displaying 1000 best results Help
Search results for: CLUMPS OF DISCS
-
Validation of lumbar spine finite element model
Open Research DataThe functional biomechanics of the lumbar spine have been better understood by finite element method (FEM) simulations. However, there are still areas where the behavior of soft tissues can be better modeled or described in a different way. The purpose of this research is to develop and validate a lumbar spine section intended for biomechanical research....
-
Preparation and characterization of TiO2 nanostructures for catalytic CO2 photoconversion
PublicationThe titanium dioxide target (99.7%) of 1 cm in dia was ablated in vacuum by laser pulses(6 ns) at 266 nm and at repetition rate of 10 Hz. During deposition the laser fluence between 1 and 3.5 J/cm2 and the O2 pressure from the range of 10-2 - 1 Pa were applied. The thin TiO2 films were deposited on glass substrate (1 × 1 cm2) heated up to 500 °C. The chemical composition of the film and samples produced by annealing were investigated...
-
Estimation of Screw Displacement Pile-Bearing Capacity Based on Drilling Resistances
PublicationThis article presents an engineering, empiricalmethod of estimating the bearing capacity and settlementcharacteristics Q-s of screw displacement piles andcolumns, based on soil resistance encountered during thedrilling to form piles/columns in the ground. The methodwas developed on the basis of correlation analyses of thetest results of 24 piles made during the “DPDT-Auger”research project (Krasiński et al., 2022a). In the proposedmethod,...
-
Studies of the separation performance of silanized silica gel for simulated distillation
PublicationWe present the results of investigations of the chromatographic (sorptive) properties of silanized silica gel as a stationary phase for gas chromatography used for simulated distillation. Commercially available silanized sorbent (particle diameter range 63–200 m, average pore size 60 Å) was sieved to obtain the 80–100 mesh fraction (180–150 m). The obtained results revealed that silanized silica gel allows the complete separation...
-
Research of leakage magnetic field in deenergized transformer
PublicationThe article deals with the issue of the numerical analysis of the magnetic field occurring around the transformer after it has been powered down. The main goal of this analysis was to examine if it is possible to identify the residual fluxes in the transformer legs based on this fields’ measurements. It was also intended to determine the type and the location of magnetic sensors. Numerical analysis of the magnetic field was performed....
-
Kinetics of cyclohexane removal by Candida subhashii and Fusarium solani
Open Research DataDataset presents cyclohexane biodegradation in gas phase using two species of microorganisms: Candida Subhashii and Fusarium solani. Biodegradation was carried out in sealed chambers with a capacity of 1000 ml. In each of them there are two discs inhabited with microorganisms, made of polyurethane foam, 80 mm in diameter and 20 mm thick.
-
Results after grinding C45 steel
Open Research DataThe database contains results from nanoindenter, scanning microscope and also X-ray diffractometer. To determine the residual stresses and the size of the crystallites in the ferrite grains in the grinded surface layer, the Williamson Hall analysis of the X-ray diffraction patterns was performed. XRD diffraction patterns were also used to perform a...
-
Multi-Objective Water Distribution Systems Control of Pumping Cost, Water Quality, and Storage-Reliability Constraints
PublicationThis work describes a multi-objective model for trading-off pumping cost and water quality for water distribution systems operation. Constraints are imposed on flows and pressures, on periodical tanks operation, and on tanks storage. The methodology links the multi-objective SPEA2 algorithm with EPANET, and is applied on two example applications of increasing complexity, under extended period simulation conditions and variable...
-
Pressure drop and heat transfer during boiling and condensation at subcritical region
PublicationMost of the data presented in the literature relate to saturation temperatures in the range - 20°C to 40°C due to the application in refrigeration technology. There is necessity to extend databases to higher values of saturation temperature due to new applications such as Organic Rankine Cycle and high temperature heat pumps. Only few papers contain data for high reduced pressure for low boiling point liquids. This paper focus...
-
EXPERIMENTAL RESEARCH ON INFLUENCE OF THE FUEL NOZZLE GEOMETRY ON THE FUEL CONSUMPTION OF THE MARINE 4-STROKE DIESEL ENGINE
PublicationThe article presents experimental research that has been carried out on a marine, 4-stroke, 3-cylinder, turbocharged engine. During testing, the engine operated at a constant rotational speed of 750 rpm and a load from 0 kW to 280 kW. The engine was fuelled by diesel oil of known specification and loaded by electric generator with water resistance. The fuel consumption was measured during the engine operation with fuel nozzles...
-
A constitutive law for concrete with smooth transition from continuous into discontinuous cracks’ description
PublicationPaper presents a constitutive model for concrete that combines a continuous and discontinuous crack’s description to simulate the concrete under tensile dominated loads. In a continuum regime, two different constitutive laws were used. First, a plasticity model with the Rankine failure criterion and an associated flow rule was used. Second, a constitutive law based on isotropic damage mechanics was formulated. Both model alternatives...
-
The structure of Bi2VO5.5 ceramic prepared by 3 different ways measured with X-ray diffraction
Open Research DataThe structure of Bi2VO5.5 ceramics was measured by XRD.
-
Thermal properties of strontium–borate glasses and glass-ceramics containing bismuth and vanadium oxides measured with DSC method
Open Research DataThermal properties of strontium–borate glasses and glass-ceramics containing bismuth and vanadium oxides was measured by DSC.
-
Thermal properties of ceramic Bi2VO5.5 and strontium–borate glass-ceramics containing crystalites of Bi2VO5.5. measured with DSC
Open Research DataThermal properties of ceramic Bi2VO5.5 and strontium–borate glass-ceramics containing Bi2VO5.5 crystallites was measured by DSC.
-
Strength of Materials II,Lectures,DAPE,spring 22-23(PG_00050281)
e-Learning CoursesThe aim of the subject is to acquire knowledge related to the advanced fundamentals of Mechanics of Materials
-
Inter Applied Chemistry Programme 7 Principles of Environmental MicrobiologyC.W. Knapp
e-Learning CoursesInter Applied Chemistry Programme 7 Dr Charles W. Knapp BSc MSc PhD FHEA Principles of Environmental Microbiology
-
[AiU] Contemporary research methodology, evaluation and preservation of historic architecture
e-Learning Courses{mlang pl} Dyscyplina: architektura i urbanistyka Zajęcia obowiązkowe dla doktorantów II roku Prowadzący: Assoc. Prof. Dr. Paola Ardizzola Liczba godzin: 30 Forma zajęć: wykład/seminarium {mlang} {mlang en} Discipline: architecture and urbanism Obligatory course for 2nd-year PhD students Academic teachers: Assoc. Prof. Dr. Paola Ardizzola Total hours of training: 30 teaching hours Course type: lecture/seminar {mlang}
-
Physical and chemical basis of energy generation - GT 2021-2022
e-Learning Courses -
Strength of Materials I,Lectures,DAPE,fall 22-23(PG_00055150)
e-Learning CoursesThe aim of the subject is to acquire knowledge related to the fundamentals of Mechanics of Materials
-
Strength of Materials II,Lectures,DAPE,spring 21-22 (PG_00050281)
e-Learning CoursesThe aim of the subject is to acquire knowledge related to the strength of materials II (mechanics of material, part 2)
-
[AiU] Contemporary research methodology, evaluation and preservation of historic architecture
e-Learning CoursesThis course is compulsory for PhD students assigned to Architecture and Urbanism tracks at Doctoral School at Gdańsk University of Technology. The course is conducted by prof. Sandro Parrinello, Department of Civil Engineering and Architecture of University of Pavia Course type: workshops Total hours of training: 30 teaching hours Classes in hybrid mode (classes conducted online and at the GdańskTech)
-
SUMMER SCHOOL OF ENGLISH 2023 GROUP 1 14.00 BEIJING TIME
e-Learning Courses -
Mechanics of Materials, MSc, 2022/2023, Summer, [L,T] (PG_00057378)
e-Learning Courses -
Design of Public Spaces with Green Elements, Erasmus, semestr VI
e-Learning Courses -
DATA MINING (Field of study: Economic analytics 1st semester) -2022
e-Learning Courses -
Przedmiot Podstawy Zarządzania/Essentials of Managament (Archiwizowany 2023-04-14)
e-Learning Courses -
Elements of Polish History.Culture.Society&Economics.2022/2023.BIM.sem.1
e-Learning Courses -
Strength of Materials I, Tutorials, DaPE, Fall 22-23, (PG_00055150)
e-Learning CoursesCelem przedmiotu jest zapoznanie studentów z zasadami wytrzymałości materiałów oraz metody realizacji obliczeń wytrzymałościowych.
-
Strength of Materials I,Lectures,DAPE,fall 24-25(PG_00055150)
e-Learning CoursesThe aim of the subject is to present the fundamentals of strength of materials and methods used to conduct strength of materials calculations
-
Strength of Materials I,Lectures,DAPE,fall 23-24(PG_00055150)
e-Learning CoursesThe aim of the subject is to acquire knowledge related to the fundamentals of Mechanics of Materials
-
Public spaces design with elements of greenery 2023/24 eng.
e-Learning Courses -
Economics and organization of investment process - sem.8 - 2023/24
e-Learning Courses -
Composite materials - fabrication, properties and prospects of application 2024/2025
e-Learning Courses -
Fundamentals of Electrical Engineering and Electronics 2 [EE][2024/25]
e-Learning CoursesIntroduction and analysis of fundamental electronic components, circuits and applications.
-
Methodology of teamwork, L, DAPE, sem.4, letni, 2023/24
e-Learning CoursesSubject lecture
-
Building Installations (PG_00050761) 2019/2020 - 1st sem. of master degree
e-Learning Courses -
Fundamentals of Power Electronics [Energy Technologies][EE][I][2023/24]
e-Learning Courses -
[AiU] 20232024_Contemporary research methodology, evaluation and preservation of historic architecture_final
e-Learning CoursesThis course is compulsory for PhD students assigned to Architecture and Urbanism tracks at Doctoral School at Gdańsk University of Technology. The course is conducted by prof. Sandro Parrinello, Department Architecture of University of Florence Course type: workshops Total hours of training: 30 teaching hours Classes in hybrid mode (classes conducted online and at the GdańskTech)
-
Methodology of teamwork, S, DAPE, sem.3, letni, 2023/24
e-Learning CoursesSubject seminar
-
Strength of Materials I,Lectures,DAPE,fall 23-24(PG_00055150)
e-Learning CoursesThe aim of the course is to acquire knowledge referring to the Mechanics of Materials (Strength of Materials)
-
Theory of architectural design V. Design for all 2024/25
e-Learning CoursesThe aim of the course is to increase awareness of the needs of people with special needs and the idea of universal design. The subject is to introduce the social and legal conditions of the profession of architect, focused on the needs of all vulnerable user groups, including people with disabilities and the elderly. Knowledge of solutions related to Design for All is necessary due to the implementation of directives and standards...
-
Fundamentals of Electrotechnics and Electronics II - project China [2023/24]
e-Learning CoursesIntroduction and analysis of fundamental electronic components, circuits and applications.
-
Strength of Materials I, Tutorials, DaPE, Winter 24/25, (PG_00055150)
e-Learning CoursesCelem przedmiotu jest zapoznanie studentów z zasadami wytrzymałości materiałów oraz metodami realizacji obliczeń wytrzymałościowych.
-
Methodology of teamwork, L, DAPE, sem.3, letni, 2023/24
e-Learning CoursesSubject lecture
-
[NCh, ICh] Physical Chemistry of Organic Compounds in Natural Waters
e-Learning Courses{mlang pl} Dyscyplina: Nauki chemiczne Zajęcia obieralne dla doktorantów Prowadzący: prof. dr hab. Tadeusz Górecki Liczba godzin: 15 {mlang} {mlang en} Discipline: Chemical science Elective course for PhD students Academic teacher: prof. dr hab. inż. Tadeusz Górecki Total hours of training: 15 teaching hours {mlang}
-
Strength of Materials II,Lectures,DAPE,spring 23-24(PG_00050281)
e-Learning CoursesThe aim of the subject is to acquire knowledge to conduct engineering calculation of systems under the complex load. Celem przedmiotu jest zapoznanie się z realizacją obliczeń wytrzymałościowych układów w złożonym stanie obciążenia.
-
Economics and organization of investment process - sem.6 - 2023/24
e-Learning Courses -
Strength of Materials I, Tutorials, DaPE, Fall 23/24, (PG_00055150)
e-Learning CoursesCelem przedmiotu jest zapoznanie studentów z zasadami wytrzymałości materiałów oraz metodami realizacji obliczeń wytrzymałościowych.
-
Methodology of teamwork, S, DAPE, sem.4, letni, 2023/24
e-Learning CoursesSubject seminar
-
Selected local stability problems of channel section flanges made of aluminium alloys
PublicationThe paper addresses the issue of local buckling of compressed flanges of cold-formed thin-walled channel columns and beams with nonstandard flanges composed of aluminium alloys. The material behaviour follows the Ramberg–Osgood law. It should be noted that the proposed solution may be also applied for other materials, for example: stainless steel, carbon steel. The paper is motivated by an increasing interest in nonstandard cold-formed...