Search
Filters
total: 257
filtered: 244
Search results for: protective systems
-
Quantification of interlayer adhesion in protective coating systems using impedance spectroscopy
PublicationNowoczesne systemy powłokowe stosowane w praktyce są wielowarstwowe. Potencjalnie słabymi obszarami z punktu widzenia właściwości ochronnych są obszary międzywarstwowe. Osiągnięcie odpowiedniej przyczepności pomiędzy warstwami pozwala na polepszenie zdolności ochronnych całego zestawu. Tradycyjne metody pomiaru adhezji międzywarstwowej są destrukcyjne. Zaproponowano nową metodę oceny przyczepności międzywarstwowej przy użyciu...
-
Assessment of protective properties of rubber lining in absorbers of flue gas desulphurization systems.
PublicationResults of research on degradation of rubber lining which is the main protection of absorbers in flue gas desulphurization (FGD) systems were presented. The power plant where the system operated is lignite-fired. Owing to measurements using electrochemical impedance spectroscopy and gravimetric determination of water content in the lining, the areas of the system which are most exposed to degradation were shown. The results obtained...
-
Degradation of protective coatings in steel chimneys of flue gas desulfurisation system
PublicationThis paper presents problems associated with corrosion of steel stacks and changes in philosophy of corrosion protection when implemented into flue gas desulphurization systems. In-situ tests were taken by means of electrochemical impedance spectroscopy at the stack which discharges flue gas before wet lime/limestone desulphurization. A very quick electrolyte absorption by the spherical infill vinylester coating was found using...
-
Non-destructive inspection of anti-corrosion protective coatings using optical coherent tomography
PublicationW artykule przedstawiono zastosowanie optycznej tomografii koherentnej (OCT) do badania antykorozyjnych powłok ochronnych. Omówiono właściwości optycznej interferometrii niskokoherentnej jako zastosowanej metody pomiarowej, opisano budowę pomiarowego systemu OCT, zbudowanego w Katedrze Metrologii i Optoelektroniki WETI PG. Przy pomocy zrealizowanego systemu przebadano grupę powierzchni metalicznych pokrytych różnymi powłokami antykorozyjnymi....
-
Effect of the let-through energy of overcurrent protective devices on the temperature of conductors during short-circuits
PublicationThe scope of the verification of low-voltage systems covers the earth fault loop impedance measurement. This measurement is usually performed with the use of low-value current meters, which force a current many times lower than the one occurring during a real short-circuit. Therefore, the international standard recommends consideration of the increase of resistance of conductors with the increase of temperature, which may occur...
-
Flexible Knowledge–Vision–Integration Platform for Personal Protective Equipment Detection and Classification Using Hierarchical Convolutional Neural Networks and Active Leaning
PublicationThis work is part of an effort to develop of a Knowledge-Vision Integration Platform for Hazard Control (KVIP-HC) in industrial workplaces, adaptable to a wide range of industrial environments. The paper focuses on hazards resulted from the non-use of personal protective equipment (PPE). The objective is to test the capability of the platform to adapt to different industrial environments by simulating the process of randomly selecting...
-
The influence of the motor filtrers on harmonic current emmision in the pro-ective connection of drive systems.
PublicationThis paper contains detailed analysis of currents in protective wire in engine supplied from frequency converter without any external filters added. It was found that the peak value of current in protective conductor of engine was about 1500 mA at frequencies 5 Hz 50 Hz. In the continuation of research the dU/dt type motor filter and the sinusoidal filter were tested. It was found that the current in protective wire decreased...
-
USE OF PERSONAL PROTECTIVE EQUIPMENT
Publication -
High voltage protective assembly.
PublicationW referacie opisano zestaw zabezpieczeniowy, składający się z bezpiecznika i ogranicznika przepięć, przeznaczony dla napowietrznych słupowych stacji transformatorowych średnich napięć. Zastosowany warystorowy ogranicznik przepięć spełnia jednocześnie rolę wspornika dla bezpiecznika gazowydmuchowego. W referacie przedstawiono budowę, podstawowe parametry, przykłady zastosowania oraz wyniki badań zwarciowych zestawu.
-
Diamond-based protective layer for optical biosensors
PublicationOptical biosensors have become a powerful alternative to the conventional ways of measurement owing to their great properties, such as high sensitivity, high dynamic range, cost effectiveness and small size. Choice of an optical biosensor's materials is an important factor and impacts the quality of the obtained spectra. Examined biological objects are placed on a cover layer which may react with samples in a chemical, biological...
-
Construction of Filtering Respiratory Protective Devices
Publication -
Selection of Organic Coating Systems for Corrosion Protection of Industrial Equipment
PublicationThe most important element of corrosion protection in industrial conditions is the protective coating system. However, selecting the right coating can often be a real problem due to the sheer number of coating manufacturers and their products on the market. A quantitative approach based on the data mining technique used to analyze the obtained multi-site exposure data has been proposed. This was demonstrated by the example of the...
-
Protective coatings for stainless steel for SOFC applications
PublicationW pracy przedstawiono badania związane z warstwami antykorozyjnymi stali nierdzewnych stosowanych w tlenkowych ogniwach paliwowych. Warstwy przygotowana z użyciem prekursorów polimerowych na bazie Y i Co. Użyta stal to Crofer 22 APU.
-
Basic Test Methods of Respiratory Protective Devices
Publication -
Workplace Survey of Cold Protective Glove Aging
Publication -
Evaluation of organic coating systems for corrosion protection of industrial equipment using impedance spectroscopy
PublicationThe high economic impact of corrosion can be reduced by enhanced corrosion management and prevention based on appropriate means. This applies in particular to the protection of structures with organic protective coatings. Steel is subject to corrosion that reduces its service life and leads to destruction in most severe cases. The application of paints to metallic objects for corrosion control has been known for a long time and...
-
Immunogenic and protective activity of recombinant chimeric Toxoplasma gondii proteins
PublicationToxoplasmosis, one of the most common parasitic invasions worldwide, may pose a great threat for individuals with weakened immune system. The parasite also causes considerable economic losses due to infection of livestock. To date there is no efficient immunoprophylaxis for humans and animals, which would provide long-lasting protection against T. gondii invasion. Chimeric proteins, containing several selected fragments of parasite...
-
MnCo2O4 deposited by spray pyrolysis as a protective layer for stainless steel interconects
PublicationStainless steel interconnects working in Solid Oxide Fuel Cells stacks are exposed to high temperature resulting in their corrosion. Protective layers for the hydrogen and oxygen sides are necessary to protect the interconnect material, prolongate the stack lifetime and maintain the output power. In this paper MnCo2O4 protective layer for the oxygen side of the interconnect is deposited by spray pyrolysis and is examined.
-
The protective properties of graphene oxide coatings functionalized with phosphorus atoms.
PublicationRecently, electrophoretically deposited graphene oxide coatings are commonly applied as an anti-corrosion layer. However, improper adjustment of electrophoretic deposition (EPD) parameters as well as the hydrophilic nature of graphene oxide contribute to the formation of defects in the coatings and the increase in the wetting properties, respectively, and thus lead to a reduction of protective properties. The growth of wetting...
-
Protective Zone of an Industrial Plant as a Tool for Environmental Protection
Publication -
Physiological tests on firefighters whilst using protective clothing
Publication -
Chemical Hand Warmers in Protective Gloves: Design and Usage
Publication -
Protective properties of the chromium - titanium carbonitryde composite coatings.
PublicationZbadano właściwości ochronne warstw chromowych zawierających dodatki węglika tytanu poprawiającego właściwości mechaniczne warstw. badania ditycżą roztworów kwasu siarkowego. Badania przeprpwadzono metodą spektroskopii impedamncyjnej. Wykazano ze właściwosci ochronne warswt są lepsze dzięki sdyspergowanym cząstkowm węglika tytanu.
-
Ceria Based Protective Coatings for Steel Interconnects Prepared by Spray Pyrolysis
PublicationStainless steels can be used in solid oxide fuel/electrolysis stacks as interconnects. For successful long term operation they require protective coatings, that lower the corrosion rate and block chemical reactions between the interconnect and adjacent layers of the oxygen or the hydrogen electrode. One of the promising coating materials for the hydrogen side is ceria. Using standard sintering techniques, ceria sinters at around...
-
Nanocrystalline diamond sheets as protective coatings for fiber-optic measurement head
PublicationFiber-optic sensors find numerous applications in science and industry, but their full potential is limited because of the risk of damaging the measurement head, in particular, due to the vulnerability of unprotected tips of the fiber to mechanical damage and aggressive chemical agents. In this paper, we report the first use of a new nanocrystalline diamond structure in a fiber-optic measurement head as a protective coating of...
-
Does time of protective procedure and genotype of chamomile affect yield?
Publication -
Antimicrobial properties of protective coatings produced by plasma spraying technique
Publication -
Effect of environmental temperature variations on protective properties of organic coatings
Publication -
Knitted Structures Made of Antibacterial Fibers Intended for Protective Gloves
Publication -
Case study of the impact of toecap type on the microclimate in protective footwear
Publication -
General Guidelines for the Selection and Use of Filtering Respiratory Protective Devices
Publication -
Cyclic mechanical stress impact on protective properties of organic coatings
PublicationCelem pracy jest zaprezentowanie wyników badań wpływu cyklicznych naprężeń mechanicznych na układy powłoka/metal. Powtarzające się naprężenia mechaniczne zostały zidentyfikowane jako czynnik w znaczącym stopniu przyczyniający się do degradacji powłok. Próbki składające się z powłoki epoksydowej nałożonej na stal St3SAl poddano serii 21000 cykli naprężenie-odpuszczenie. Badania przeprowadzono w zakresie odkształceń elastycznych...
-
Effect of environmental temperature variations on protective properties of organic coatings
PublicationW oparciu o model rozwoju naprężeń oraz niszczenia kumulatywnego przedyskutowano wpływ zmiennych temperatur środowiska na mechaniczną spójność i własności ochronne systemów powłokowych. Badano wpływ cykli temperaturowych pomiędzy 20 i 55 st. C oraz między -20 i 20 st. C na trwałość różnych powłokowych systemów malarskich na stali. Stosując technikę spektroskopii impedancyjnej monitorowano zmiany parametrów powłok poddanych cyklom...
-
Corrosion Study of Ceria Protective Layer Deposited by Spray Pyrolysis on Steel Interconnects
PublicationSingle fuel cells and electrolysis cells are assembled into stacks using interconnects in order to increase power and gas production capacity. The most common choice for the interconnect material is stainless steel. It has good electrical and mechanical properties and is also cost effective. One of the problems when using steel is the formation of a thermally grown oxide scale during use which has a lower electrical conductivity...
-
Polymeric porous membranes as solid support and protective material in microextraction processes: A review
PublicationPolymeric porous membranes have proven to be a versatile and efficient material for microextraction processes. In analytical practice, they are used both as a solid support and as a protective medium for improved sample preparation in various analytical applications. Polymeric porous membranes offer unique advantages in microextraction due to their large surface area and controllable pore size, eliminating interfering effects from...
-
Stream Reasoning to Improve Decision-Making in Cognitive Systems
PublicationABSTRACT Cognitive Vision Systems have gained a lot of interest from industry and academia recently, due to their potential to revolutionize human life as they are designed to work under complex scenes, adapting to a range of unforeseen situations, changing accordingly to new scenarios and exhibiting prospective behavior. The combination of these properties aims to mimic the human capabilities and create more intelligent and efficient...
-
Protective properties of Al2O3 + TiO2 coating produced by the electrostatic spray deposition method
PublicationMechanical resistance of Al2O3 + TiO2 nanocomposite ceramic coating deposited by electrostatic spray deposition method onto X10CrAlSi18 steel to thermal and slurry tests was investigated. The coating was produced from colloidal suspension of TiO2 nanoparticles dispersed in 3 wt% solution of Al2(NO3)3, as Al2O3 precursor, in ethanol. TiO2 nanoparticles of two sizes, 15 nm and 32 nm, were used in the experiments. After deposition,...
-
Protective effect of desloratadine against oxidative stress in human erythrocytes in vitro
Publication -
Thermo-fluid Transport Phenomena in Air-fed Pressurised Protective Clothing
PublicationPublikacja opisuje sposób modelowania turbulentnych przepływów dwuskładnikowych w ciśnieniowych kombinezonach ochronnych, które używane są w reaktorach fuzyjnych. Rozważane są różne modele turbulencji. Przepływy modelowane są w realistycznych geometriach, które odtwarzane są metodą fotogrametrii. Pokazano również sposób modelowania kondensacji pary wodnej na wewnętrznych powierzchniach kombinezonów.
-
Potential protective effect of ovocystatin on aging-related cognitive impairment in rats
Publication -
Dabigatran: its protective effect against endothelial cell damage by oxysterol
Publication -
Evaluation of laser texturing in fabricating cut-resistant surfaces for protective gloves
Publication -
Evaluation of the Elastomeric Composite Self-repair Process for the Construction of Protective Gloves
Publication -
Efficiency of Filtering Materials Used in Respiratory Protective Devices Against Nanoparticles
Publication -
The Impact of Protective Gloves on Manual Dexterity in Cold Environments—A Pilot Study
Publication -
Evaluation of damage of polymeric toecaps used in protective footwear – case study
Publication -
3D Hand Scanning Methodology for Determining Protective Glove Dimensional Allowances
Publication -
Protective Footwear And The Risk Of Slipping In Older Workers – Definitions, Achievements, Recommendations
Publication -
Modified Polymer Materials for Use in Selected Personal Protective Equipment Products
Publication -
Inspection of protective linings using microwave spectroscopy combined with chemometric methods
PublicationOpisano nowa niedestrukcyjna metodę kontroli jakości nowych wykładzin ochronnych na podłożu metalowym oraz oceny ich stanu w trakcie eksploatacji przy zastosowaniu spektroskopii mikrofalowej w szerokim zakresie częstotliwości od 6,5 do 13 GHz. Uzyskane dane pomiarowe dodane zostały obróbce chemometrycznej w celu redukcji ilości danych doświadczalnych i wizualizacji rezultatów. Przedstawiono podstawy teoretyczne metody oraz wyniki...