Filtry
wszystkich: 5302
-
Katalog
- Publikacje 3915 wyników po odfiltrowaniu
- Czasopisma 191 wyników po odfiltrowaniu
- Konferencje 5 wyników po odfiltrowaniu
- Osoby 104 wyników po odfiltrowaniu
- Projekty 6 wyników po odfiltrowaniu
- Zespoły Badawcze 1 wyników po odfiltrowaniu
- Kursy Online 134 wyników po odfiltrowaniu
- Wydarzenia 20 wyników po odfiltrowaniu
- Oferty 1 wyników po odfiltrowaniu
- Dane Badawcze 925 wyników po odfiltrowaniu
wyświetlamy 1000 najlepszych wyników Pomoc
Wyniki wyszukiwania dla: PLANE FRAMES
-
Impact analysis of surface roughness of the plate-plate measuring system on resistance torque in interaction with MR fluid
PublikacjaMagnetorheological (MR) fluids are complex suspensions of magnetic particles in a non-magnetic carrier fluid. They exhibit ‘smart’ properties that enable them to change their rheological parameters in response to a change in the external magnetic field applied. This behavior is used in some engineering solutions, e.g. MR clutches or brakes. For such systems to work correctly, the resistance torque achieved by contact with the...
-
Noise modeling of static CMOS gates for low-noise circuit synthesis
PublikacjaW artykule przedstawiono efektywną metodę modelowania widma szumu napięcia zasilającego generowanego przez statyczne bramki cyfrowe CMOS. Metoda modelowania uwzględnia krótkie impulsy prądowe powstające w czasie przełączania bramek i pozwala oszacować górne limity widma szumu napięcia zasilającego co umożliwia niskoszumową syntezę układów cyfrowych.
-
Non-Linear Analysis of Inter-Story Pounding between Wood-Framed Buildings during Ground Motion
PublikacjaPounding between adjacent buildings during ground motion may result in structural damage or lead to total destruction of structures. The research on the phenomenon has recently been much advanced; however, the analyses have been carried out only for concrete, steel, and masonry structures, while pounding between wooden buildings has not been studied so far. The aim of this paper is to show the results of detailed non-linear seismic...
-
A Comparative Numerical Simulation Study of Turbulent Non-premixed CO/H2/N2 Syngas Jet Flames
PublikacjaIn the present work, numerical simulations of turbulent non-premixed syngas flame have been performed in Reynolds-Averaged Naver-Stokes turbulence approach using four turbulence-chemistry interaction models. To this aim, we used assumed beta PDF approach, Steady Laminar Flamelet model, Eddy Dissipation Concept and Partially Stirred Reactor model. Numerical results are compared and analysed with respect to two experiments from the...
-
Place Attachment and Collective Action Tendency
PublikacjaThree studies were carried out to examine how place attachment and collective action tendency are related and what role self-expansion and social interactions play in this relationship. In the first study (N = 156) we found that a more active form of attachment – place discovered – is a significant predictor of tendency to engage in collective action in favor of one’s neighborhood. In the second study (N = 197), we focused on...
-
A place of school in the idea of the sustainable development
PublikacjaWell designed school space enables social contacts, increases activity of pupils and improves the condition of their health. However, the best design would not bring the expected benefits if it is not integrated with the surroundings in terms of transportation, security and local needs. In the sustainable development, the social goals are in harmony with ecological aims according to the rule of "3 r" (reduce, reuse, recycle).
-
Variable speed small hydropower plant
Publikacja -
Anaerobic bacteria in wastewater treatment plant
Publikacja -
EVALUATION OF CAUSES OF CORROSION OF PLATE HEATEXCHANGER
PublikacjaPrzeprowadzono analizę zniszczeń korozyjnych wykrytych na płycie wymiennika ciepła stosowanego do chłodzenia silnika głównego statku. Stwierdzono obecność wżerów korozyjnych oraz korozji szczelinowej. Przedstawiono możliwe przyczyny wystąpienia w.w. uszkodzeń.
-
Rendering planet w czasie rzeczywistym
PublikacjaArtykuł ten ma za cel przedstawić techniki dynamicznego tworzenia i renderowania planet. Opisuje on sposoby, dzięki którym można z dowolnym stopniem dokładności przedstawiać powierzchnię planety w czasie rzeczywistym, używając do tego celu takich technik, jak megateksturing, dynamiczny poziom dokładności i inne.
-
A multistage turbine for a micro power plant
PublikacjaThis paper presents results of a design analysis of a multi-stage turbine for the cogeneration micro-power plant working in accordance with Organic Rankine Cycle (ORC). The heat power of the plant is assumed equal to 20 kW and the corresponding available electric output is estimated to be of about 3 kW. Different variants of the radial and axial-flow turbines have been considered, while the detailed results of the calculations...
-
Kazimierz Market Place. Akwarela 38x56cm
PublikacjaL'acquerello in Alessandria, la mostra internazionale patrocinata dal Comune e dalle Provincia di Alessandria, dalla Regione Piemonte e dal Comune di Vignale e organizzata dall'Associazione italiana acquerellisti. L'esposizione, circa 150 acquerelli dei socie Aia e di artisti provenienti da Australia, Belgio, Brasile Polonia e Spagna per presentare le principali tecniche dell'acquerelli e le diverse concezioni artistiche e stilistiche...
-
Study of a plate modelling a dock gate
Publikacja -
Polish experience with cold in-place recycling
PublikacjaDeep cold in-place recycling using cement and asphalt emulsion has been used for reconstruction of existing roads since the beginning of the 1990s. This paper describes the first Polish requirements for mineral-cement-emulsion mixtures. As requirements stated for the strength of the mineral-cement-emulsion mixtures were quite high, most of the mixtures were designed using high amount of cement and aggregate added for the improvement...
-
Numerical simulation of hardening of concrete plate
PublikacjaThe paper presents a theoretical formulation of concrete curing in order to predict temperature evolution and strength development. The model of heat flow is based on a well-known Fourier equation. The numerical solution is implemented by means of the Finite Difference Method. In order to verify the model, the in situ temperature measurements at the top plate of a road bridge were carried out. A high agreement between numerical...
-
Oxylipins in Plant Protection/Disease Management
Publikacja -
Pumped-storage power plant Żarnowiec.
PublikacjaPrzedstawiono historię budowy, główne zadania i parametry techniczne elektrowni szczytowo-pompowej w Żarnowcu
-
Experimental study on plate modal parameters
PublikacjaTest doświadczalny jest częścią systemu diagnostycznego. Autorzy badają wpływ dodatkowej masy na parametry modalne wolno popartej stalowej płytyi. Artykół przedstawia technikę wyznaczania parametrów modalnych dla systemów monitorowania konstrukcji.The experimental test introduced in the paper is the part of the diagnostic system. The authors investigate the influence of the additional mass on modal parameters of simply supported...
-
Hydraulic power plant on the Radunia River
Publikacjaprzedstawiono rys historyczny, paramerty techniczne i walory turystyczne elektorwni wodnych.
-
Numerical Analysis of a Steel Frame Building with Soft-storey Failure under Ground Motion Excitation
PublikacjaThe aim of this paper is to show the results of a numerical analysis focused on the behaviour of multi-storey steel frame building that suffers from a soft-storey failure under ground motion excitation. A numerical model of the structure was created in FEM computer software and was exposed to an impact that would have been generated after a soft-storey failure due to falling of the upper floors. During the analysis, the whole structure...
-
CONSTRUCTION TECHNOLOGY OF TIMBER-FRAME HOUSES RESISTANT TO DYNAMIC LOADS – STUDY ON MODELS OF EXTERIOR WALLS
PublikacjaThe aim of this paper is to show the numeric representation of experimental studies concerning the behaviour of exterior wall models of a timber-frame house under harmonic loading. A single wall model according to traditional technology of timberframe house walls (filling with mineral wool) was tested. The analysis was conducted for the following frequencies: 0.5 Hz, 1.0 Hz, 2.0 Hz and 5.0 Hz for various values of the specified...
-
Washboarding during cutting on frame sawing machines II. Experimental study of the saw blade behaviour
PublikacjaPraca jest swego rodzaju suplementem do referatu przedstawianego na 15th Inernational Wood Machining Seminar w Los Angeles, CA, USA. Opisano uzyskane wyniki badań doświadczalnych prowadzonych w oparciu o plan badań Hartley`a.Czynnikami badanymi były: naprężenia napinające brzeszczotu piły, częstotliwość skoków ramy piłowej oraz wysokość cięcia przedmiotu obrabianego. Czynnikami wynikowymi były: wysokość sfalowania powierzchni oraz...
-
Timber-frame house resistant to dynamic loads - analysis of wall panel filled with polyurethane foam
PublikacjaThe present study shows the experimentally and numerically determined response of a single timber-frame house wall panel filled with polyurethane (PU) foam under dynamic loads. The harmonic tests were conducted for the following frequencies: 0.5 Hz, 1.0 Hz, 2.0 Hz and 5.0 Hz for various values of the specified displacement. Based on the results of the comparison between the experimental tests and the numerical analyses, the numerical...
-
Comparison of the fracture toughness of pine wood determined on the basis of orthogonal linear cutting and frame sawing
PublikacjaIn this paper, the values of the fracture toughness of Scots pine determined by cutting tests are presented. The cutting tests were carried out using the samples of Scotch pine (Pinus sylvestris L.) from Pomeranian Region, Poland. These experiments were carried out on two research stands: orthogonal linear cutting tests were conducted using the microtome instrument and the frame saw PRW-15M was used for sawing tests. The values...
-
Analysis of surface roughness of chemically impregnated Scots pine processed using frame-sawing machine
PublikacjaThe objective of this work was to evaluate the effect of the impregnation process of pine wood (Pinus sylvestris L.) on roughness parameters of the surface processed on a frame sawing. The samples weredried and impregnated using a commercial procedure by a local company. The touch method withthe use of measuring stylus (pin) was employed to determine of surface roughness of the samplesconsidering parameters, namely, arithmetical...
-
Effective one-band Hamiltonian for the copper-oxygen plane in the superconducting copper oxides
Publikacja -
Damage detection of a T-shaped panel by wave propagation analysis in the plane stress
PublikacjaW pracy zaprezentowano podejście obliczeniowe do analizy propagacji fal w płaskim stanie naprężenia. Problem brzegowo-początkowy podlega przestrzennej aproksymacji z użyciem wielowęzłowych, izoparametrycznych, czworobocznych elementów klasy C0. Macierze elementowe są całkowane numerycznie za pomocą kwadratury Gauss-Legendre-Lobatto. Aproksymację w dziedzinie czasu wykonano za pomocą algorytmu Newmarka. Symulacje numeryczne przeprowadzono...
-
Preoperative Ultrasonographic Assessment of the Anterior Pelvic Plane for Personalized Total Hip Replacement
Publikacja -
A general theory for anisotropic Kirchhoff–Love shells with in-plane bending of embedded fibers
PublikacjaThis work presents a generalized Kirchhoff–Love shell theory that can explicitly capture fiber-induced anisotropy not only in stretching and out-of-plane bending, but also in in-plane bending. This setup is particularly suitable for heterogeneous and fibrous materials such as textiles, biomaterials, composites and pantographic structures. The presented theory is a direct extension of classical Kirchhoff–Love shell theory to incorporate...
-
Effect of fabric anisotropy on shear localization in sand during plane strain compression
PublikacjaW artykule przedstawiono wyniki numerycznej wpływu anizotropii strukturalnej w materiałach granulowanych na powstawanie lokalizacji odkształceń. Obliczenia wykonano dla ściskania w płaskim stanie odkształcenia stosując metodę elementów skończonych na bazie mikropolarnego modelu hipoplastycznego.
-
Miejscowy plan zagospodarowania przestrzennego
PublikacjaPublikacja kierowana jest do Czytelników zainteresowanych zagadnieniami planowania przestrzennego na poziomie gminnym, ładem przestrzennym i rozwojem zrównoważonym. W monografii zaprezentowano aktualne problemy związane z dokumentem planistycznym, jakim jest miejscowy plan zagospodarowania przestrzennego. Omówiono zasady opracowania tego dokumentu w kontekście przepisów prawnych, zawartości merytorycznej i problemów edycyjnych....
-
Development of fragility curves in adjacent steel moment-resisting frames considering pounding effects through improved wavelet-based refined damage-sensitive feature
PublikacjaFragility curves present useful information related to earthquake-induced probability assessment of steel moment-resisting frames (MRFs) and determine the probability of the damage exceedance at different floor levels of MRFs. The review of the literature shows that most of the previous studies dealing with the fragility curves were based on conventional measures, such as spectral acceleration at the first mode period, peak...
-
Plan Journal
Czasopisma -
Plan Canada
Czasopisma -
Nicotinamide phosphoribosyltransferase expression in thyroid glands of patients with Graves' disease
Publikacja -
Upcycling Waste Polypropylene into Graphene Flakes on Organically Modified Montmorillonite
Publikacja -
A concept for reducing PM 10 emissions for car brakes by 50%
PublikacjaWith regard to airborne particles with an aerodynamic diameter of less than 10 μm (PM10), in countries in the European Union, the mass of brake emissions equals approximately 8–27% of the total traffic-related emissions. Using a research methodology combining tests at different scale levels with contact mechanics simulations and PM10 chemical characterization, the REBRAKE EU-financed project had the following aims: i) to demonstrate...
-
Modelling and Analysis of the Positioning Accuracy in the Loading Systems of Mobile Cranes
PublikacjaIn this work, the authors analyse the influence of the order and range of sequential movements of a crane's working members on the accuracy of the final cargo positioning. The analysis was conducted on the basis of a specially developed method in which the authors proposed the introduction of a geometrical indicator of positioning the load in the intermediate positions (after completing each movement sequence) and in the target...
-
James Joyce Quarterly
Czasopisma -
Dynamic Games and Applications
Czasopisma -
Names: A Journal of Onomastics
Czasopisma -
Henry James Review
Czasopisma -
Games for Health Journal
Czasopisma -
JMIR Serious Games
Czasopisma -
Journal of Dynamics and Games
Czasopisma -
GAMES AND ECONOMIC BEHAVIOR
Czasopisma -
Actualidad Contable Faces
Czasopisma -
IEEE Transactions on Games
Czasopisma -
De Vrije Fries
Czasopisma -
James Baldwin Review
Czasopisma