Wyszukiwarka
Filtry
wszystkich: 1273
wyświetlamy 1000 najlepszych wyników Pomoc
Wyniki wyszukiwania dla: polymer
-
Raman system for on-line monitoring and optimisation of hybrid polymer gelation
PublikacjaW artykule przedstawiono system do monitorowania ramanowskiego reakcji żelowania w procesie zol-żel syntezy organiczno-nieorganicznych polimerów hybrydowych. System pomiarowy umożliwił wykonywanie pomiarów zdalnych, bez wkonieczności wprowadzania jego elementów do wnętrza komory reakcyjnej. Konstrukcja systemu zapewniła szeroki zakres pomiarowy od 200 do 3500 cm-1, przy odpowiednio wysokiej czułości i wyeliminowniu wpływu fluorescencji....
-
Raman system for monitoring of dye doping to hybrid polymer network
PublikacjaZrealizowano i przedstawiono system ramanowski do zdalnego monitorowania procesu zol-żel, dedykowany do monitorowania procedury wprowadznia cząstek barwnika do sieci polimeru hybrydowego. System umożliwia wykonywanie pomiarów zdalnych, bez zakłócania i przerywania przebiegu procesu technologicznego. Zademonstrowano i skomentowano wyniki pomiarów dla przykładowego procesu.
-
Test objects for MRI quality assurance based on polymer gels
Publikacja -
Dosimetric evaluation of a novel polymer gel dosimeter for proton therapy
Publikacja -
The Effect of Nanosilica on the Mechanical Properties of polymer-Cement Composites (PCC)
Publikacja -
Effect of polymer fibres reinforcement on selected properties of asphalt mixtures
PublikacjaThe paper presents selected results of the research program concerning fibre reinforced asphalt concrete. Aramid-polyalphaolefin fibres was used in this study. Selected properties responsible for low temperature cracking and resistance to permanent deformation are presented in this paper. Low temperature cracking susceptibility was evaluated with the results obtained from bending test of rectangular beams with constant rate of...
-
Copper-based 2D-coordination polymer as catalyst for allylation of aldehydes
PublikacjaA copper-tartrate, [Cu2(Tart)2(H2O)2]·4H2O, was synthesized at room temperature in aqueous media using copper chloride and D-tartaric acid. The compound crystallizes in the monoclinic system P21 space group and was characterized by infrared spectroscopy, thermogravimetry, X-ray powder diffraction and the results are in good agreement with the single crystal...
-
Electrochemical and photoelectrochemical properties of the interface between titania nanotubes covered by conducting polymer in aqueous by conducting polymer in aqueous electrolytes – The effect of various geometry and electrolytes concentration
PublikacjaIn the present work we show the impact of nanotubes (NTs) geometry of titania utilized as a substrate in organic-inorganic systems acting as a p-n junction on efficient conversion of radiation energy into electrochemical energy. The electrolytic bath composition and electrolysis conditions were controlled in order to obtain TiO2NTs of various geometry as a result of electrochemical oxidation of titanium foil. The electrode material...
-
International Journal of Polymer Science
Czasopisma -
ACS Applied Polymer Materials
Czasopisma -
Advanced Manufacturing-Polymer & Composites Science
Czasopisma -
Iranian Journal of Polymer Science and Technology
Czasopisma -
Mechanical lithography in a polymer substrate using AFM in contact mode
Dane BadawczeMechanical lithography in a polymer substrate. Contact mode. NTEGRA Prima (NT-MDT) device. NSG 01 probe.
-
EFFECT OF ANTIOXIDANTS ON THE STABILITY OF PITCH- BASED POLYMER TO THERMO-OXIDATIVE ACTION
PublikacjaThe influence of stabilizers – hydrogen donors – on the processes of thermooxidative destruction of pitch-based polymer has been investigated. It is shown that Irganox has not stabilizing effect on pitch-based polymer and melamine slightly retards the destructive process. A mixture of melamine and Irganox exhibits synergetic stabilizing effect and at the optimum ratio it can be used to prevent unwanted thermooxidative processes...
-
Technological aspects of manufacturing polymer packaging materials degradable in seawater environment
PublikacjaIn recent years, the number of polymer materials used in the food packaging market was growing extremely fast. This contributed to depletion of non-renewable resources and more intense degradation of the environment due to resistant polymer. Therefore, such a dramatic situation has forced researchers to look for biodegradable materials, decomposable under action of microorganism. Currently, only a small number of researches examine...
-
Investigation of behaviour of metal structures with polymer dampers under dynamic loads
PublikacjaA large number of accidents concerning structures subjected to dynamic loads have been recently observed. One of the examples of such a structure is a temporary steel grandstand erected using scaffolding system. Dynamic load that is generated by crowd movement has a significant influence on the behaviour of the structure and may lead to excessive structural vibrations. The aim of the study is to consider the idea of using polymer...
-
The effect of macro polymer fibres length and content on the fibre reinforced concrete
PublikacjaThe paper presents studies of a ready-mix concrete containing polymer fibres of three different lengths: 24, 38 and 54 mm. The performed tests allowed to determine the effect of fibre volume fraction and length on the concrete strength. The basic parameters of concrete mixture (consistency, air content and bulk density) were identified. Fibre reinforced concrete belongs to a group of composite materials. The polymer fibres are...
-
Polymer based thick films - material quality and interface resistance evaluation
PublikacjaThe properties of polymer based thick film layers mede using different resistive pastes and dipping silvers have been studied. The composite of carbon and graphite (C/Gr) conducting particles suspended in different polymer vehicles were used for preparation resistive layers. Interface resistance Rc created between dipping silver (DiAg) contact layer and resistive layer was determined from the surface potential distribution measurements...
-
Potential applications of crude glycerol in polymer technology–Current state and perspectives
PublikacjaThe increasing use of bio-based fuels and fuel additives, among them biodiesel, causes significant surplus of crude glycerol on the market which creates new challenges in terms of its sustainable utilization. A lot of ways for the incorporation of this by-product into different branches of industry requires purification by expensive and complicated processes. Therefore, researchers are seeking for applications of untreated crude...
-
Investigation of solid polymer electrolyte gas sensor with different electrochemical techniques
PublikacjaIn this work solid polymer electrolyte (SPE) amperometric sulphur dioxide sensor is investigated. Nafion was used as a membrane electrode and 1M sulphuric acid as an internal electrolyte. Sensor response to sulphur dioxide was measured. Besides traditional constant voltage amperometry also different electrochemical techniques were used. Results obtained by these methods are compared.
-
Effect of low-temperature plasma on chitosan-coated PEEK polymer characteristics
Publikacja -
TESTING CONTRACTION AND THERMAL EXPANSION COEFFICIENT OF CONSTRUCTION AND MOULDING POLYMER COMPOSITES
PublikacjaThe paper presents results of systematic tests of contraction and thermal expansion coefficients of materials based on polymer composites. The information on the above material properties is essential both at the design stage and during the use of finished products. Components for the samples were selected in such a way as to represent typical materials used for production of construction and moulding elements. The performed tests...
-
Investigation of energy deposition and its optical imaging in polymer gel dosimeters
PublikacjaThis following chapter describes methods for verifying the absorbed dose during radiotherapy. Special attention is paid to the method using polymer-gel dosimeters, the dose reading of which is performed by means of Laser Computed Tomography. The chapter also includes considerations on alternative solutions for dosimetric measurements and various types of radiotherapy and their pros and cons. In addition, both the methods of structural...
-
Influence of the Addition of Recycled Aggregates and Polymer Fibers on the Properties of Pervious Concrete
PublikacjaThe aim of the study was to check the possibility of reusing aggregate from recycled concrete waste and rubber granules from car tires as partial substitution of natural aggregate. The main objective was to investigate the effects of recycled waste aggregate modified with polymer fibers on the compressive and flexural strength, modulus of elasticity and permeability of pervious concrete. Fibers with a multifilament structure and...
-
Interferometric Sensor of Wavelength Detuning Using a Liquid Crystalline Polymer Waveplate
PublikacjaOperation of a polarization interferometer for measurement of the wavelength changes of a tunable semiconductor laser was investigated. A lambda/8 waveplate made from liquid crystalline polymer is placed in one of interferometers’ arms in order to generate two output signals in quadrature. Wavelength was measured with resolution of 2 pm in the wavelength range 628–635 nm. Drift of the interferometer, measured in the period of 500...
-
Polarization interferometer using a Liquid Crystalline Polymer waveplate for wavelength measurement
PublikacjaA two-beam polarization interferometer for measuring wavelength changes of a tunable semiconductor laser was designed, built and tested. This interferometer uses a λ/8 waveplate made from Liquid Crystalline Polymer in order to generate two output signals in quadrature. The λ/8 waveplate can be manufactured either on a beamsplitter face or on the mirror surface, reducing the cost and complexity of the optomechnical assembly. Experiment...
-
Construction and investigation of SO2 amperometric sensor with a solid polymer electrolyte membrane
Publikacjan this paper a sensor for detection of the sulphur dioxide based on three electrode cell configuration with a liquid electrolyte, a mercury sulphate reference electrode and a solid polymer electrolyte working electrode is presented. Working elec- trode was obtained by using Takenaka-Torikai chemical deposi- tion method by precipitation of Au particles into the pores of the Nafion membrane. Sensors characteristics measurements were...
-
Imprinted polymer particles for iron uptake: Synthesis, characterization and analytical applications
Publikacja -
Bulk-Surface Modification of Nanoparticles for Developing Highly-Crosslinked Polymer Nanocomposites
PublikacjaSurface modification of nanoparticles with functional molecules has become a routine method to compensate for diffusion-controlled crosslinking of thermoset polymer composites at late stages of crosslinking, while bulk modification has not carefully been discussed. In this work, a highly-crosslinked model polymer nanocomposite based on epoxy and surface-bulk functionalized magnetic nanoparticles (MNPs) was developed. MNPs were...
-
Potential of Functionalized Polyolefins in a Sustainable Polymer Economy: Synthetic Strategies and Applications
PublikacjaPolymers play a crucial role in our modern life as no other material exists that is so versatile, moldable, and lightweight. Consequently, the demand for polymers will continue to grow with the human population, modernization, and technological developments. However, depleted fossil resources, increasing plastic waste production, ocean pollution, and related growing emission of greenhouse gases has led to a change in the way we...
-
CARBOCHAIN POLYMER-GLUCOSE HYBRIDS: SYNTHESIS, THERMAL/MECHANICAL PROPERTIES AND BIODEGRADABILITY
Publikacja -
Metal heksacyanoferrate network synthesized inside polymer matrix for electrochemical capacitors
PublikacjaPrzedmiotem publikacji jest charakterystyka elektrochemiczna polimeru przewodzącego (poli(3,4-etylenodioksytiofenu)) modyfikowanego błękitem pruskim oraz jego pochodnymi, pochodną kobaltową oraz pochodną niklową. Materiały są stabilne elektrochemicznie, a uzyskane wartości pojemności elektrycznej pozwalają na wykorzystanie ich przy konstrukcji kondensatorów elektrochemicznych.
-
Modified Polymer Materials for Use in Selected Personal Protective Equipment Products
Publikacja -
Advances in Natural Polymer-Based Electrospun Nanomaterials for Soft Tissue Engineering
Publikacja -
Development of a Formability Prediction Model for Aluminium Sandwich Panels with Polymer Core
Publikacja -
Chiral Diketopyrrolopyrrole-Helicene Polymer With Efficient Red Circularly Polarized Luminescence
Publikacja -
The Effect of Aromatic Diimide Side Groups on the π-Conjugated Polymer Properties
Publikacja -
Intermolecular Interactions in Selected Polymer-Water Systems as Seen by Raman Spectroscopy
Publikacja -
On the possibility of using liquid or lipid - polymer membrane systems as taste sensors
PublikacjaMembrany ciekłe z anionowym surfaktanetem mogą być użyte do rozpoznawania molekularnego substancji smakowych ale nie mogą stanowić podstawy sensora smaku głównie z powodu chaotycznych zachowań. Przeciwnie membrany polimerowo-lipidowe mogą być zastosowane w sensorze smaku do badania jakości pewnych napojów handlowych.
-
Investigation of Taste Substances by five Channel Lipid-Polymer Membrane Sensor.
PublikacjaBadano substancje o różnych stężeniach należące do czterech klas smaku za pomocą pięcio-kanałowego sensora opartego o elektrody jonoselektywne z różnymi membranami polimerowo-lipidowymi. Stwierdzono, że sensor jest czuły na zmiany stężeń chlorowodorku chininy, kawsu cytrynowego i chlorku sodu, przeciwnie jak w przypadku sacharozy. Na podstawie tych wyników można przypuszczać, że sensor może być zastosowany do roztworów składających...
-
Characterization of PVC-based polymer inclusion membranes with phosphonium ionic liquids
Publikacja -
Application of non-metal doped titania for inverted polymer solar cells
PublikacjaDomieszkowany jodem oraz domieszkowany jodem ditlenek tytanu uzyto jako warstwę buforową w ogniwie ITO/X-TiO2?P3HT-PCMB /MnO2/ Ag.Warswty X-TiO2 nalożono metodą spin-coatingu z zawiesiny nanocząstek w DMSO. Jednorodne struktury scharakteryzowane pod względem morfologii mikroskopowo metodą AFM. Charakterystyka prądowo-napięciowa urzdzeń wskazuje iż domieszkowany jodem TiO2 pozwala osiągnąć lepsze parametry PCE (1,67%) i prąd zwarcia...
-
Radiation therapy dosimetry using magnetic resonance imaging of polymer gels
Publikacja -
Polymer films based on silk fibroin and collagen - the physico-chemical properties
Publikacja -
Characteristics of Hybrid Bioglass-Chitosan Coatings on the Plasma Activated PEEK Polymer
Publikacja -
Polymer biodegradable coatings as active substance release systems for urological applications
PublikacjaCatheter-associated urinary tract infections are the result of catheterization of the bladder. The risk of infection is directly proportional to the length of the bladder catheterization. Bacteria cells have the ability to adhere and create the biofilm on the surface of catheter materials. Bacteria’s biofilm is an extremely beneficial environment of existence for microorganisms. Microorganisms that are an integral part of the biofilm...
-
PROGRESS IN POLYMER SCIENCE
Czasopisma -
JOURNAL OF POLYMER RESEARCH
Czasopisma -
JOURNAL OF POLYMER ENGINEERING
Czasopisma -
Polymers
Czasopisma