Filtry
wszystkich: 2922
wyświetlamy 1000 najlepszych wyników Pomoc
Wyniki wyszukiwania dla: domination subdivision number
-
Falling accident risk in Poland.
PublikacjaFor the last few years we observe optimistic tendencies in traffic risk development in Poland the number of fatalities decreases about 10% per year, bringing Poland closer to European Union standards. Nevertheless in 2001 we observed the unexpected, and bigger than forecasted, casualty reduction. The reason was the economic downturn suffered across the country, resulting in reduced demand for transportation. The danger lies in...
-
Influence of an applied bearing system on behaviour of multi-span footbridge
PublikacjaThe cycle overpass in Gdynia is a box structure over 300 metres long, 10-span. It was opened for bicycle traffic in the second half of 2013. At the end of its construction, there was failure due to excessive horizontal displacement of the system. A number of bearings exceeded the range of permissible transverse shifts thus it was necessary to temporarily protect the spans from slipping. The FEM analysis of the original solution...
-
Slurry Erosion -Design of Test Devices
PublikacjaDegradation of material caused by impacts of a solid particle (erodent) suspended in a liquid is called slurry erosion and is a major problem in the hydropower and maritime industry. Slurry erosion depends on many factors, e.g. liquid and erodent velocity, size, shape, angle of impact, hardness and number of erodents, and strength of a target material. The various types of test devices have been designed to investigate an effect...
-
Azimuth estimator for a rotating array radar with wide beam
PublikacjaThe problem of estimating azimuth in rotating array radar with a beam, wide in the azimuth plane, is considered. Under such setup the echo signal usually has a very low signal to noise ratio, but the number of observations is large, because of long dwell times. The proposed solution is based on the maximum likelihood approach, but it employs simplifications which facilitate its implementation in real time systems. Results, obtained...
-
Acoustic journal bearing - A search for adequate configuration
PublikacjaClassical non-contact bearings are already used in a number of specialist applications but there are somespecialist areas where they cannot be used for variety of reasons and acoustic sliding bearings could be an alternative. The paper presents the quest for a configuration of an acoustic journal bearing and shows that the overall shape of the bearing and its geometry are of a vital importance for the load capacity oft he bearing....
-
“Project-factor-decision”. Decisive factors in IT projects and their impact on its success
PublikacjaThe aim of this article is to indicate the need for a deepening, systematizing and codifying of the theoretical and practical knowledge on IT project management, in the area of management decision-making processes. The scope of decisions made by managers is constantly on the increase. Project managers make decisions not only within the classic triangle of constraints, which consists of a schedule, a budget and the project scope,...
-
Weldability of S500MC Steel in Underwater Conditions
PublikacjaWet welding with the use of covered electrodes is one of the methods of underwater welding. This method is the oldest, the most economic and the most versatile. The main difficulties during underwater wet welding are: high cooling rates of the joint, the presence of hydrogen in the arc area and formation of hard martensitic structure in the weld. These phenomena are often accompanied by porosity of welds and large number of spatters,...
-
Accelerating Video Frames Classification With Metric Based Scene Segmentation
PublikacjaThis paper addresses the problem of the efficient classification of images in a video stream in cases, where all of the video has to be labeled. Realizing the similarity of consecutive frames, we introduce a set of simple metrics to measure that similarity. To use these observations for decreasing the number of necessary classifications, we propose a scene segmentation algorithm. Performed experiments have evaluated the acquired...
-
Modeling DAC Application Execution Time
PublikacjaAn application written in the Divide And Conquer paradigm is more difficult to model than SPMD application because of complex algorithm, causing use of many coefficients in a computational complexity function. Processors are divided into various layers, each layer contains different number of processors. Data packets processed in different layers and transferred between layers have different length. Moreover first layer processors use...
-
UK travel agents’ evaluation of eLearning courses offered by destinations: an exploratory study.
PublikacjaThis study aims to develop an understanding of the use of e-learning courses created for travel agents by Destination Management Organizations (DMOs). It explores agents’ perceptions of such courses. The research examines the views of 304 UK-based travel agents using online survey and investigates whether age, sex, type of agency, work experience, and educational level have influence on e-learning uptake. The satisfaction of travel...
-
Terminal charging scheduling of battery electric buses based on vehicle routing problem
PublikacjaElectric buses are considered to be a viable solution for reducing emission in dense urban areas. However, the greater charging time is a huge challenge for operators. In this paper, charging scheduling method was elaborated based on vehicle routing problem using mixed-integer linear programming model. The main novelty of the paper is the combination of modelling aspect, namely flexible turn sequence and heterogeneous shared charging...
-
A New, Reconfigurable Circuit Offering Functionality of AND and OR Logic Gates for Use in Algorithms Implemented in Hardware
PublikacjaThe paper presents a programmable (using a 1-bit signal) digital gate that can operate in one of two OR or AND modes. A circuit of this type can also be implemented using conventional logic gates. However, in the case of the proposed circuit, compared to conventional solutions, the advantage is a much smaller number of transistors necessary for its implementation. Circuit is also much faster than its conventional counterpart. The...
-
Dataset of non-isomorphic graphs of the coloring types (K3,Km-e;n), 2<m<7, 1<n<R(K3,Km-e).
Dane BadawczeFor K3 and Km-e graphs, a coloring type (K3,Km-e;n) is such an edge coloring of the full Kn graph, which does not have the K3 subgraph in the first color (representing by no edges in the graph) or the Km-e subgraph in the second color (representing by edges in the graph). Km-e means the full Km graph with one edge removed.The Ramsey number R(K3,Km-e)...
-
Implementacja w FPGA algorytmu detekcji krawędzi obrazu w czasie rzeczywistym
PublikacjaW artykule przedstawiono projekt architektury oraz implementację układową toru przetwarzania wstępnego obrazu z modułem detekcji krawędzi. Układ został zaimplementowany w FPGA Intel Cyclone. Zrealizowany moduł wykorzystuje pięć wybranych algorytmów wykrywania krawędzi, w tym Robertsa, Sobela i Prewitt.
-
Prądy łożyskowe w układach napędowych z silnikami indukcyjnymi
PublikacjaW pracy przedstawiono problemy występujące w układach napędowych z silnikami indukcyjnymi zasilanymi z falownika napięcia. Zwrócono uwagę na rosnącą liczbę uszkodzeń silników w napędach przekształtnikowych. Wskazano przyczyny wynikające z charakteru zasilania przekształtnikowego silnika. Główną uwagę poświęcono prądowi łożyskowemu, który odpowiada za większość awarii maszyn. Przedstawiono rodzaje prądów łożyskowych, wyjaśniając...
-
Coarse-grained simulation - an efficient approach for studying motions of large proteins
PublikacjaOne of the most important challenges in performing Molecular Dynamics (MD) simulations of large protein complexes is to accommodate the model accuracy and the simulation timescale. Hitherto, for the most relevant dynamics of protein aggregates in an explicit aqueous environment, the timescale reachable for the all-atoms simulations is of hundreds of nanoseconds. This range is four to six orders of magnitude smaller than processes...
-
Reduced-Cost Design Optimization of High-Frequency Structures Using Adaptive Jacobian Updates
PublikacjaElectromagnetic (EM) analysis is the primary tool utilized in the design of high-frequency structures. In vast majority of cases, simpler models (e.g., equivalent networks or analytical ones) are either not available or lack accuracy: they can only be used to yield initial designs that need to be further tuned. Consequently, EM-driven adjustment of geometry and/or material parameters of microwave and antenna components is a necessary...
-
Field Evaluation of High Modulus Asphalt Concrete Resistance to Low-Temperature Cracking
PublikacjaHigh-modulus asphalt concrete has numerous advantages in comparison to conventional asphalt concrete, including increased resistance to permanent deformations and increased pavement fatigue life. However, previous studies have shown that the construction of road pavements with High Modulus Asphalt Concrete (HMAC) may significantly increase the risk of low-temperature cracking. Those observations were the motivation for the research...
-
Microbial and chemical quality assessment of the small rivers entering the South Baltic. Part I: Case study on the watercourses in the Baltic Sea catchment area
PublikacjaThe area of the Coastal Landscape Park (CLP) due to its location is extremely attractive touristic area. In the summer season, a significant increase in population density is observed, which influences surface water quality. Large numbers of tourists generate an increased amount of municipal wastewater, being treated in local treatment plants and discharged into rivers and streams. The paper presents preliminary research from summer...
-
Novel staphylococci nucH taxonomical marker used in identification of human-associated Staphylococcus succinus subsp. casei
PublikacjaThe aim of our study was to assess the sequencing of unique nucH gene fragment based on performed bioinformatics analysis as a novel diagnostic method for the identification of difficult to identify staphylococcal human pathogenic strains. Initially, PCR-RFLP-rrn analysis specific to the spacers between 16SrDNA and 23SrDNA followed by HhaI restriction analysis was performed. Further, sequencing of nucH and 16S rDNA genes fragments...