Wyniki wyszukiwania dla: DIESEL ENGINE, TOP DEAD CENTER, LANGMUIR PROBE
-
Evaluation of the influence of the opening pressure of a marine Diesel engine injector on the results of numerical simulation of the working cycle and their comparison with the results of the laboratory experiment
PublikacjaThe article presents the results of a numerical simulation of the working process carried out in a diesel engine. In the applied utility program DIESEL-RK, the laboratory engine Farymann Diesel type D10 was implemented. A selected inoperability of its functional fuel supply system - reduced opening pressure of the injector pinj - was introduced. The values of adequate diagnostic parameters were determined: working gas temperature...
-
Energetuc aspect of diesel engine operotion
PublikacjaW artykule zaproponowano interpretację wartościującą działania, które (podobnie jak przedstawione mechanice klasycznej działania Hamiltona i Maupertiusa oraz działanie wynikające ze zmiany pędu ciała) jest rozpatrywane jako wielkość fizyczna o jednostce miary zwanej dżulosekundą [dżulsekunda]. Przedstawiono oryginalną metodę analizy i oceny działania silników o zapłonie samoczynnym w ujęciu energetycznym dla potrzeb eksploatacyjnych....
-
Conversion of a diesel engine bus into a trolleybus
PublikacjaPrzedsiębiorstwo Komunikacji Trolejbusowej w Gdyni od 2004 roku we własnym zakresie buduje trolejbusy w oparciu o nadwozia używanych autobusów. W monografii przedstawiono przyczyny rozpoczęcia tego przedsięwzięcie, jego przebieg oraz techniczny budowy trolejbusu w oparciu o nadwozie autobusowe.
-
The influence of the fuel spray nozzle geometry on the exhaust gas composition from the marine 4-stroke diesel engine
PublikacjaThe paper presents experimental research on a 4-stroke, 3-cylinder, turbocharged AL25/30 Diesel engine. Research consisted in investigating the effect of the geometry of the fuel injectors on the exhaust gas composition from the engine. During measurements, the engine was operated with a regulator characteristic of a load range from 40 kW to 280 kW, made by electric water resistance. The engine was mechanically coupled to the electric...
-
MODELLING OF TOXIC COMPOUNDS EMISSION IN MARINE DIESEL ENGINE DURING TRANSIENT STATES AT VARIABLE PRESSURE OF FUEL INJECTION
PublikacjaTransient states are an important part of the spectrum of engine loads, especially the traction engines. In the case of marine diesel engines, transient states are of particular importance in reducing the analysis of motion units for special areas and maneuvering in port, the participation of transient states in the load spectrum significantly increases, also, the emission of toxic compounds from this period increases proportionally....
-
Stochastic model of the process of diesel engine operation.
PublikacjaStreszczenie: Najistotniejszym problemem eksploatacji silników o zapłonie samoczynnym jest problem racjonalnego (a zwłaszcza optymalnego) sterowania procesem eksploatacji tych silników. Sterowanie takie może ułatwić zastosowanie iteracyjnego algorytmu wyznaczania optymalnych strategii opracowanego przez R.A. Howarda. Wykorzystanie jednak tego algorytmu do sterowania procesem eksploatacji silników wymaga między innymi opracowania...
-
A review on application of artificial neural network (ANN) for performance and emission characteristics of diesel engine fueled with biodiesel-based fuels
PublikacjaBiodiesel has been emerging as a potential and promising biofuel for the strategy of reducing toxic emissions and improving engine performance. Computational methods aiming to offer numerical solutions were inevitable as a study methodology which was sometimes considered the only practical method. Artificial neural networks (ANN) were data-processing systems, which were used to tackle many issues in engineering and science, especially...
-
Application of the F-statistic of the Fisher-Snedecor distribution to analyze the significance of the effect of changes in the compression ratio of a diesel engine on the value of the specific enthalpy of the exhaust gas flow
PublikacjaThe paper discusses the impact of changes in the compression ratio on the operating parameters of a diesel engine, e.g. on the temperature of exhaust gases. It presents the construction of the laboratory test stand, on which experimental measurements were realized. It is characterized how the actual changes of the compression ratio were introduced to the existing engine. The program of experimental investigations taking into account...
-
Magnetically sensitive fiber probe with nitrogen-vacancy center nanodiamonds integrated in a suspended core
PublikacjaEfficient collection of photoluminescence arising from spin dynamics of nitrogen vacancy (NV) centers in diamond is important for practical applications involving precise magnetic field or temperature mapping. These goals may be realized by the integration of nanodiamond particles with optical fibers and volumetric doping of the particles alongside the fiber core. That approach combines the advantages of robust axial fixation of...
-
Reliability and types of diagnosis in the process of diesel engine operation
PublikacjaThe article presents complexity of the problem concerning development of diagnosis with defined reliability by a diagnosing system (SDG) on technical condition of marine combustion engines, especially main engines. It was shown that development of the final diagnosis, the so-called initial operation diagnosis, on the operational usability (fDG on PEx) of a main engine in particular, is not possible without prior development of...
-
A concept of the predicting of technical state of diesel engine elements
PublikacjaPrzedstawiono możliwości i ograniczenia dotyczące prognozowania stanu technicznego elementów silników oraz wykazano potrzebę doskonalenia istniejących metod planowania ich obsług profilaktycznych. Wskazano możliwość przekształcenia rozkadów szybkości zużywania elementów silników na rozkłady czasu ich poprawnego działania do osiągnięcia stanu granicznego w celu prognozowania ich stanu technicznego i odpowiedniego planowania obsług.
-
Quantitative Assessment of Operation of Ship Main Diesel Engine
PublikacjaOperation of ship propulsion system is associated with realization of definite operational goals. If to elements of the system the operational reliability strategy could be applied, the situation would be very simple as existing conditions would unambiguously determine application of means being on hand. However decision to reject application of the strategy (even if hypothetical) becomes obvious with a view of necessity of ensuring...
-
Diagnostic Analysis of Exhaust Gas with A Quick-Changing Temperature from a Marine Diesel Engine Part II / Two Factor Analysis
PublikacjaThe article presents a continuation of research carried out to determine the effect of input parameters (changes in engine structure parameters) on selected output parameters (diagnostic measures), based on quickly changing exhaust gas temperature. A method of determining the simultaneous influence of two input factors (the structure parameter and the engine load) on one output factor was presented, as well as an evaluation...
-
Reduction of CO2 Emissions from Offshore Combined Cycle Diesel Engine-Steam Turbine Power Plant Powered by Alternative Fuels
PublikacjaDiverse forms of environmental pollution arise with the introduction of materials or energy that exert adverse effects on human health, climate patterns, ecosystems, and beyond. Rigorous emission regulations for gases resulting from fuel combustion are being enforced by the European Union and the International Maritime Organization (IMO), directed at maritime sectors to mitigate emissions of SOx, NOx, and CO2. The IMO envisions...
-
DIAGNOSTIC INFORMATION ANALYSIS OF QUICKLY CHANGING TEMPERATURE OF EXHAUST GAS FROM MARINE DIESEL ENGINE PART I SINGLE FACTOR ANALYSIS
PublikacjaIn this paper, attention was paid to the problem of low controllability of marine medium- and high-speed engines during operation, which significantly limits the parametric diagnosis. The measurement of quickly changing temperature of engine exhaust gas was proposed, the courses of which can be a source of diagnostic information. The F statistic of the Fisher-Snedecor distribution was chosen as a statistical tool. Laboratory tests...
-
Evaluation of the significance of the effect of the active cross-sectional area of the inlet air channel on the specific enthalpy of the exhaust gas of a diesel engine using statistics F of the Fisher-Snedecor distribution
PublikacjaThis paper presents the application of Fisher-Snedecor distribution F statistics to assess the significance of the influence of changes in the active cross-sectional area of the inlet air channel (Adol) flow in a diesel engine on the observed diagnostic parameter determined on the basis of measurements of the quick changing exhaust gas temperature in the outlet channel, which is the specific enthalpy of the exhaust gas stream within...
-
A semi-Markov model of fuel combustion process in a Diesel engine
PublikacjaW artykule przedstawiono czterostanowy model procesu spalania w przestrzeniach roboczych (cylindrach) silników o zapłonie samoczynnym w formie procesu semimarkowskiego, dyskretnego w stanach i ciągłego w czasie. Wartościami tego procesu są stany odpowiadające powszechnie akceptowanym rodzajom spalania w tego rodzaju silnikach a mianowicie takie stany procesu jak: spalanie pełne (całkowite i zupełne), spalanie niezupełne, spalanie...
-
Energy-time method for assesment of main diesel engine operation
PublikacjaW publikacji przedstawiono rozwinięcie prezentowanej w literaturze metody ilościowej oceny działania na przykładzie okrętowego silnika głównego z zapłonem samoczynnym. Według tej interpretacji, działanie silnika może zostać przedstawione jako wielkość fizyczna. W tym aspekcie, na przykładzie wybranego układu funkcjonalnego, silnika dokonano oceny przydatności tej wielkości do opisu własności niezawodnościowych tego układu.
-
Model of the combustion process in the marine 4-stroke diesel engine
Publikacja -
Planning of structure and range of preventive maintenance of marine diesel engine
PublikacjaPrzedstawiono sposób wyznaczania zasobów godzin pracy elementów złożonego obiektu technicznego na przykładzie okrętowego silnika spalinowego oraz planowania struktury i zakresu jego obsługi profilaktycznej.