Wyszukiwarka
Filtry
wszystkich: 103
wybranych: 90
Filtry wybranego katalogu
Wyniki wyszukiwania dla: power conditioning
-
Impact of Ischemic Intra-Conditioning on Power Output and Bar Velocity of the Upper Limbs
Publikacja -
The forming and emission of high power electromagnetic pulses
PublikacjaAn impulse energy source, a power conditioning system and an electromagnetic field emitter are essential to generate an electromagnetic field pulse (EMFP) with a specific frequency bandwidth. Selected simulation results for a power conditioning system consisting of a fuse opening switch and a paraboloidal electromagnetic emitter have been presented in this article. The synthetic system examined in the simulation is powered by an...
-
The forming and emission of high power electromagnetic pulses
PublikacjaAn impulse energy source, a power conditioning system and an electromagnetic field emitter are essential to generate an electromagnetic field pulse (EMFP) with a specific frequency bandwidth. Selected simulation results for a power conditioning system consisting of a fuse opening switch and a paraboloidal electromagnetic emitter have been presented in this article. The synthetic system examined in the simulation is powered by...
-
A novel approach to energy safety improvement in the marine power plants with active power surge compensator
PublikacjaPaper raises a point of power surges and theirs adverse effects in the marine power plants. The article explains a source of surges appearance, and presents measurements carried out on a modern ship. It discusses effects of dynamic power transients on the ship’s energy safety. Finally it proposes, a novel approach for power surge elimination, based on medium voltage active conditioner. As well as it propose the topology and control...
-
Fibre lasers - conditioning constructional and technological
Publikacja -
Application of microwaves for sewage sludge conditioning
PublikacjaArtykuł dotyczy wpływu promieniowania mikrofalowego na odwadnianie osadów ściekowych. Przeprowadzono pomiary parametrów charakteryzujących podatność osadów ściekowych na odwadnianie: opór właściwy, czas ssania kapilarnego oraz zawartość suchej masy w osadzie po odwirowaniu. Stwierdzono poprawę odwadnialności osadów kondycjonowanych promieniowaniem mikrofalowym, zależną ilościowo od rodzaju preparowanych osadów. Zastosowanie podwójnego...
-
Small photovoltaic setup for the air conditioning system
Publikacja -
IMPEDANCE MEASUREMENT MODULE FOR GAS SENSORS WITH TEMPERATURE CONDITIONING FEATURE
PublikacjaThe paper presents an impedance measurement module which is aimed for gas sensor. Sensor’s heater temperature conditioning and modulation feature is available in order to allow implementation of different techniques improving selectivity and sensitivity of gas sensors. The measurement module uses three-parameter sine-fitting technique for impedance measurement. To monitor sensor temperature, the resistance of the sensor’s heater...
-
Organizational Conditioning of Job Satisfaction. A Model of Job Satisfaction
Publikacja -
Numerical conditioning of delta-domain Lyapunov and Riccati equations
PublikacjaW pracy rozważono problem uwarunkowania dyskretno czasowych równań Lapunowa oraz równań Riccatiego - to znaczy problem wrażliwości rozwiązań takich równań na odchyłki ich parametrów od nominalnych wartości. Zdefiniowano odpowiedni "różniczkowy" wskaźnik uwarunkowania oraz podano efektywną metodę szacowania jego wartości. Udowodniono teoretycznie - a także przekonująco zilustrowano na drodze numerycznej - twierdzenie głoszące, iż...
-
The methods of heat recovery in air conditioning and ventilation systems
PublikacjaPrzedstawiono wybrane metody i urządzenia do odzysku ciepła takie jak: recyrkulacja, regeneratory obrotowe, rekuperatory, rurki cieplne,układy z czynnikiem pośredniczącym, pompy ciepła oraz układy hybrydowe. Przedyskutowano podstawowe kryteriium oceny odzysku ciepła oraz efektywność cieplną wymiennika w układzie odzysku ciepła.
-
Modeling of lapping plate wear and conditioning in single-sided lapping
PublikacjaIn order to achieve higher quality on worked surfaces with lower roughness, very high accuracy of shape and dimensions it is crucial to improve conventional finishing technologies and to develop new working principles. Single-sided lapping is one of the most effective planarization technologies and it is determined by a number of factors and boundary conditions. The most significant influence over a dimensional and profile accuracy,...
-
Signal conditioning for examination of shallow-water acoustic noise correlation properties
PublikacjaThe article describes the process of signal conditioning for examination of acoustic noise correlation properties in shallow water. Knowledge of these properties is very important for the design processes of passive and active hydroacoustic systems. This paper focuses on the above issue from the point of view of passive sonar. In sonar systems, signal processing algorithms operate on both useful acoustic signals, and accompanying...
-
Sprint performance following plyometric conditioning activity in elite sprinters
Publikacja -
The Effects of Plyometric Conditioning on Post-Activation Bench Press Performance
Publikacja -
CONDITIONING FACTORS OF INDUSTRY-UNIVERSITY COOPERATION FROM THE PERSPECTIVE OF ENTERPRISES
PublikacjaThe cooperation between enterprises and universities varies in terms of character and intensity. Bearing in mind the potential represented by both parties, its low intensity is still noticed, and consequently, the lack or incomplete use of opportunities resulting from this cooperation. Current factors of industry-university cooperation were identified from the perspective of companies from biotechnology and pharmaceutical...
-
A study of possibility the air conditioning system in a car to become a bioaerosol generator
Publikacja -
Acute Effects of Ischemic Intra-Conditioning on 30 m Sprint Performance
Publikacja -
Effects of Unilateral Conditioning Activity on Acute Performance Enhancement: A Systematic Review
Publikacja -
Some remarks about numerical conditioning of discrete time Riccati eqations.
Publikacja...
-
Analysis of abrasive particle trajectories during single-sided lapping process with driven conditioning ring
PublikacjaIn this paper new kinematics systems were studied for a single lapping process. In order to ensure the constant profile wear of the tool a standard kinematic system can be changed. Lapping is carried out by applying loose abrasive grains between two surfaces and causes a relative motion between them. The result is a finish of multi-directional lay. During process, the mechanism of surface formation are decisively affected by a...
-
The Effects of Plyometric Conditioning Exercises on Volleyball Performance with Self-Selected Rest Intervals
Publikacja -
Internal heat recuperation in vapor compression and hybrid desiccant air conditioning systems
PublikacjaPraca przedstawia badania prowadzone w Katedrze Techniki Cieplnej Politechniki Gdańskiej nad wewnętrznym odzyskiem ciepła w parowo-spreżarkowych oraz adsorpcyjnych hybrydowych urządzeniach klimatyzacyjnych. Zaprezentowano wyniki analizy psychrometrycznej procesów realizowanych w urządzeniach, stanowiska badawcze urządzeń oraz uzyskane wyniki eksperymentalne.
-
Conditioning scenarios on regional impact assessment of the Via Hanseatica zone (the Sapphire Arc).
PublikacjaPraca zawiera cztery scenariusze rozwoju regionalnego strefy wokół drogi Via Hanseatica (Szczecin-gdańsk-Kaliningrad). Scenariusze służą jako podstawa oceny oddziaływań regionalnych (impact essessment) drogi.
-
Numerical modeling of cross-flow heat exchanger for air-conditioning purposes in preliminary study.
PublikacjaPraca przedstawia wyniki obliczeń numerycznych krzyżowego płytowo-rurowego wymiennika ciepła przeznaczonego do celów klimatyzacyjnych w początkowym etapie jego projektowania.
-
Postactivation Performance Enhancement of Concentric Bench Press Throw After Eccentric-Only Conditioning Exercise
Publikacja -
Determination of polybrominated diphenyl ethers (PBDEs) in dust samples collected in air conditioning filters of different usage – method development
PublikacjaThis study presents the results of studies aimed at the development of an analytical procedure for separation, identification, and determination of PBDEs compounds in dust samples collected from automotive cabin air filters and samples collected from filters installed as part of the air purification system in academic facilities. Ultrasound-assisted dispersive solid phase extraction (UA-dSPE) was found to perform better in terms...
-
AN IMPACT OF THE EFFICIENT FUNCTIONING OF THE VENTILATION AND AIR-CONDITIONING SYSTEM ON THERMAL COMFORT OF THE MEDICAL STAFF IN THE OPERATING ROOM
Publikacja -
Acute Effects of Complex Conditioning Activities on Athletic Performance and Achilles Tendon Stiffness in Male Basketball Players
Publikacja -
Acute Effects of Isometric Conditioning Activity on the Viscoelastic Properties of Muscles and Sprint and Jumping Performance in Handball Players
Publikacja -
Real‐Time PPG Signal Conditioning with Long Short‐Term Memory (LSTM) Network for Wearable Devices
PublikacjaThis paper presents an algorithm for real‐time detection of the heart rate measured on a person’s wrist using a wearable device with a photoplethysmographic (PPG) sensor and accelerometer. The proposed algorithm consists of an appropriately trained LSTM network and the Time‐Domain Heart Rate (TDHR) algorithm for peak detection in the PPG waveform. The Long Short‐Term Memory (LSTM) network uses the signals from the accelerometer...
-
Social and Infrastructural Conditioning of Lowering Energy Costs and Improving the Energy Efficiency of Buildings in the Context of the Local Energy Policy
Publikacja -
Acute Effects of High-Load vs. Plyometric Conditioning Activity on Jumping Performance and the Muscle-Tendon Mechanical Properties
Publikacja -
Acute effects of combined isometric and plyometric conditioning activities on sports performance and tendon stiffness in female volleyball players
Publikacja -
Cascaded Buck Hybrid Interlink Converter for Multiple-Input / Multiple-Output Operation
PublikacjaThe provision of isolated- and non-isolated DC output voltages by Power electronics power-conditioning devices in the recent ‘green-energy-revolution’ era is on course. In this paper, a structure for multi-input multi-output(MIMO) DC–DC buck converter is proposed to generate output voltages of varying levels with fewer component-count. The DC output voltage of each of the constituting buck converters can be used independently or...
-
Effects of Eccentric Speed during Front Squat Conditioning Activity on Post-activation Performance Enhancement of Hip and Thigh Muscles
Publikacja -
Acute effects of unilateral and bilateral conditioning activity on countermovement jump, linear speed, and muscle stiffness: A randomized crossover study
Publikacja -
Badania urządzeń wentylacyjno-klimatyzacyjnych wykorzystujących adsorpcyjne osuszanie powietrza = Experimental and theoretical investigations into air - conditioning systems with desiccant unit
PublikacjaArtykuł dotyczy prac związanych z potrzebą ograniczenia zużycia energii w systemach wentylacyjnych i klimatyzacyjnych. Przedstawia badania nad nowoczesnymi, adsorpcyjnymi urządzeniami wentylacyjno-klimatyzacyjnymi oraz doskonaleniem metod obliczania procesów wymiany ciepła i masy w tym zakresie.
-
Functional Properties and Antioxidant Activity of Morus alba L. Leaves var. Zolwinska Wielkolistna (WML-P)—The Effect of Controlled Conditioning Process
Publikacja -
Effectiveness of either short-duration ischemic pre-conditioning, single-set high-resistance exercise, or their combination in potentiating bench press exercise performance
Publikacja -
Will NILM Technology Replace Multi-Meter Telemetry Systems for Monitoring Electricity Consumption?
PublikacjaThe estimation of electric power utilization, its baseload, and its heating, light, ventilation, and air-conditioning (HVAC) power component, which represents a very large portion of electricity usage in commercial facilities, are important for energy consumption controls and planning. Non-intrusive load monitoring (NILM) is the analytical method used to monitor the energy and disaggregate total electrical usage into appliance-related...
-
A novel degree-hour method for rational design loading
PublikacjaCooling degree-hours (CDH) received the broadest application in evaluation of the ambient air cooling efficiency in power engineering (engine intake air cooling systems) and air conditioning. The current CDH numbers are defined as a drop in air temperature multiplied by associated time duration of performance and their summarized annual number is used to estimate the annual effect achieved due to sucked air cooling in power plants...
-
Application of shifted Chebyshev polynomial-based Rayleigh–Ritz method and Navier’s technique for vibration analysis of a functionally graded porous beam embedded in Kerr foundation
PublikacjaPresent study is dealt with the applicability of shifted Chebyshev polynomial based Rayleigh-Ritz method and Navier’s technique on free vibration of Functionally Graded (FG) beam with uniformly distributed porosity along the thickness of the beam. The material properties such as Young’s modulus, mass density, and Poisson’s ratio are also considered to vary along the thickness of the FG beam as per the power-law exponent model....
-
Implementation of Hermite-Ritz method and Navier’s Technique for Vibration of Functionally Graded Porous Nanobeam Embedded in Winkler-Pasternak Elastic Foundation Using bi-Helmholtz type of nonlocal elasticity
PublikacjaPresent study is devoted to investigating the vibration characteristics of Functionally Graded (FG) porous nanobeam embedded in an elastic substrate of Winkler-Pasternak type. Classical beam theory (CBT) or Euler-Bernoulli beam theory (EBT) has been incorporated to address the displacement of the FG nanobeam. Bi-Helmholtz type of nonlocal elasticity is being used to capture the small scale effect of the FG nanobeam. Further, the...
-
Influence of Increased Body Mass and Body Composition on Cycling Anaerobic Power
Publikacja -
Short-Term Blood Flow Restriction Increases Power Output and Bar Velocity During the Bench Press
Publikacja -
Tool Wear Prediction in Single-Sided Lapping Process
PublikacjaSingle-sided lapping is one of the most effective planarization technologies. The process has relatively complex kinematics and it is determined by a number of inputs parameters. It has been noted that prediction of the tool wear during the process is critical for product quality control. To determine the profile wear of the lapping plate, a computer model which simulates abrasive grains trajectories was developed in MATLAB. Moreover,...
-
Combined cold supply system for ship application based on low GWP refrigerants - Thermo-economic and ecological analyses
PublikacjaThe withdrawal of popular high-GWP refrigerants will significantly affect maritime industry. Refrigeration and air conditioning systems currently used on ships are not ready to fulfil future limitations. Therefore, there is a need for system, which will operate with low-GWP refrigerants and at the same time will be efficient and reliable in difficult environmental conditions. This paper explains the concept of a cold supply system,...
-
Non-conventional approach in single-sided lapping process: kinematic analysis and parameters optimization
PublikacjaThe lapping process is strongly affected by a number of input parameters. One of the fundamental mechanical processes in lapping is the abrasive effect of particles. In order to examine the influence of the kinematic parameters on the lapping uniformity of unconventional single-sided machine, numerical simulations of particles sliding trajectories are performed. Changing the kinematic parameters, e.g., rotational velocities or...
-
The idea of a robotic single-sided lapping system
PublikacjaThis paper reviews the idea of a robotic lapping system. Robot’s assistance automates the lap-ping process and supports the development of a flexible lapping system. However, the main aim behind the idea of a robotic lapping system is to provide improved means for controlling the posi-tion of conditioning rings on a lapping plate. Due to the kinematics of lapping process, the profile wear of the tool is not constant along the radius....