Filtry
wszystkich: 20206
-
Katalog
- Publikacje 14915 wyników po odfiltrowaniu
- Czasopisma 522 wyników po odfiltrowaniu
- Konferencje 208 wyników po odfiltrowaniu
- Wydawnictwa 1 wyników po odfiltrowaniu
- Osoby 332 wyników po odfiltrowaniu
- Wynalazki 23 wyników po odfiltrowaniu
- Projekty 55 wyników po odfiltrowaniu
- Laboratoria 3 wyników po odfiltrowaniu
- Zespoły Badawcze 1 wyników po odfiltrowaniu
- Aparatura Badawcza 7 wyników po odfiltrowaniu
- Kursy Online 305 wyników po odfiltrowaniu
- Wydarzenia 40 wyników po odfiltrowaniu
- Oferty 1 wyników po odfiltrowaniu
- Dane Badawcze 3793 wyników po odfiltrowaniu
wyświetlamy 1000 najlepszych wyników Pomoc
Wyniki wyszukiwania dla: power%20system%20analysis%20computing
-
A Set of Low-power Microcontroller-based Modules Used for Testing of Small Energy Measurement Methods
PublikacjaEstimation of energy consumption of low-power devices is not widely discussed in the scientific literature, but this topic is getting more and more popular. Evaluation process of newly developed methods and instrumentation requires carefull treatment. In order to fulfill this niche, the set of micro-power microcontroller based devices was proposed. The devices represent typical energy consuption profiles and allow experimental verification...
-
Forecasting values of cutting power for the sawing process of impregnated pine wood on band sawing machine
PublikacjaW artykule przedstawiono prognozowane wartości mocy skrawania dla pilarki taśmowej (ST100R firmy STENNER), które są stosowane w polskich tartakach. Wartości mocy skrawania oszacowano dla drewna sosny zwyczajnej (Pinus sylvestris L.), które zostało poddane impregnacji. Dla porównania wyznaczono również wartości mocy skrawania dla drewna niezaimpregnowanego. Wartości te określono za pomocą innowacyjnej metody prognozowania sił skrawania,...
-
Verification of safety in low-voltage power systems without nuisance tripping of residual current devices
PublikacjaLow-voltage power systems require initial and periodical verification to check the effectiveness of protection against electric shock. As a protection in case of fault, automatic disconnection of supply is most often used. To verify such a protection measure, the earth fault loop impedance or resistance is measured. This measurement is easy to perform in circuits without residual current devices. When residual current devices are...
-
Selection of optimal location and rated power of capacitor banks in distribution network using genetic algorithm
PublikacjaIn this paper, the problem of placement and rated power of capacitor banks in the Distribution Network (DN) is considered. We try to suggest the best places for installing capacitor banks and define their reactive power. The considered formulation requires the optimization of the cost of two different objectives. Therefore the use of properly multiobjective heuristic optimization methods is desirable. To solve this problem we use...
-
A newly-developed model for predicting cutting power during wood sawing with circular saw blades
PublikacjaIn the classical approach, cutting forces and cutting power in sawing processes of orthotropic materials such as wood are generally calculated on the basis of the specific cutting resistance kc (cutting force per unit area of cut). For every type of sawing kinematics (frame saws, band saws and circular sawing machines) different empirical values of specific cutting resistance kc have to be applied. It should be emphasised that...
-
Monitoring Regenerative Heat Exchanger in Steam Power Plant by Making Use of the Recurrent Neural Network
PublikacjaArtificial Intelligence algorithms are being increasingly used in industrial applications. Their important function is to support operation of diagnostic systems. This paper pesents a new approach to the monitoring of a regenerative heat exchanger in a steam power plant, which is based on a specific use of the Recurrent Neural Network (RNN). The proposed approach was tested using real data. This approach can be easily adapted to...
-
On the production of electricity in Poland using a geothermal binary power plant - A thermodynamic overview - Part I
PublikacjaPoland has a significant potential of geothermal energy. However, the high-temperature sources that are needed to drive power plants are found in relatively few places. Therefore, the objective of this paper is to consider any location in the northern part of Poland as a possible place to build a binary power plant. A scientific research was confirmed the existence of an elevated temperature gradient in this region. The hot rocks...
-
Light-Powered Starter for Micro-Power Boost DC–DC Converter for CMOS Image Sensors
PublikacjaThe design of a starter for a low-voltage, micro-power boost DC–DC converter intended for powering CMOS image sensors is presented. A unique feature of the starter is extremely low current, below 1 nA, supplying its control circuit. Therefore, a high-voltage (1.3 V) configuration of series-connected photovoltaic diodes available in a standard CMOS process or a small external LED working in photovoltaic mode can be used as an auxiliary...
-
The power of personal brand authenticity and identification: top celebrity players’ contribution to loyalty toward football
PublikacjaPurpose: In the current era of fake news, illusions, manipulations, and other artificial attributes of virtuality and reality, authenticity is a virtue that people highly appreciate. This study examines the influence of the personal brand authenticity of top football players on loyalty to the football discipline in general, via the mediation of personal brand identification. Design: Based on data collected from a convenience sample...
-
Safety issues referred to induced sheath voltages in high-voltage power cables – case study
PublikacjaLoad currents and short-circuit currents in high-voltage power cable lines are sources of the induced voltages in the power cables’ concentric metallic sheaths. When power cables operate with single-point bonding, which is the simplest bonding arrangement, these induced voltages may introduce an electric shock hazard or may lead to damage of the cables’ outer non-metallic sheaths at the unearthed end of the power cable line. To...
-
SiC-Based Power Electronic Traction Transformer (PETT) for 3 kV DC Rail Traction
PublikacjaThe design of rolling stock plays a key role in the attractiveness of the rail transport. Train design must strictly meet the requirements of rail operators to ensure high quality and cost-eective services. Semiconductor power devices made from silicon carbide (SiC) have reached a level of technology enabling their widespread use in traction power converters. SiC transistors oering energy savings, quieter operation, improved reliability...
-
Modified Inductive Multi-Coil Wireless Power Transfer Approach Based On Z-Source Network
PublikacjaThis article presents a non-conventional approach to a multi-coil wireless power transfer system based on a Z-source network. The novelty of the approach lies in the use of a Z-source as a voltage source for energy transmission through the wireless power transfer coils. The main advantage is in a reduced number of semiconductors. This paper provides the design approach, simulation and experimental study. Feasibility and possible...
-
Influence of Different Biofuels on the Efficiency of Gas Turbine Cycles for Prosumer and Distributed Energy Power Plants
PublikacjaThe efficiency of a gas turbine can be affected by the use of different biofuels usually with a relatively Lower Heating Value (LHV). The paper evaluates the impact of calorific value of fuel on turbine performance and analyzes the possibilities of optimizing turbine construction from the point of view of maximum efficiency for a particular fuel. The several variants of design of small power microturbines dedicated to various biofuels...
-
The impact of the distribution network reconfiguration on active power losses: Selected issues of UPGRID project realization
PublikacjaThe dynamic development of smart grids allows the use of remote controllable switches to change the configuration of the distribution network. The paper discusses the impact of the distribution system reconfiguration on active power losses, taking into account the typical daily load profiles. Based on modified IEEE 33-bus test distribution system the article presents the method of selection the appropriate sensitivity factor and...
-
Modeling and Simulation for Exploring Power/Time Trade-off of Parallel Deep Neural Network Training
PublikacjaIn the paper we tackle bi-objective execution time and power consumption optimization problem concerning execution of parallel applications. We propose using a discrete-event simulation environment for exploring this power/time trade-off in the form of a Pareto front. The solution is verified by a case study based on a real deep neural network training application for automatic speech recognition. A simulation lasting over 2 hours...
-
Designing a magnetoacoustic emission measurement configuration for measurement of creep damage in power plant boiler tubes
PublikacjaOpisywane są własności skonstruowanego detektora emisji magneto-akustycznej (EMA) służącego dla pomiaru stopnia degradacji rurociągów w przemyśle energetycznym. Specjalna budowa biegunów magnesu umożliwia ich dopasowanie do zakrzywionych powierzchni. Układ pomiarowy pozwala na badanie natężenia EMA dla pola wzdłuż osi rury, a także w kierunku obwodowym. Wykazano, iż możliwa jest detekcja zmiany stopnia degradacji materiału na obwodzie...
-
A model of combined heat and power generating plant with urban heat distribution network for production scheduling
PublikacjaPoruszono zagadnienie związane z pracowaniem harmonogramu produkcji elektrociepłowni. Uwzględniony został wpływ zachowania się miejskiej sieci ciepłowniczej na pracę elektrociepłowni. Możliwe jest również modelowanie współpracy ze zbiornikiem ciepła.
-
Podsystem wizualizacji w adaptacyjnym synchronizatorze prądnic =The vizualizzation subsystem of adaptabile synchronizer of power generators
PublikacjaZamieszczono opis podsystemu wizualizacji układu automatycznej synchronizacji układu autopmatycznej synchronizacji prądnic pracującego wg opracowanej adaptacyjnej metody synchronizacji. Zawarto synchronizacje dot. zadań podsystemu wizualizacji wraz z prezentacją wybranych okien graficznego interfejsu uzytkownika. Omówiono również sposób realizacji podsystemu wizualizacji. Zwrócono uwagę na znaczenie i rolę dobrze zorganizowanej...
-
Realizacja stanowiska badawczego synchronizacji obiektów elektroenergetycznych = The realization of the reserch station of synchronazing power generators
PublikacjaW artykule opisano sposób realizacji układu automatycznej synchronizacji obiektów elektroenergetycznych pracującego według opracowanej metody. Skupiono się na opisie sposobu praktycznej realizacji układu, nie zaś na opisie samej metody synchronizacji, której opis można znaleźć w podanych w przypisach pozycjach literaturowych. Dokonano charakterystyki stanowiska badawczego z podaniem wymagań oraz wyróżnieniem poszczególnych składowych...
-
Evaluation of quality of electric power distribution network elements in order to maintain functional and technical safety
PublikacjaPraca dotyczy wieloatrybutowego systemu oceny elementów sieci elektroenergetycznej do celów zapewnienia jej bezpieczeństwa funkcjonalnego i technicznego. Rozważana sieć składa się z dużej liczby elementów, ocenianych jakościowo i ilościowo. Zaproponowana metoda składa się z dwóch etapów: (i)wstępnego wyboru niewielkiej liczby elementów niebezpiecznych w oparciu o małą liczbę informacji (ii) wykonaniu uszeregowania wybranych elementów...
-
On the independence number of some strong products of cycle-powers
PublikacjaIn the paper we give some theoretical and computational results on the third strong power of cycle-powers, for example, we have found the independence numbers alpha((C^2_10)^⊠3) = 30 and alpha((C^4 _14)^⊠3) = 14. A number of optimizations have been introduced to improve the running time of our exhaustive algorithm used to establish the independence number of the third strong power of cycle-powers. Moreover, our results establish...
-
Robert Bogdanowicz dr hab. inż.
OsobyRobert Bogdanowicz received his Ph.D. degree with honours in Electronics from the Gdansk University of Technology. He worked as a post-doc researcher in Ernst-Moritz-Arndt-Universität Greifswald Institut für Physik. He has initiated optical emission imaging of muti-magnetron pulsed plasma and contributed to the development of antibacterial implant coatings deposited by high-power impulse magnetron sputtering. He moved back to...
-
Foundations of Computing and Decision Sciences
Czasopisma -
Scalable Computing: Practice and Experience
Czasopisma -
Advances in Intelligent Systems and Computing
Czasopisma -
WIRELESS COMMUNICATIONS & MOBILE COMPUTING
Czasopisma -
INTERNATIONAL JOURNAL OF AUTOMATION AND COMPUTING
Czasopisma -
Journal of Computing in Higher Education
Czasopisma -
International Journal of Architectural Computing
Czasopisma -
International Journal of Semantic Computing
Czasopisma -
Journal of Grid and Distributed Computing
Czasopisma -
IEEE Transactions on Affective Computing
Czasopisma -
IEEE Transactions on Services Computing
Czasopisma -
ACM Transactions on Parallel Computing
Czasopisma -
IEEE Transactions on Cloud Computing
Czasopisma -
ACM Transactions on Accessible Computing
Czasopisma -
Sustainable Computing-Informatics & Systems
Czasopisma -
ICTACT Journal on Soft Computing
Czasopisma -
Journal of High Performance Computing
Czasopisma -
Journal of Applied Mathematics and Computing
Czasopisma -
ACM Transactions on Computing Education
Czasopisma -
International Journal of Reconfigurable Computing
Czasopisma -
JOURNAL OF CLINICAL MONITORING AND COMPUTING
Czasopisma -
Baltic Journal of Modern Computing
Czasopisma -
IEEE ANNALS OF THE HISTORY OF COMPUTING
Czasopisma -
Service Oriented Computing and Applications
Czasopisma -
Mobile Computing and Communications Review
Czasopisma -
Journal of Computing and Information Technology
Czasopisma -
Statistics, Optimization and Information Computing
Czasopisma -
International Journal of Cloud Computing
Czasopisma