Filtry
wszystkich: 6133
-
Katalog
wyświetlamy 1000 najlepszych wyników Pomoc
Wyniki wyszukiwania dla: FLOOD PREDICTION
-
The Discrete-Continuous, Global Optimisation of an Axial Flow Blood Pump
PublikacjaThis paper presents the results of the discrete-continuous optimisation of an axial flow blood pump. Differential evolution (DE) is used as a global optimisation method in order to localise the optimal solution in a relatively short time. The whole optimisation process is fully automated. This also applies to geometry modelling. Numerical simulations of the flow inside the pump are performed by means of the Reynolds-Average Navier-Stokes...
-
Blood Pressure - Pulse Transit Time Relationships: Comparative Studies
PublikacjaA non-invasive and continuous blood pressure estimation could allow a better diagnosis and an earlier detection of various diseases. It could be performed using a photoplethysmography. However, it requires that a relation between blood pressure and pulse transit time is known. Eleven theoretical formulas were used in obtaining the simulated and noise free synthetic data. Then, they were utilized in validation of three, commonly...
-
Estimation of blood pressure parameters using ex-Gaussian model
PublikacjaThe paper presents an example of model-based estimation of blood pressure parameters (onset, systolic and diastolic pressure) from continuous measurements. First, the signal was low pass filtered and its quality was estimated. Good quality periods were divided into beats using an electrocardiogram. Next, the beginning of each beat of the blood pressure signal was approximated basing on the function created from the sum of two independent...
-
Causes of damage and methods of repairing floor made on polystyrene concrete
PublikacjaThe paper describes damages, tests and repair of the floor made on existing ceiling and expanded polystyrene concrete underlay. The floor was built on a reinforced concrete ceiling with an area of about 1050 m2. Significant damage in the form of cracks, detachments and unevenness was found in the floor. In order to determine the causes of damage, in situ tests and laboratory tests were carried out. It was found that the damage...
-
Integrated Application of GPR and Ultrasonic Testing in the Diagnostics of a Historical Floor
PublikacjaThe paper presents the results of integrated ground penetrating radar (GPR) and ultrasonic testing (UT) measurements conducted on a historical floor in St. Nicholas’ Church, Gdańsk, Poland. The described inspection was the first stage of the technical state assessment of the building. The aim of the study was the detection of underfloor air gaps, which were observed in a few trial pits. The condition of the ground under the floor...
-
Food and Foodways
Czasopisma -
Food & History
Czasopisma -
FOOD BIOTECHNOLOGY
Czasopisma -
NAHRUNG-FOOD
Czasopisma -
Food Biophysics
Czasopisma -
Food Security
Czasopisma -
FOOD AUSTRALIA
Czasopisma -
Food Webs
Czasopisma -
Food Frontiers
Czasopisma -
Food Research
Czasopisma -
Nature Food
Czasopisma -
Food Ethics
Czasopisma -
Reduction of Derivative pipeline effort in water turbine
PublikacjaThe paper presents an approach to evaluate and reduce the effort of the derivative pipeline in a water turbine of a hydrostatic power station in its vulnerable spots. Potential places of the biggest effort of the structure, as well as the coefficient of displacement and safety factor related to them were identified using FEM numerical method. Pipeline reinforcement was designed and made based on FEM analysis. Original technology...
-
Distributed Data Reduction through Agent Collaboration
Publikacja -
An Approach to Data Reduction and Integrated Machine Classification
Publikacja -
Model order reduction for subgridding in fdtd scheme
PublikacjaW artykule zaprezentowana została technika pozwalająca na uzyskanie wysokiej rozdzielczości w metodzie FDTD. Prezentowany algorytm jest połączeniem metod redukcji rzędu modelu i lokalnych zagęszczeń zaimplementowanych do FDTD. Pozwala to zmniejszyć liczbę użytych zmiennych stanu, a także skrócić krok czasowy, co skutkuje znacznie krótszym czasem symulacji, niż w przypadku klasycznej metody FDTD.
-
Digital techniques for noise reduction in CCD detectors
Publikacja -
Application of optical fibres in oxidation-reduction titrations
Publikacja -
Metal salts reduction during parylenes polymerization
PublikacjaPublikacja o wynikach obliczeń kwantowych o możliwości redukcji niektórych soli metali przy pomocy rodników parylenu w czasie jego polimeryzacji.
-
Reduction of Inrush Current by Demagnetization of Magnetic Core
PublikacjaW artykule przedstawiono demagnetyzację rdzenia transformatora jako metodę ograniczania prądu załączeniowego. W zaproponowanej metodzie źródłem energii wykorzystywanej do rozmagnesowania jest kondensator. W przeprowadzonych obliczeniach symulacyjnych rozważono różne wartości pojemności kondensatora i wartości napięcia w celu określenia optymalnych wartości tych parametrów. Następnie obliczono strumienie szczątkowe, jakie ustalają...
-
Wow defect reduction based on interpolation techniques
PublikacjaW artykule przedstawiono wyniki badania różnych technik interpolacji wykorzystanych w redukcji kołysania dźwięku. W badaniach użyto: interpolację liniową, techniki interpolacji wielomianowej, i interpolację funkcją sink. Jakość rekonstrukcji zbadano wykorzystując sztucznie spreparowany sygnał foniczny, zrekonstruowany wymienionymi metodami interpolacji. Jakość rekonstrukcji oceniono wykorzystując standardowe deskryptory jakości...
-
Optimization of Graphene Oxide Synthesis and Its Reduction
PublikacjaIn this article, we present the review of the chemical methods of synthesis of graphene oxide and its reduction in order to obtain the so-called reduced graphene oxide (rGO) whose properties are similar to those of pure graphene. We also present our experiments and the results in this field and the comparison of the efficiency of different methods of synthesis as well as the reduction of graphene oxide. To characterize the obtained...
-
Reduction of the end-effect in surface texture analysis
Publikacja -
Data reduction and stacking for imbalanced data classification
Publikacja -
Reduction of pressure forces in turbine labyrinth seals
PublikacjaPrzedstawiono nową metodę zmniejszani sił samowzbudnych typu aerodynamicznego. zastosowano ją do różnych typów nadbandażowych uszczelnień labiryntowych. Efektywność rdukcji sił samowzbudnych wynosiła nawet ponad 60%. Potwierdzone rezultay obliczeniami i eksperymentalnie.
-
Reduction of steel chimney vibrations with a pendlum damper.
PublikacjaKarman vortices observed around chimneys may induce dangerous structural vi-brations at certain wind velocities. The aim of this paper is to analyse theeffectiveness of pendulum damper in vibration reduction of a steel chimney. A two degree-of-freedom system is used to model the behaviour of the struc-ture equipped with a damper. The results of the study show that the use of pendulum with tuned frequency leads to significant...
-
Wow defect reduction based on interpolation techniques
PublikacjaW referacie przedstawiono wyniki badania różnych technik interpolacji wykorzystanych w redukcji kołysania dźwięku. W badaniach użyto: interpolację liniową, dwie techniki interpolacji wielomianowej (Hermite i spline), i technikę sumowania okienkowanych funkcji sink. Jakość rekonstrukcji wykonano wykorzystując sztucznie spreparowany sygnał audio, rekonstruowany wymienionymi metodami interpolacji. Jakość rekonstrukcji oceniono wykorzystując...
-
Experiences and Challenges in Fatality Reduction on Polish Roads
PublikacjaAccording to the UN, road safety is the key to achieving sustainable development goals, yet the complexity of how road accidents happen makes this a difficult challenge leaving many countries struggling with the problem. For years, Poland has infamously been one of the EU’s top countries for road-accident fatality rates. Despite that, it has made significant progress in the last thirty years with a fatality reduction of more than...
-
Thermohydraulic maldistribution reduction in mini heat exchangers
PublikacjaA detailed numerical investigation has been carried out to analyze the flow maldistribution in 50 parallel 1 mm × 1 mm rectangular minichannels and 1 mm depth minigap section with rectangular, trapezoidal, triangular or concave manifolds in Z-type flow configuration. The working medium was ethanol and the mass flow rate was 5 × 10−4 kg/s. Both sections were heated from the bottom side. Heat flux of 10 000 W/m2 and 5000 W/m2 was...
-
Color prediction from first principle quantum chemistry computations: a case of alizarin dissolved in methanol
PublikacjaThe electronic spectrum of alizarin (AZ) in methanol solution was measured and used as reference data for color prediction. The visible part of the spectrum was modelled by different DFT functionals within the TD-DFT framework. The results of a broad range of functionals applied for theoretical spectrum prediction were compared against experimental data by a direct color comparison. The tristimulus model of color expressed in terms...
-
Fragmental Method KowWIN as the Powerful Tool for Prediction of Chromatographic Behavior of Novel Bioactive Urea Derivatives
Publikacja -
Prediction of the structures of proteins with the UNRES force field, including dynamic formation and breaking of disulfide bonds
Publikacja -
UNRES server for physics-based coarse-grained simulations and prediction of protein structure, dynamics and thermodynamics
Publikacja -
Application of gas chromatographic data and 2D molecular descriptors for accurate global mobility potential prediction
PublikacjaMobility is a key feature affecting the environmental fate, which is of particular importance in the case of persistent organic pollutants (POPs) and emerging pollutants (EPs). In this study, the global mobility classification artificial neural networks-based models employing GC retention times (RT) and 2D molecular descriptors were constructed and validated. The high usability of RT was confirmed based on the feature selection...
-
Prediction of NOx Emission Based on Data of LHD On-Board Monitoring System in a Deep Underground Mine
Publikacja -
Prediction Model for Hemorrhagic Complications after Laparoscopic Sleeve Gastrectomy: Development of SLEEVE BLEED Calculator
Publikacja -
Scale effect in the self-propulsion prediction for Ultra Large Container Ship with contra-rotating propellers
PublikacjaThis article addresses the problem of the scale effect for an Ultra Large Container Ship (ULCS) with a novel twin-crp-pod propulsion system. Twin-crp-pod steering-propulsion arrangement is an innovative solution that gains from three well-known systems: twin-propeller, contra-rotating propellers and pod propulsors. It is expected that applying the twin-crp-pod system to the analysed Ultra Large Container Ship will increase propulsion...
-
Load path sensitivity and multiaxial fatigue life prediction of metals under non-proportional loadings
PublikacjaEngineering components often operate under complex loadings, in which the variable amplitude multiaxial stresses are raised by geometric discontinuities including holes, grooves, fillets and shoulders, etc. Besides, the non-proportional loading will lead to the rotation of maximum principal stress/strain and additional fatigue damage of structural elements in service. Consequently, the multiaxial and non-proportional loading have...
-
Numerical Modelling for Prediction of Compression Index from Soil Index Properties in Jimma town, Ethiopia
PublikacjaIn this study, correlations are developed to predict compression index (Cc) from index parameters so that one can be able to model Jimma soils with compression index using simple laboratory tests. Undisturbed and disturbed soil samples from twelve different locations in Jimma town were collected. Laboratory tests like specific gravity, grain size analysis, Atterberg limit, and one-dimensional consolidation test for a total of twenty-four...
-
Advanced Scalar-valued Intensity Measures for Residual Drift Prediction of SMRFs with Fluid Viscous Dampers
PublikacjaMaximum Residual Inter-story Drift Ratio (RIDRmax) plays an important role to specify the state of a structure after severe earthquake and the possibility of repairing the structure. Therefore, it is necessary to predict the RIDRmax of Steel Moment-Resisting Frames (SMRFs) with high reliability by employing powerful Intensity Measures (IMs). This study investigates the efficiency and sufficiency of scalar-valued IMs for predicting...
-
EXPERIMENTAL VERIFICATION OF THE METHOD OF FLOW BOILING AND FLOW CONDENSATION HEAT TRANSFER PREDICTION FOR SELECTED FLUIDS
PublikacjaIn the paper presented are the results of calculations using authors own model to predict heat transfer coefficient during flow boiling of different refrigerants. The experimental data from various research studies from literature were collected. Calculations were conducted for a full range of quality variation and a wide range of mass velocity. The aim of the study was to test the sensitivity of the in- house developed model....
-
From the pills to environment – Prediction and tracking of non-steroidal anti-inflammatory drug concentrations in wastewater
PublikacjaThe extend of environment pollution by pharmaceuticals is in a stage that required more automatic and integrated solutions. The non-steroidal anti-inflammatory drugs (NSAIDs) are one of the most popular pharmaceutical in the world and emerging pollutants of natural waters. The aim of the paper was to check the correlation of the sales data of selected NSAIDs (ibuprofen, naproxen, diclofenac) and their concentration in the WWTP...
-
Fast and reliable knowledge-based design closure of antennas by means of iterative prediction-correction scheme
PublikacjaA novel framework for expedited antenna optimization with an iterative prediction-correction scheme is proposed. The methodology is comprehensively validated using three real-world antenna structures: narrow-band, dual-band and wideband, optimized under various design scenarios. The keystone of the proposed approach is to reuse designs pre-optimized for various sets of performance specifications and to encode them into metamodels...
-
Estimation and Prediction of Vertical Deformations of Random Surfaces, Applying the Total Least Squares Collocation Method
PublikacjaThis paper proposes a method for determining the vertical deformations treated as random fields. It is assumed that the monitored surfaces are subject not only to deterministic deformations, but also to random fluctuations. Furthermore, the existence of random noise coming from surface’s vibrations is also assumed. Such noise disturbs the deformation’s functional models. Surface monitoring with the use of the geodetic levelling...
-
ADAPTATION OF ENGINEERING FEA-BASED ALGORITHMS TO LCF FAILURE AND MATERIAL DATA PREDICTION IN OFFSHORE DESIGN
PublikacjaThere is an ever growing industrial demand for quantitative assessment of fatigue endurance of critical structural details. Although FEA-based calculations have become a standard in engineering design, problems involving the Low-To-Medium cycle range (101-104) remain challenging. This paper presents an attempt to optimally choose material data, meshing density and other algorithm settings in the context of recent design of the...