Filters
total: 27088
filtered: 6212
displaying 1000 best results Help
Search results for: STRAT AND TIE METHOD
-
Application of shifted Chebyshev polynomial-based Rayleigh–Ritz method and Navier’s technique for vibration analysis of a functionally graded porous beam embedded in Kerr foundation
PublicationPresent study is dealt with the applicability of shifted Chebyshev polynomial based Rayleigh-Ritz method and Navier’s technique on free vibration of Functionally Graded (FG) beam with uniformly distributed porosity along the thickness of the beam. The material properties such as Young’s modulus, mass density, and Poisson’s ratio are also considered to vary along the thickness of the FG beam as per the power-law exponent model....
-
Production and Properties of the Porous Layer Obtained by the Electrochemical Method on the Surface of Austenitic Steel
Publication: The growing demand for implants has seen increasing interest in the introduction of new technologies and surface modification methods of metal biomaterials. This research aimed to produce and characterize a porous layer grown on austenitic stainless steel 316L, obtained via the anodization process near the micro-arc oxidation, i.e., low voltage micro-arc oxidation (LVMAO). The discussed layer significantly influences the properties...
-
Experimental tuning of AuAg nanoalloy plasmon resonances assisted by machine learning method
PublicationPlasmonic nanostructures based on AuAg nanoalloys were fabricated by thermal annealing of metallic films in an argon atmosphere. The nanoalloys were chosen because they can extend the wavelength range in which plasmon resonance occurs and thus allow the design of plasmonic platforms with the desired parameters. The influence of initial fabrication parameters and experimental conditions on the formation of nanostructures was investigated....
-
TEST METHOD FOR DETERMINING THE CHEMICAL EMISSIONS OF A MARINE DIESEL ENGINE EXHAUST IN OPERATION
PublicationThe article briefly describes the problem of air pollution caused by sea-going ships and the resulting restrictions on the emission of toxic and harmful chemical compounds in the exhaust of marine engines, introduced by the International Maritime Organization (IMO) under the International Convention for the Prevention of Sea Pollution from Ships (MARPOL 73/78). Such emissions provide a significant metrological problem, not only...
-
OCCUPATIONAL RISK ASSESSMENT USING THE RISK SCORE METHOD DURING GEODETIC MEASUREMENTS
Publication -
Influence of the analyzing window on electrode impedance measurement by the continuous frequency scanning method
Publication -
Digital image correlation method: a versatile tool for engineering and art structures investigations
Publication -
Application of Hybrid FEM-DIC Method for Assessment of Low Cost Building Structures
Publication -
Experimental method to evaluate the load-carrying capacity of double corrugated sheet profiles
Publication -
The operational method of filling information gaps in satellite imagery using numerical models
Publication -
Identification of Non-Stationary Magnetic Field Sources Using the Matching Pursuit Method
Publication -
Mercury fractionation in marine macrofauna using thermodesorption technique: Method and its application
Publication -
Application of the Fröbenius method to the Schrödinger equation for a spherically symmetric potential: an anharmonic oscillator
Publication -
New supervised alignment method as a preprocessing tool for chromatographic data in metabolomic studies
Publication -
Development and validation of GC–MS/MS method useful in diagnosing intestinal dysbiosis
Publication -
Development of a digital method for neutron/gamma-ray discrimination based on matched filtering
Publication -
The method of improving the dynamic range of jitter analyzers in optical-fiber transmission systems
Publication -
Effect of extraction method on the yield of furanocoumarins from fruits ofArchangelica of?cinalis Hoffm.
Publication -
The method of multispectral image processing of phytoplankton processing for environmental control of water pollution
Publication -
A method for detecting possible near miss ship collisions from AIS data
Publication -
Method for Determination of Methyl tert-Butyl Ether and Its Degradation Products in Water
Publication -
SEM investigations of the mechanism of formation and growth of nanohydroxyapatite layers coated with ultrasonic method
Publication -
New method of fractional order integrator analog modeling for orders 0.5 and 0.25
Publication -
Assessment of hardened layer thickness for 40HNMA steel using eddy current method
Publication -
Simulation Method for Scheduling Linear Construction Projects Using the Learning– Forgetting Effect
Publication -
Effect of preparation method on the properties of potato starch acetates with an equal degree of substitution
Publication -
Using the AHP Method to Select an Electronic Documentation Management System for Polish Municipalities
Publication -
Searching for space-time clusters: The CutL method compared to Kulldorff’s scan statistic
Publication -
Measurement of ethylene production as a method for determining the optimum harvest date of ‘Jonagored’ apples
Publication -
The Influence of Input Data Standardization Method on Prediction Accuracy of Artificial Neural Networks
Publication -
A new method for preparation of rutile phase titania photoactive under visible light
Publication -
A new deterministic method of finding safe ship trajectory for any convex domain
PublicationW artykule wprowadzono nową deterministyczną metodę wyznaczania bezpiecznej trajektorii statku dla sytuacji spotkania z wieloma obiektami obcymi i dla dowolnej zadanej domeny. Jej prostota i fakt, że minimalizuje ona liczbę manewrów czynią ją dobrą alternatywą dla obecnie stosowanych metod. Metoda jest przedstawiona tak, aby mogła być bezpośrednio zastosowana w pokładowych systemach antykolizyjnych lub w systemach VTS.
-
Influence of the method of the control of the hybrid contactless short-circuit limiter on power quality
PublicationW artykule przedstawiono wpływ sterowania bezstykowego ogranicznika prądów zwarciowych na ograniczanie zapadów napięcia. Scharakteryzowano podstawowe własności ogranicznika oraz układu sterowania jego pracą. Ponieważ prąd zwarciowy jest detekowany przez dedykowany superkrótki bezpiecznik sterowanie musi być dostosowane do czasu przedrukowego i łukowego topika, które zależą od aktualnej wartości prądu i aktualnej konfiguracji obwodu....
-
Modeling of a rock fall using the discrete element method and study of the seismic signal
PublicationW artykule przedstawiono opis fal sejsmicznych, zastosowanie dyskretnej metody elementów do opisu obrywu skalnego, opis programów obliczeniowych oraz obliczenia numeryczne wg. podanych programów obliczeniowych.
-
A new hybrid method for analysis of scattering from arbitrary configuration of cylindrical objects
PublicationArtykuł opisuje nową hybrydową metodę analizy rozpraszania fali elektromagnetycznej od obiektów cylindrycznych o dowolnym przekroju poprzecznym. W prezentowanym podejściu każdy obiekt jest traktowany jako efektywny cylinder o przekroju kołowym, opisany przez macierz impedancyjną. W celu uzyskania owej macierzy zastosowano połączenie metod różnic skończonych w dziedzinie częstotliwości (FDFD) i dopasowania rodzajów (MM). W celu...
-
A method for selection of parameters of ship propulsion system fitted with compromise screw propeller
PublicationArtykuł dotyczy algorytmicznej metody wstępnego doboru parametrów układu napędowego okrętu wyposażonego w śrubę o skoku stałym, gdy eksploatacja okrętu związana jest z istotnymi zmianami: głębokości i szerokości drogi wodnej, oporu kadłuba i prędkości marszowej. Argumentami modelu matematycznego rozważanego zagadnienia projektowego są identyfikowane na etapie projektowania wstępnego główne parametry projektowe okrętu. Struktura...
-
Validation of dimensionless method using height average wind velocity for wind forces
Publication -
Effect of extraction method on the antioxidative activity of ground elder (Aegopodium podagraria L.)
Publication -
Problems of PAH quantification by GC–MS method using isotope-labelled standards
Publication -
Assessment of the Effects of Wastewater Treatment Plant Modernization by Means of the Field Olfactometry Method
Publication -
Fabrication Of Scaffolds From Ti6Al4V Powders Using The Computer Aided Laser Method
Publication -
Solving boundary value problems for delay differential equations by a fixed-point method
PublicationOgólne liniowe zagadnienie brzegowe dla nieliniowego układu równań różniczkowych z opóźnieniem jest redukowane do zagadnienia o punkcie stałym odpowiedniego operatora a następnie poszukiwany punkt stały tego operatora jest przybliżany funkcją kawałkami liniową zdefiniowaną poprzez jej wartości w węzłach. Przy odpowiednich założeniach istnienie tego punktu stałego jest równoważne istnieniu tzw. epsilon przybliżonych punktów stałych...
-
Adjusted subpixel method enables optimisation of bronchial measurements in high-resolution CT
PublicationArtykuł przedstawia metodę korekcji pomiaru rozmiaru oskrzeli w techice HRCT. W celu walidacji metody zastosowano fantom. W efekcie opracowano metodę nieliniowej predykcji rzeczywistych rozmiarów ścianek małych oskrzeli w obrazach HRCT.
-
Application of extended Finite Element Method to cracked concrete elements - numerical aspects
PublicationArtykuł omawia zastosowanie rozszerzonej metody elementów skończonych do zarysowanych elementów betonowych. Obliczenia wykonano dla elementów poddanych zginaniu i mieszanemu ściskaniu - rozciąganiu. Wyniki porównano z doświadczeniami.
-
Ab initio studies of phonons in MgO by the direct method including LO mode
Publication -
FEM (Finite Element Method) Numeric Analyses of the Syrenka S201 Car Model
Publication -
The Use of Stem Cells as a Potential Treatment Method for Selected Neurodegenerative Diseases: Review
Publication -
A simple method for selection of trypsin chromogenic substrates using combinatorial chemistry approach
Publication -
Green method of conversion of geraniol to value-added products in the presence of selected minerals
Publication -
A Reference Point Method to Triple-Objective Assignment of Supporting Services in a Healthcare Institution
Publication