Filtry
wszystkich: 4442
-
Katalog
- Publikacje 3303 wyników po odfiltrowaniu
- Czasopisma 45 wyników po odfiltrowaniu
- Konferencje 9 wyników po odfiltrowaniu
- Wydawnictwa 6 wyników po odfiltrowaniu
- Osoby 98 wyników po odfiltrowaniu
- Wynalazki 2 wyników po odfiltrowaniu
- Projekty 6 wyników po odfiltrowaniu
- Laboratoria 1 wyników po odfiltrowaniu
- Zespoły Badawcze 4 wyników po odfiltrowaniu
- Kursy Online 95 wyników po odfiltrowaniu
- Wydarzenia 11 wyników po odfiltrowaniu
- Dane Badawcze 862 wyników po odfiltrowaniu
wyświetlamy 1000 najlepszych wyników Pomoc
Wyniki wyszukiwania dla: carboxy group
-
Influence of Heat Treatment Temperature on Fatigue Toughness in Medium-Carbon High-Strength Steels
PublikacjaCurrent research has demonstrated that the tempering temperature affects the martensitic transformation of medium-carbon high-strength steels. This temperature plays an important role in the final microstructure, percentage ratios of martensite to ferrite phases and, consequently, in the mechanical properties and the fatigue response. So far, the relationship between the martensitic tempering temperature and the cyclic deformation...
-
Effects of UV light irradiation on fluctuation enhanced gas sensing by carbon nanotube networks
PublikacjaThe exceptionally large active surface-to-volume ratio of carbon nanotubes makes it an appealing candidate for gas sensing applications. Here, we studied the DC and low-frequency noise characteristics of a randomly oriented network of carbon nanotubes under NO2 gas atmosphere at two different wavelengths of the UV light-emitting diodes. The UV irradiation allowed to sense lower concentrations of NO2 (at least 1 ppm) compared to...
-
Effect of austempering temperature on microstructure and cyclic deformation behaviour of multiphase low-carbon steel
PublikacjaThis paper examined the cyclic deformation behaviour of multiphase low-carbon steel that was subjected to austempering heat treatments at four temperatures (190 °C, 230 °C, 275 °C, and 315 °C) below the martensite start temperature (Ms = 353 °C). The tests were conducted at room temperature, under fully reversed strain-controlled conditions, with strain amplitudes in the range 0.5–1.0%. The microstructure was observed by transmission...
-
Influence of carbon deposits and subsequent silylation of silica gel on sorption efficiency of explosive nitramines
Publikacja -
Carbon nanotube based dielectric spectroscopy of tumor secretion; electrochemical lipidomics for cancer diagnosis
Publikacja -
Post-Pyrolytic Carbon as a Phase Change Materials (PCMs) Carrier for Application in Building Materials
PublikacjaThis article covers new application for char as a carrier of phase-change materials (PCM) that could be used as an additive to building materials. Being composed of bio-char and PCM, the granulate successfully competes with more expensive commercial materials of this type, such as Micronal® PCM. As a PCM carrier, char that was obtained from the pyrolysis of chestnut fruit (Aesculus hippocastanum) with different absorbances of the...
-
The influence of the carbon equivalent on the weldability of high-strength low-alloy steel in the water environment
PublikacjaFrom many years, the high strength low alloy steels are often used for offshore constructions. This constructions, due to the environment in which they work, require more frequent repairs than the constructions from the land. For economic reasons, repairs take place in the underwater conditions, however water significantly decreases the weldability of steel. The paper presents the results of the CTS weldability test for S460ML...
-
Tailoring Electro/Optical Properties of Transparent Boron-Doped Carbon Nanowalls Grown on Quartz
PublikacjaCarbon nanowalls (CNWs) have attracted much attention for numerous applications in electrical devices because of their peculiar structural characteristics. However, it is possible to set synthesis parameters to vary the electrical and optical properties of such CNWs. In this paper, we demonstrate the direct growth of highly transparent boron-doped nanowalls (B-CNWs) on optical grade fused quartz. The effect of growth temperature...
-
Organic carbon fluxes of a glacier surface: a case study of Foxfonna, a small Arctic glacier
PublikacjaArctic glaciers are rapidly responding to global warming by releasing organic carbon (OC) to downstream ecosystems. The glacier surface is arguably the most biologically active and biodiverse glacial habitat and therefore the site of important OC transformation and storage, although rates and magnitudes are poorly constrained. In this paper, we present measurements of OC fluxes associated with atmospheric deposition, ice melt,...
-
Carbon Nanomaterials From Metal-Organic Frameworks: A New Material Horizon for CO2 Reduction
PublikacjaThe rise of CO2 in the atmosphere, which results in severe climate change and temperature increase, is known as the major reason for greenhouse effect. Reducing CO2 to value-added products is an attractive solution to this severe problem, along with addressing the energy crisis, to which the catalysts being employed are of vital importance. Due to their high porosity and tunable compositions, Metal-Organic Frameworks (MOFs) show...
-
Prediction of flow boiling heat transfer coefficient for carbon dioxide in minichannels and conventional channels
PublikacjaIn the paper are presented the results of calculations using authors own model to predict heat transfer coefficient during flow boiling for carbon dioxide. The experimental data from various researches were scrutinised conducted for a full range of quality variation and wide range of mass velocity. The aim of the study was to test the sensitivity of the in-house model. The work shows the importance of taking into account surface...
-
Prediction of flow boiling heat transfer coefficient for carbon dioxide in minichannels and conventional channels
PublikacjaIn the paper presented are the results of calculations using authors own model to predict heat transfer coefficient during flow boiling of carbon dioxide. The experimental data from various resea rches were collected. Calculations were conducted for a full range of quality variation and a wide range of mass velocity. The aim of the study was to test the sensitivity of the in-house model. The results show the importance of taking into...
-
Salt melt synthesis of curved nitrogen-doped carbon nanostructures: ORR kinetics boost
PublikacjaImplementing metal-free electrocatalysts for the oxygen reduction reaction (ORR) and revealing crucial chemical or topographical parameters driving their activity are vital for the development of power cells. The carbon-based catalysts are very often synthesized through carbonization of biopolymers, in particular, those one containing nitrogen groups such as chitosan. Unfortunately, the resulting carbonaceous materials usually...
-
Bis-phosphonated carbon nanotubes: one pot synthesis and their application as efficient adsorbent of mercury
PublikacjaEffective, one-pot method of CNTs phosphonylation is presented. Cheap and readily available reagents are used, so the process can be easily transferred to large-scale production. The product was analyzed using spectroscopic methods (FTIR, UV-vis, XPS). Thermal properties of the bis-phosphonated nanotubes are reported for the first time. Newly obtained material was tested as an adsorbent for mercury removal from water. The sorption...
-
Induced-fit binding of laccase to gold and carbon electrodes for the biological fuel cell applications
PublikacjaAnalogues of laccase natural substrates (syringic, veratric, ferulic, vanillic, isovanillic, 3,5-dimethoxybenzoic aldehydes) were employed to bind and orient laccase molecules in a way which facilitates adsorption of the catalyst molecules and their electrical connection with the conductive support. Laccase was bound efficiently to these substrates both on gold and carbon electrodes forming, respectively, 2D and 3D films sensitive...
-
Aspects of intergranular corrosion of AISI 321 stainless steel in high-carbon-containing environments
PublikacjaPurpose – The purpose of this paper is to present a case study of unexpected sensitization to intergranular corrosion of highly resistant AISI 321 steel in petrochemical conditions, where it was subjected to the simultaneous influence of elevated temperature of 250°C and vapors from the asphalt production process. Design/methodology/approach – Corrosion coupons were exposed in an installation carrying asphalt vapors. To identify...
-
UV-visible emision as a probe of core excitations applied to the furan carbon dioxide molecules
PublikacjaWykonano badania wzbudzenia wewnątrz powłokowego drobin furanu i dwutlenku węgla korzystając ze spektroskopii fluorescencyjnej w zakresie widzialnym i UV. Przeprowadzono pomiary emisji linii Hα i Hβ w pobliżu progu wzbudzenia O 1s i C 1s drobin furanu i dwutlenku węgla
-
Influence of cavitation intensity on the relative cavitation resistance of laser processed C45 carbon steel
PublikacjaPraca przedstawia badania względnej odporności kawitacyjnej we wstępnym okresie niszczenia laserowo przetopionej 6 kW laserem CO2 stali C45. Badania odporności kawitacyjnej wykonano na stanowisku z wirującą tarczą. Na erodowanej przetopionej warstwie powierzchniowej określono trzy obszary o różnej intensywności oddziaływania obciążeń kawitacyjnych. Określano wielkość odkształceń plastycznych w analizowanych obszarach, spowodowanych...
-
Improving denitrification efficiency at the "Wschod" WWTP in Gdansk (Poland) - effects of different carbon sources
PublikacjaCelem badań było określenie wpływu dawkowania trzech różnych źródeł węgla (ścieków po oczyszczaniu mechanicznym, metanolu, ścieków gorzelnianych) na szybkość denitryfikacji, mierzoną w warunkach laboratoryjnych z osadem czynnym z oczyszczalni ścieków Gdańsk-Wschód. Największą szybkość procesu (4.8-5.2 mgN/(g*h)) zaobserwowano dla ścieków przemysłowych. Dodatkowo przeprowadzono badanie długości fazy adaptacji osadu do metanolu w...
-
Electrochemical study of lithium insertion into carbon-rich polymer-derived silicon carbonitride ceramics
PublikacjaW pracy przedstawiono materiał ceramiczny, bogaty w węgiel krzemo azotek węgla (SiCN), otrzymany na drodze pirolizy w zakresie temperatur od 1100 do 1700°C. Badania elektrochemiczne insercji litu wykazały, że materiał elektrodowy na bazie SiCN może być obiecujący jako anoda w bateriach litowych. Próbka otrzymana w 1300°C cechuje się pojemnością 392 mAh/g i jest stabilna aktywna elektrochemicznie w trakcie interkalacji i deinterkalacji...
-
Covalent mechanochemical functionalization of carbon-encapsulated iron nanoparticles towards the improvement of their colloidal stability
Publikacja -
TiO2 Processed by pressurized hot solvents as a novel photocatalyst for photocatalytic reduction of carbon dioxide
Publikacja -
Fe-modified activated carbon obtained from biomass as a catalyst for α-pinene autoxidation
Publikacja -
Heat Transfer in Adsorption Chillers with Fluidized Beds of Silica Gel, Zeolite, and Carbon Nanotubes
Publikacja -
Effect of Pd loading on hydrogen storage properties of disordered mesoporous hollow carbon spheres
Publikacja -
Synthesis of carbon nanotubes via chemical vapor deposition by using rareearth metals as catalysts
Publikacja -
Inner-Tube Chirality Determination for Double-Walled Carbon Nanotubes by Scanning Tunneling Microscopy
Publikacja -
Comparative study on homogeneity, filling ratio and purity of iron filled multiwalled carbon nanostructures
Publikacja -
Single‐walled carbon nanotubes modified by PFO: An optical absorption and Raman spectroscopic investigation
Publikacja -
Cisplatin filled multiwalled carbon nanotubes – a novel molecular hybrid of anticancer drug container
Publikacja -
Facile synthesis N-doped hollow carbon spheres from spherical solid silica
Publikacja -
Carbon nanotubes decorated by mesoporous cobalt oxide as electrode material for lithium-ion batteries
Publikacja -
On the Formation of Single-Walled Carbon Nanotubes in Pulsed-Laser-Assisted Chemical Vapor Deposition
Publikacja -
Oxidized SWCNT and MWCNT as co-catalysts of polymeric carbon nitride for photocatalytic hydrogen evolution
Publikacja -
Graphitic carbon nitride/graphene oxide/reduced graphene oxide nanocomposites for photoluminescence and photocatalysis
Publikacja -
Systematic study on synthesis and purification of double-walled carbon nanotubes synthesized via CVD
Publikacja -
Porous silica matrix as an efficient strategy to boosted photocatalytic performance of titania/carbon composite
Publikacja -
Carbon Deposition and Sulfur Poisoning in SrFe0.75Mo0.25O3-δand SrFe0.5Mn0.25Mo0.25O3-δElectrode Materials for Symmetrical SOFCs
Publikacja -
Machinability investigation in electric discharge machining of carbon fiber reinforced composites for aerospace applications
Publikacja -
A distillery by-product as an external carbon source for enhancing denitrification in mainstream and sidestream treatment processes
PublikacjaThe use of fusel oil as an 'alternative' carbon source for denitrification in the mainstream and sidestream treatment processes was studied. Research comprised two kinds of batch experiments as well as acclimation of process biomass to external carbon sources. In the conventional nitrate utilization rate (NUR) measurements (one-phase experiments with non-acclimated biomass), the NUR with fusel oil was 1.4-1.7 g N/(kg VSS•h which...
-
Novel non-metallic carbon-nitrogen photocatalysts deposited in cold plasma for hydrogen production
Publikacja -
Photocatalytic Carboxylation of Organic Substrates with Carbon Dioxide at Zinc Sulfide with Deposited Ruthenium Nanoparticles
Publikacja -
Influence of free carbon on the Young's modulus and hardness of polymer‐derived silicon oxycarbide glasses
Publikacja -
Nonequilibrium thermodynamic model of diffusion processes in the steel - carbon thin film tribological system
Publikacja -
The Role of Organic and Inorganic Amendments in Carbon Sequestration and Immobilization of Heavy Metals in Degraded Soils
Publikacja -
Reducing Carbon Footprint of Agriculture—Can Organic Farming Help to Mitigate Climate Change?
Publikacja -
Pd nanoparticles with tunable diameter deposited on carbon nanotubes with enhanced hydrogen storage capacity
Publikacja -
Synergistic effect of activated carbon and Ni2O3 in promoting the thermal stability and flame retardancy of polypropylene
Publikacja -
Nitrogen-doped porous carbon embedded with cobalt nanoparticles for excellent oxygen reduction reaction
Publikacja -
Hierarchical porous carbon sheets derived on a MgO template for high-performance supercapacitor applications
Publikacja