Wyniki wyszukiwania dla: SENSITIVITY ANALYSIS
-
Towards spectral sensitivity curve for two-photon vision mechanism
PublikacjaAbstract Purpose: The perceived brightness of different visible light sources can be compared with photometric units based on the standardized luminosity curves (300-780nm range). As reported previously (PNAS 111(50), pp. E5445-E5454 (2014)), near-infrared (NIR) radiation can cause isomerization of visual pigments by one- or two-photon absorption. The perceived color of the stimulus is red in the case of one-photon vision (1PV)...
-
Probabilistic sensitivity of the limit states of structures using Monte Carlom simulation
PublikacjaThe paper presents the concept of probabilistic sensitivity of structural limit states with respect to given design variables. A general idea is presented, illustrated by a simple case solved in an analytical way. More general approach is presented for the engineering structures, in this case a dedicated Monte Carlo simulation procedure is involved as part of the methodology. Illustration of the engineering case is done, by means...
-
Fault Diagnostics in PEMFC Stacks by Evaluation of Local Performance and Cell Impedance Analysis
PublikacjaStarvation, flooding, and dry‐out phenomena occur in polymer electrolyte membrane fuel cells (PEMFCs), due to heterogeneous local conditions, material inhomogeneity, and uneven flow distribution across the single cell active area and in between the individual cells. The impact of the load level and air feed conditions on the performance was identified for individual single cells within a 10‐cell stack. Analysis of the current density...
-
Identification of diagnostic parameter sensitivity during dynamic processes of a marine engine
PublikacjaChanging some parameters of the engine structure alters the emission of harmful components in the exhaust gas. This applies in particular to the damage of charge exchange system as well as fuel system and engine supercharger. These changes are much greater during the dynamic states and their accompanying transitional processes. The different sensitivity of diagnostic parameters to the same force, coming from the engine structure, but...
-
New approaches for improving selectivity and sensitivity of resistive gas sensors: A review
PublikacjaResistive gas sensors are very popular and reliable but suffer from low selectivity and sensitivity. Various methods have been suggested to improve both features without increasing the number of sensors in gas detection systems. Fluctuation enhanced gas sensing was proposed to improve gas detection efficiency by analyzing low-frequency resistance fluctuations, and noise parameters can be more informative than the single DC resistance...
-
New approaches for improving selectivity and sensitivity of resistive gas sensors: a review
PublikacjaPurpose – This paper aims to present the methods of improving selectivity and sensitivity of resistance gas sensors. Design/methodology/approach – This paper compares various methods of improving gas sensing by temperature modulation, UV irradiation or fluctuation-enhanced sensing. The authors analyze low-frequency resistance fluctuations in commercial Taguchi gas sensors and the recently developed tungsten trioxide (WO3) gas-sensing...
-
An assessment of Islamic banking in Bosnia and Herzegovina – a comparative analysis using the CAMELS approach
PublikacjaThis paper examines the phenomenon of Islamic banking in Bosnia and Herzegovina. Although almost half of the Bosnian population is recognized as Islamic, there is only one bank purely based on Sharia operating in this country. The aim of the article is to conduct a comparative analysis of the financial standing of this bank and the banking sector in this country and region. The chosen method of analysis is CAMELS which examines...
-
On the sensitivity, selectivity, sensory information and optimalsize of resistive chemical sensors
PublikacjaWykorzystano pojęcia teorii informacji do określenia możliwości poprawy selektywności i czujności rezystancyjnych sensorów gazu. Podano ogólne rozważania dotyczące limitu selektywnoœci dla tych sensorów. Porównano iloraz sygnału do szumów oraz pojemność kanału informacyjnego dla sensorów chemicznych wykorzystujących jako sygnał zjawiska fluktuacyjne z klasycznymi sensorami charakteryzowanymi jedną wartością. Ogólne rozważania wsparto...
-
Sensitivity of the Baltic Sea level prediction to spatial model resolution
Publikacjahe three-dimensional hydrodynamic model of the Baltic Sea (M3D) and...
-
Sensitivity evaluation of Krakowiec clay based on time-dependent behavior
Publikacja -
A new OSS design based on parameter sensitivity tochanges in measurements
PublikacjaW wyniku istniejących silnych ograniczeń praktycznych i etycznych nałożonych na eksperymenty medyczne, procedura estymacji parametrów w diagnozie i terapii jest często zagadnieniem skomplikowanym. Jeśli dane pomiarowe pobierane są w postaci próbek krwi, liczba tych próbek, a także czas obserwacji powinny być zminimalizowane. Optymalizacja eksperymentu polega na optymalizacji odpowiedniego sformułowanego kryterium będącego funkcją...
-
Sensitivity to nitrogen dioxide of electrocatalytic gas sensor based on NASICON
PublikacjaW pracy przedstawiono wyniki badań czujnika elektrokatalitycznego na bazie NASICONu.
-
Human Obesity Is Characterized by a Selective Potentiation of Central Chemoreflex Sensitivity
Publikacja -
Impaired baroreflex sensitivity as a potential marker of cardiovascular risk in hypertension
Publikacja -
Selective Potentiation of Peripheral Chemoreflex Sensitivity in Obstructive Sleep Apnea
Publikacja -
Probabilistic sensitivity of limit states of structures. The Monte Carlo simulation
PublikacjaPraca zawiera koncepcję badania wrażliwości stanów granicznych konstrukcji na zmiany poszczególnych zmiennych podstawowych, w oparciu o procedurę symulacyjną Monte Carlo. Sformułowanie ogólne metody oparte jest na analizie stanów granicznych konstrukcji, wprowadzona metoda losowa umożliwia badania histogramu stanu granicznego oraz estymację niezawodności / prawdopodobieństwa awarii konstrukcji.
-
An analysis of the characteristics of Indonesian industrial sectors: 2005-2010
PublikacjaThe purpose of the current study is to analyze the characteristics of Indonesian industrial sectors from 2005 through 2010. The study employs the analysis instruments from the Input-Output (IO) analysis, namely the indices of the power of dispersion, and the sensitivity of dispersion. For 2005 and 2010, the study focuses on nine and seventeen industries, respectively. The results show that industry 3, manufacturing, placed the...
-
An analysis of the characteristics of Indonesian industrial sectors: 2005-2010
PublikacjaThe purpose of the current study is to analyze the characteristics of Indonesian industrial sectors from 2005 through 2010. The study employs the analysis instruments from the Input-Output (IO) analysis, namely the indices of the power of dispersion, and the sensitivity of dispersion. For 2005 and 2010, the study focuses on nine and seventeen industries, respectively. The results show that industry 3, manufacturing, placed the...
-
NON-LINE ANALYSIS OF STIFFNESS IN COMPRESSION CONDITIONS
PublikacjaThe analyzes were aimed at demonstrating the influence of parameters describing the deformation of the structure on the uncertainty of critical force, and the impact of technological imperfections on stress uncertainty in compression conditions. In a linear buckling analysis, the problem is considered only for the initial, permanent state of the stiffness matrix. In the case of demonstrating the influence of initial deformations...
-
Efficiency comparison of selected endoscopic video analysis algorithms
PublikacjaIn the paper, selected image analysis algorithms were examined and compared in the task of identifying informative frames, blurry frames, colorectal cancer and healthy tissue on endoscopic videos. In order to standardize the tests, the algorithms were modified by removing from them parts responsible for the classification, and replacing them with Support Vector Machines and Artificial Neural Networks. The tests were performed in...