Filters
total: 321
filtered: 277
Search results for: THERMAL ENGINEERING
-
Organic Rankine as bottoming cycle to a combined Brayton and Clausius-Rankine cycle
PublicationThis paper presents an enhanced approach, as it will be considered here that the ORC installation could be extra-heated with the bleed steam, a concept presented by the authors. In such way the efficiency of the bottoming cycle can be increased and an amount of electricity generated increases. A thermodynamic analysis and a comparative study of the cycle efficiency for a simplified steam cycle cooperating with ORC cycle will be...
-
Thermoplastic polyurethanes derived from petrochemical or renewable resources: A comprehensive review
PublicationThermoplastic polyurethanes (TPUs) materials are obtained by the reaction of polyol (ether-, ester-, and carbonate-based diols with average molecular weight in the range from 1,000 to 3,000 g/mol) with aliphatic or aromatic diisocyanates. Synthesized materials consist of the hard and soft segments which are separated in different level. All mechanical and thermal properties of TPUs depend on the chemical structure of used monomers,...
-
Physical and Thermophysical Properties of 1-Hexyl-1,4-diaza[2.2.2]bicyclooctanium Bis(trifluoromethylsulfonyl)imide Ionic Liquid
PublicationOwing to their unique properties, ionic liquids (ILs) have become a real alternative to organic compounds. Nowadays, ILs are commonly used in a number of areas such as chemical synthesis and separation techniques. However, ionic liquids continue to have a limited applicability in industry because the information on their physical and chemical properties is not readily available. This paper presents, for the first time, the results...
-
ASSESSMENT OF NATURAL VENTILATION SYSTEM FOR A TYPICAL RESIDENTIAL HOUSE IN POLAND
PublicationThe paper presents the research results of field measurements campaign of natural ventilation performance and effectiveness in a residential building. The building is located in the microclimate whose parameters differ significantly in relation to a representative weather station. The measurement system recorded climate parameters and the physical variables characterizing the air flow in the rooms within 14 days of the winter season....
-
Beeswax And Palmitic Acid Utilization With Heat Pipes For Electronics Cooling
PublicationThis paper presents an experimental study of heat pipes supported by phase change materials (PCMs) coated at their adiabatic sections in application for electronics cooling. The PCMs investigated in this research were palmitic acid and beeswax, the latter being considered as a more cost-effective alternative. The study focused on three powers: 20W, 25W, and 30W. The experimental results revealed that the incorporation of palmitic...
-
Dome over the Gdynia seaport building
PublicationThe paper presents the description of structure and the selected problems of the technical condition, as well as the strength analysis of the thin-walled reinforced concrete shell which has been making a covering of the main hall of the Gdynia Seaport Building through the last 80 years. The rectangle projection of four single curvature shells of the dome was shaped out of mutual perpendicular intersection of two cylindrical shells. The...
-
Fabrication and Study of BiNbO4 Ceramics
PublicationAim of the present research was to fabricate and study crystalline structure as well as dielectric properties of BiNbO4 ceramics. In the present study BiNbO4 ceramics was fabricated by solid state reaction from the mixture of simple oxides viz. Bi2O3, and Nb2O5. Stoichiometric mixture of the powders was thermally analyzed so parameters of the thermal treatment were determined. The EDS measurements proved conservation of the chemical...
-
Synthesis, characteristics, and photocatalytic activity of zinc oxide nanoparticles stabilized on the stone surface for degradation of metronidazole from aqueous solution
PublicationAbstract Background: The presence of antibiotics such as metronidazole in wastewater even at low concentrations requires searching for a suitable process such as advanced oxidation process (AOP) to reduce the level of pollutants to a standard level in water. Methods: In this study, zinc oxide (ZnO) nanoparticles were synthesized by thermal method using zinc sulfate (ZnSO4) as a precursor, then, stabilized on stone and was used...
-
Oxygen vacancy-enriched V2O5·nH2O nanofibers ink for universal substrates-tolerant and multi means-integratable NH3 sensing
PublicationUniversal substrates-tolerant and multi means-integratable ammonia (NH3) sensing is highly desired in future Internet of Things in environmental monitoring, food security and early diagnosis of human diseases, however, is still less than satisfactory. Here, an oxygen vacancy-governed NH3 sensing has been developed with V2O5·nH2O nanofibers (NFs) ink, via combined thermal decomposition of ammonium metavanadate and dilution. As-obtained...
-
Experimental investigation of heat transfer enhancement in straight and U-bend double-pipe heat exchanger with wire insert
PublicationIn this paper, the possibility of heat transfer enhancement in the U-bend exchanger was presented. Experimental research has been carried out for four individual heat exchanger constructions i.e. plain tube in tube, turbulized tube in tube, plain U-bend and U-bend with turbulator. Also, heat transfer experiments for various boundary conditions were performed to obtain reference values. In case of U-bend exchanger with and without...
-
Multi-functional monodispersed SiO2-TiO2 core-shell nanostructure and TEOS in the consolidation of archaeological lime mortars surfaces
PublicationArchaeological traditional lime mortars are susceptible to many environmental conditions such as the impact of water (rain, humidity, groundwater, etc.), variation of temperatures' degrees, wind and/or pollution. Accordingly, this research aims to provide newly assessed multifunctional Nano-coating for the purpose of archaeological lime mortar protection. For this, the study combined physicochemical and mechanical characterizations...
-
Co-simulation strategy of transient CFD and heat transfer in building thermal envelope based on calibrated heat transfer coefficients
PublicationThe paper presents a strategy to develop a fully transient numerical model of a heat transfer in building, using a transient CFD model of indoor air and a thermal envelope model, running in a co-simulation. The strategy relies on the utilization of RANS with a high-Re turbulence model and a wall function, which enables to use a coarse computational mesh limiting the computational time. Since wall functions give invalid heat transfer...
-
Study of thermal property changes of biopol/polyamide 11 blends during biodegradation in compost
Publication -
Dynamic mechanical properties and thermal degradation process of the compositions obtainedfrom unsaturated poly(ester urethanes) cross-linked with styrene
Publication -
DSC Study of Polyurethanes obtained from 4,4'-Bis(10-Hydroxydecaoxy)biphenyl
Publication -
Thermal behavior of the products of 2-chloro-2-propen-1-ol oligomerization
Publication -
The influence of microjet array area ratio on heat transfer in the compact heat exchanger
PublicationThe paper describes the comprehensive study on the effect of microjet array geometrical parameters on the heat transfer enhancement in the modular heat exchanger. The conducted experimental study provides an experimental database on single phase submerged microjet heat transfer. The Wilson plot method was applied to determine the heat transfer coefficients in the laminar and transition flow regimes of a liquid-to-liquid heat exchanger....
-
Natural convection in symmetrically heated vertical channels
PublicationThe study describes natural convection through a vertical channel, open on four sides and bound by two isothermal walls. Both balancing and infrared experimental investigations were performed in air (Pr = 0.71) to estimate the impact of channel width s and wall-to-ambient temperature difference (tw - t∞) on natural convective heat transfer, the formation of air flow patterns and the rate of flow pattern formation. The study was...
-
Experimental investigation of dryout of SES36, R134a, R123 and ethanol in vertical small diameter tubes
PublicationW publikacji przedstawiono wyniki badań eksperymentalnych kryzysu wrzenia typu dryout podczas wrzenia w przepływie czterech czynników (SES36, R134a, R123, alkohol etylowy) w kanałach o średnicy wewnętrznej 1.15 mm i 2.3 mm. Badania przeprowadzono w szerokim zakresie zmian stopnia suchości pary (0.65-1), gęstości strumienia masy (40-900 kg/(m2s)) i gęstości strumienia ciepła (20-220 kW/m2). W badaniach wykorzystano technikę termowizyjną...
-
Numerical analysis by FEM and analytical study of the dynamic thermal behavior of hollow bricks with different cavity concentration
PublicationThis paper presents the investigation results on the influence of the cavity concentration in hollow bricks on static and dynamic thermal parameters: a time lag, a decrement factor, an equivalent thermal diffusivity (ETD) and an equivalent thermal conductivity (ETC). The dynamic thermal behavior of hollow bricks is studied with an optimized cavity shape to reduce the intensity of radiation and convective heat exchange. The thermal...
-
Thermal and physical properties of ZrO2–AlO(OH) nanopowders synthesised by microwave hydrothermal method
PublicationIndustrially relevant nanopowder was synthesised by microwave hydrothermal synthesis to obtain well-controlled composition (ZrO2–AlO(OH) system) which was found to determine a number of physical and thermal characteristics. This study reports variation of particle size, density, specific surface area (SSABET), as well as thermal behaviour of nanopowder mixtures of ZrO2–AlO(OH) in the whole range of compositions. It was found that...
-
Water uptake analysis of acceptor-doped lanthanum orthoniobates
PublicationIn this work, lanthanum orthoniobates doped with either antimony, calcium, or both have been synthesized and studied. The water uptake of the investigated materials has been analyzed by means of thermogravimetric studies. The results show the difference between the thermodynamics of hydration between the lanthanum orthoniobate system and other proton conducting ceramics. The relation between the water uptake and effective acceptor...
-
Synthesis, structure and properties of poly(ether-urethane)s synthesized using a tri-functional oxypropylated glycerol as a polyol
PublicationThe main aim of this work was to obtain poly(ether-urethane)s using tri-functional polyoxyalkylene polyol (Rokopol G1000), which introducing the chemical cross-links into the structure of polyurethanes. Poly(ether-urethane)s were prepared using two-step method, called prepolymer method, which involves in the first step the reaction of 4,4'-diphenylmethane diisocyanate (MDI) and tri-functional polypropylene glycol glycerol triether...
-
Experimental investigations on adiabatic frictional pressure drops of R134a during flow in 5mm diameter channel
PublicationThe article presents detailed two-phase adiabatic pressure drops data for refrigerant R134a at a saturation pressure of 5.5 bar corresponding to the saturation temperature of 19.4 °C. Study cases have been set for a mass flux varying from 100 to 500 kg/m2 s. The frictional pressure drop was characterized for the refrigerant R134a, for vapor qualities ranging from 0 to 1. Long-time thermal stability of test facility allowed to gather...
-
Estimation of microbiological contamination of maize seeds using isothermal calorimetry
Publication -
Using isothermal calorimetry and FT-Raman spectroscopy for step-by-step monitoring of maize seed germination: case study
Publication -
Thermal degradation of poly(alkyl methacrylates)
Publication -
Pyrolysis of poly(2-propylheptyl acrylate)
Publication -
Identification of acrylate copolymers using pyrolysis and gas chromatography
Publication -
Buffer contribution to formation enthalpy of copper(II)–bicine complex determined by isothermal titration calorimetry method
Publication -
Probing the binding selected metal ions and biologically active substances to the antimicrobial peptide LL-37 using DSC, ITC measurements and calculations
Publication -
Thermal degradation of copolymers based on selected alkyl methacrylates
Publication -
Thermal degradation of butyl acrylate-methyl acrylate-acrylic acid-copolymers
Publication -
Study of effect of phosphate and uranium ions on the thermal properties of surfactant-modified natural red clay using TG–FTIR–MS techniques
Publication -
MgO/CaO-loaded porous carbons for carbon dioxide capture
Publication -
Nanosized carbon black as synergist in PP/POE-MA/IFR system for simultaneously improving thermal, electrical and mechanical properties
Publication -
DSC and thermal stability investigation of novel poly(ester-ether) glycolsand poly(ester-ether)urethanes.
PublicationOtrzymano serie nowych poli(estro-etero)dioli z kwasu adypinowgo.........
-
Study of thermal property changes of biopol/polyamide 11 blends during biodegradation in compost.
PublicationPrzeprowadzone badania dotyczą zmian struktury krystalicznej podczas biodegradacji mieszanin polimerowych z udziałem PHBV, gdzie zależność między strukturą a podatnością na biodegradację związane są nie tylko ze stopniem krystaliczności PHBV ale także z budową faz składników mieszaniny. Wyniki pozwalają stwierdzić, że mieszaniny PA11/PHBV zawierające 60% kopoliestru PHBV(otrzymane przy użyciu wytłaczarki dwuślimakowej) charakteryzują...
-
DSC study of polyurethanes obtained from 4,4´bis(10-hydroxydecaoxy) biphenyl.
PublicationW naszych badaniach nad poliuretanami segmentowymi i sztywno segmentowymi, otrzymanymi z 4,4`-bis(6-hydroksyheksyloksy)bifenylu (BHHBP), diizocyjanianu4,4`-dicykloheksylometanu (HMDI) i oligo(adypinianu 1,6-heksylenu) stwierdziliśmy, że poliuretany otrzymane z HMDI o składzie 16% trans, trans-, 52%cis, trans- i 32% cis, cis-HMDI charakteryzują się znacznie niższymi temperaturami przejść fazowych, niż te otrzymane z frakcji...
-
Improvement of the resistance to oxidation of the ecological greases by the additives
Publication -
Modelling relation between oxidation resistance and tribological properties of non-toxic lubricants with the use of artificial neural networks
Publication -
Production of gaseous matrix-free reference materials
Publication -
Thermodynamics, size, and dynamics of zwitterionic dodecylphosphocholine and anionic sodium dodecyl sulfate mixed micelles
Publication -
Hydrothermal, microwave and mechanochemical modification of amorphous zirconium phosphate structure
Publication -
Structural and thermal characteristics of Ni-doped carbosils prepared by mechanochemistry
Publication -
Structural, thermal and energetic characteristics of synthetic active carbons prepared on the basis of ion-exchange resin Amberlite IRC 84
Publication -
Active carbons from waste biochars
Publication -
Swelling effects in cross-linked polymers by thermogravimetry
Publication -
Characteristics of thermal behavior of photoluminescent copolymers studied by the TG/DTG/FTIR coupled method
Publication -
Adsorption and calorimetric studies of hydrothermally modified carbosils
Publication