displaying 1000 best results Help
Search results for: MATERIALS ENGINEERING
-
Effects of rapid heating on non-equilibrium microstructure evolution and strengthening mechanisms of titanium alloy
Publication -
Structure and Interactions in Chitosan Composites
Publication -
The Effect of Temperature on Wear Mechanism of the AlCrN Coated Components
Publication -
The Scuffing Resistance of WC/C Coated Spiral Bevel Gears
Publication -
Highly Oriented Zirconium Nitride and Oxynitride Coatings Deposited via High‐Power Impulse Magnetron Sputtering: Crystal‐Facet‐Driven Corrosion Behavior in Domestic Wastewater
PublicationHerein, highly crystalline ZrxNy and ZrxNyOz coatings are achieved by the deposition via high‐power impulse magnetron sputtering. Various N2 and N2/O2 gas mixtures with argon are investigated. The chemical composition and, as a result, mechanical properties of the deposited layer can be tailored along with morphological and crystallographic structural changes. The corrosion resistance behavior is studied by potentiodynamic measurements...
-
Influence of Phase Composition on Dielectric Properties of Bismuth-Based Ceramics with Scheelite-Type Structure
PublicationGoal of the present research was to study dielectric properties of BiNbO4 ceramics fabricated by solid state reaction route followed with pressureless sintering. The samples were fabricated from the mixture of oxides, viz. Nb2O5 and Bi2O3. Apart from stoichiometric amount an excess of 3%, 5% and 10% by mole of Bi2O3 was used. It was found that an excess amount of Bi2O3 oxide caused formation of Bi5Nb3O15 minor phase in amount of...
-
Dielectric Properties of BiNbO<sub>4</sub>-Based Ceramic-Polymer Composites with 0-3 Connectivity
PublicationIn the present study two-phase BiNbO4//PVDF composites with 0-3 connectivity were studied by impedance spectroscopy within the frequency range Δν=100Hz-1MHz at room temperature. Polyvinylidene fluoride (PVDF) acted as a matrix whereas bismuth niobate (BiNbO4) powder acted as a dispersed phase. The volume fraction of the ceramic phase was cV=2, 4, 6, 8, 10, 16 and 20vol%. Analysis of the impedance data registered for composites...
-
Shaking table experimental study on diagnosis of damage and its evaluation in steel structure
PublicationCelem artykułu jest pokazanie wyników badań eksperymentalnych przeprowadzonych na stole sejsmicznym dotyczących identyfikacji uszkodzeń modelu dwukondygnacyjnej konstrukcji stalowej. Uszkodzenie zdefiniowano poprzez spadek sztywności i symulowano poprzez zamianę słupów modelu na elementy o mniejszym przekroju poprzecznym. Wyniki badań pokazują charakterystyczny spadek wartości naturalnych częstotliwości konstrukcji wraz ze wzrostem...
-
Inelastic damage-involved response of colliding buildings during earthquakes
PublicationW artykule poddano analizie nieliniowe zachowanie się kolidujących ze sobą budynków powodujące ich uszkodzenie podczas trzęsień ziemi. Analiza dotyczy zderzeń pomiędzy dwoma sąsiednimi budynkami czterokondygnacyjnymi. Badania pokazują, iż zastosowanie nieliniowego modelu numerycznego zachowania się obu budowli podczas trzęsień ziemi ma duże znaczenia dla dokładności wyników.
-
Bearing Capacity of aluminum bars with built-up cross section and glued or welded connections
PublicationThe paper is focused on numerical analysis and experimental test of aluminum bars with glued and welded connections between separate members. The connection properties were tested experimentally. The numerical analysis were conducted for the beam and shell model of the structure. The shape and magnitude of initial geometric imperfection was taken into account
-
Pounding between Inelastic Three-Storey Buildings under Seismic Excitations
PublicationStructural interactions between adjacent, insufficiently separated buildings have been repeatedly observed during damaging ground motions. This phenomenon, known as the structural pounding, may result in substantial damage or even total collapse of structures. The aim of the present paper is to show the results of the nonlinear numerical analysis focused on pounding between inelastic three-storey buildings under seismic excitations....
-
Structural Dynamics and Stability of Composite Structures
PublicationThis an editorial for a special Issue devoted to the application of dynamic and stability analysis of composite structures. In structural applications, past few decades have seen outstanding advances in the use of composite materials including Functionally Graded Materials (FGM). Most structures, whether they are used in civil, marine, or aerospace engineering, are subjected to dynamic loads during their operation.Therefore, dynamic...
-
Resilient Interface Shear Modulus for Characterizing Shear Properties of Pavement Base Materials
Publication -
Evaluation of Mechanical Properties of Two-Stage Concrete and Conventional Concrete Using Nondestructive Tests
PublicationDifferent types of concrete mixtures are used as building materials. The manufacturing process of two-stage concrete (TSC) differs from that of conventional concrete. This study investigated conventional mechanical properties derive empirical relations for estimation of the mechanical parameters of TSC and conventional concrete mixtures. TSC was used to prepare 216 specimens and conventional concrete was used to prepare 108 specimens...
-
Fabrication of polyurethane and polyurethane based composite fibers by the electrospinning technique for soft tissue engineering of cardiovascular system
PublicationElectrospinning is the unique technique, which provides forming of polymeric scaffolds for soft tissue engineering, which include tissue scaffolds for soft tissues of cardiovascular system. Such artificial soft tissues of cardiovascular system may possess mechanical properties comparable to native vascular tissues. Electrospinning technique gives the opportu nity to form fibres with nm- to μm-scale in diameter. The arrangement...
-
Isothermal Calorimetry and Compressive Strength Tests of Mortar Specimens for Determination of Apparent Activation Energy
PublicationThe hydration process of cementitious materials involves a thermally activated reaction that depends on the composition of the mixture and the curing temperature. The main parameter affecting the temperature variation of cast-in-place concrete is the apparent activation energy, which can be used for the efficient prediction of the temperature evolution and maturity index of hardening concrete. This paper discusses two methods to...
-
Stress strain relations and modulus of elascity of two stage concrete.
PublicationOmówiono badania doświadczalne przeprowadzone dla betonu dwuetapowego. Beton wykonano z trzech różnych kruszyw przy zastosowaniu trzech różnych proporcji w/c i c/p. Wyznaczono związki pomiędzy naprężeniami i odkształceniami. Na drodze statystycznej opracowano wzory umożliwiające wstępne szacowanie wartości siecznego modułu Younga. Ponieważ metoda dwuetapowa pozwala na zachowanie kontaktu pomiędzy poszczególnymi elementami kamiennego...
-
Extracellular biosynthesis of cobalt ferrite nanoparticles by Monascus purpureus and their antioxidant, anticancer and antimicrobial activities: Yield enhancement by gamma irradiation
Publication -
Conducting composites as cable anodes in cathodic protection
PublicationOpisano zasadę działania oraz podstawowe parametry charakteryzujące układ anodowy z wykorzystaniem anod kablowych w systemie ochrony katodowej podziemnych konstrukcji. W tej metodzie ochrony jako materiał anodowy wykorzystywany jest kompozyt przewodzący, którego właściwości mechaniczne umożliwiają budowę anody w formie kabla biegnącego wzdłuż trasy konstrukcji podziemnej. Wykazano, że zawartość grafitu w elektrodzie kompozytowej...
-
Investigation into Locking Point of Asphalt Mixtures Utilizing Superpave and Marshall Compactors
Publication -
Corrosion of evaporator tubes in low emission steam boilers
PublicationPurpose of this paper is to reveal the mechanisms of corrosion processes of outer surfaces of low-emission steam boiler evaporator tubes. Examinations were performed to find the reasons of different corrosion susceptibility of tubes situated at combustion chamber on various levels. Examinations were conducted on several segments of 57 x 5.0 mm evaporator tubes made of 16M (16Mo3) steel grade. Segments were taken from level of...
-
MPD growth of single crystals of Ce3+ doped Gd3−xLuxAl5−yGayO12 mixed garnets and their luminescent, scintillation and photoconversion properties
Publication -
Effects of Immobilized RAP Binder on Asphalt-Aggregate Interaction and Performance of 100% Recycled Asphalt Mixtures
Publication -
Surface phenomena in discotic liquid crystals investigated using polarized FTIR transmission spectroscopy
Publication -
Relationship between Fatigue Condition of Asphalt Pavements and Deflection Lag from Traffic Speed Deflectometer
Publication -
Effect of carbonate substitution on physicochemical and biological properties of silver containing hydroxyapatites
Publication -
Influence of Aggregate Gradation on the Compactability of Asphalt Mixtures Utilizing Locking Point
Publication -
Discussion of “Design Process of Asphalt Mixture Incorporating Compaction-Effort Variable” by Yining Zhang, Lijun Sun, and Dong Luo
Publication -
Structural Dynamics and Stability of Composite Structures
Publication -
Potential Alternative to Styrene–Butadiene–Styrene for Asphalt Modification Using Recycled Rubber–Plastic Blends
Publication -
In vivo and in vitro study of a novel nanohydroxyapatite sonocoated scaffolds for enhanced bone regeneration
Publication -
Manufacturing of metal-polymer composites for medical applications
Publication -
Chemical and Mechanical Properties of 70-Year-Old Concrete
PublicationThe aim of this research is to determine the durability and strength of concrete continuous footing based on the chosen mechanical, physical, and chemical properties of the concrete. The presented investigations constitute some opinions from experts on the bearing capacity of concrete continuous footing and the possibilities of carrying additional loads and extended working life. The cylindrical specimens were taken from continuous...
-
Mechanical properties and corrosion resistance of dissimilar stainless steel welds
PublicationW artykule przedstawiono właściwości mechaniczne oraz odporność korozyjną doczołowych złączy różnoimiennych stali odpornych na korozję, austenitycznej 316L oraz duplex 2205. Blachy o grubości 15 mm spawano automatycznie łukiem krytyn z różnymi energiami liniowymi. Wykazano, że właściwości mechaniczne złączy spełniają wymagania okrętowych towarzystw klasyfikacyjnych, natomiast najbardziej narażoną strefą złącza na działanie korozji...
-
The effect of long-term service at elevated temperatures on structure and mechanical properties of Cr-Mo-V steel
PublicationPurpose: of this paper is to reveal the microstructural changes in 13HMF steel exposed to long-term service at elevated temperatures. The degradation of bainite structure was determined and carbides morphology has been examined. The influence of carbides evolution was discussed in dependence of creep rupture strength and mechanical properties of the steel.
-
Surface-orientated platinum nanoparticles electrodeposited on a carbon substrate as a high performance electrocatalyst for glucose oxidation reaction in alkaline media
Publication -
Antibiotic loaded microspheres as antimicrobial delivery systems for medical applications
Publication -
An electrochemical interface for direct analysis of amlodipine in tablets and human blood samples
Publication -
Micro-strain administered SHG intensity enhancement by heavy Ce doping in co-precipitated ZnO nanoparticles
Publication -
Mechanical Properties of Polyester Coated Fabric Subjected to Biaxial Loading
PublicationThe paper is focused on the comparison between uniaxial and biaxial laboratory test results for polyester coated fabric. A short literature review concerning coated woven fabrics with emphasis on biaxial tensile tests is presented. A description of the polyester-coated fabric under biaxial test by means of constitutive models and material parameter values is proposed. To establish the right values of the ultimate tensile strength,...
-
The effect of depth of surface layers constituted by vacuum technologies on pitting
PublicationThe paper presents the results of a study of the effect of vacuum technologies of formation of surface layers on pitting of associated elements in a lubricated, heavy-load rolling contact. The study has shown that increase in a PVD coat depth is accompanied by decrease in the fatigue friction pair.
-
Discussion of “Enhanced Pavement Performance and Improved Stability of Asphalt and Recycled Plastic Blends Modified by Exfoliated Clay Nanoplatelets”
Publication -
Evaluating Asphalt Mix Ingredients by Moisture Susceptibility: The Development of a New Modified Boiling Test Procedure Based on Digital Imaging
Publication -
Quantification of Asphalt Mixture Interlocking Utilizing 2D and 3D Image Processing
Publication -
Cobalt-/Copper-Containing Perovskites in Oxygen Evolution and Reduction Reactions
Publication -
Characteristics of hybrid chitosan/phospholipid-sterol, peptide coatings on plasma activated PEEK polymer
Publication -
Effect of UV radiation and chitosan coating on the adsorption-photocatalytic activity of TiO2 particles
Publication -
Efficient synthesis of PMMA@Co0.5Ni0.5Fe2O4 organic-inorganic hybrids containing hyamine 1622 – Physicochemical properties, cytotoxic assessment and antimicrobial activity
Publication -
The impact of nozzle configuration on the heat transfer coefficient
Publication -
Effect of brookite on the photocatalytic properties of mixed-phase TiO2 obtained at a higher temperature
Publication