffolding grandstand exposed to dynamic load due to jumping. The element has been installed as a diagonal one at the back part of the structure. The method has been compared...
Rok 2017
Rok 2009
-
Transmission and reflection coefficients for damage identification in 1D elements
PublikacjaW pracy przedstawiono mozliowści wykorzystania współczynnika odbicia i przejścia fali sprężystej w miejscu nieciągłości konstrukcji do identyfikacji jej rodzaju
-
Transmission and Reflection Coefficients for Damage Identification in 1D Elements
Publikacja
wyświetlono 1129 razy