Filtry
wszystkich: 31705
-
Katalog
- Publikacje 8594 wyników po odfiltrowaniu
- Czasopisma 158 wyników po odfiltrowaniu
- Konferencje 11 wyników po odfiltrowaniu
- Osoby 419 wyników po odfiltrowaniu
- Wynalazki 8 wyników po odfiltrowaniu
- Projekty 24 wyników po odfiltrowaniu
- Zespoły Badawcze 3 wyników po odfiltrowaniu
- Kursy Online 167 wyników po odfiltrowaniu
- Wydarzenia 7 wyników po odfiltrowaniu
- Dane Badawcze 22314 wyników po odfiltrowaniu
wyświetlamy 1000 najlepszych wyników Pomoc
Wyniki wyszukiwania dla: METAL DUSTING
-
Reliability of quality forecast for hybrid metal-working machinery
Publikacja -
NOBLE METAL MODIFIED TiO2 FOR PHOTOCATALYTIC AIR PURIFICATION
PublikacjaTiO2 was surface modified with silver, gold, palladium and platinum ion clusters to improve its photocatalytic activity. The effect of metal content, the kind of dopant used during preparation procedure on the photoactivity were investigated. in toluene removal which was used as a model volatile organic compound. Toluene, at the concentration of about 100 ppm, was irradiated over noble metal modified TiO2 using light-emitting diodes...
-
Methodological evaluation of method for dietary heavy metal intake
PublikacjaNarażenie człowieka na działanie zanieczyszczeń środowiskowych jest poważnym problemem w obecnych czasach. Metale ciężkie są uważane za toksyczne dla człowieka ze względu na tendencję kumulowania się w wybranych tkankach organizmu. Ponadto, ich obecność w ustroju jest przyczyną wielu schorzeń. Substancje szkodliwe mogą przenikać do organizmu kilkoma drogami, m.in. poprzez spożywanie skażonej żywności. Biorąc pod uwagę ryzyko związane...
-
Influence of sludge treatment processes on heavy metal speciation
PublikacjaSludge composition is depending on sewage quality and also affected by processing methods such as thickening, stabilization and dewatering. During those processes some of sludge's undesirable properties might be reduced or enhanced.The objective of the study is the assessment of the influence of sludge processing on selected heavy metals partitioning between phases (aqueous and particle) and sludge. Sludge from the WWTP in Gdansk...
-
Metal Foams as Novel Catalyst Support in Environmental Processes
Publikacja -
Chlorination of Carbon Nanotubes Obtained on the Different Metal Catalysts
Publikacja -
Enantioselective Gel Phase Synthesis of Metal–Organic Materials
Publikacja -
Simultaneous Analysis of Heavy Metal Concentration in Soil Samples
Publikacja -
The recovery and the separation of metal ions from galvanic wastewaters
Publikacja -
Advances in Sheet Metal Forming Processes of Lightweight Alloys
Publikacja -
Preparation, characterization and photocatalytic activity of metal-loaded NaNbO3
Publikacja -
Central Metal Determines Pharmacokinetics of Chlorophyll-Derived Xenobiotics
Publikacja -
Metal-Organic Framework (MOF)/Epoxy Coatings: A Review
PublikacjaEpoxy coatings are developing fast in order to meet the requirements of advanced materials and systems. Progress in nanomaterial science and technology has opened a new era of engineering for tailoring the bulk and surface properties of organic coatings, e.g., adhesion to the substrate, anti-corrosion, mechanical, flame-retardant, and self-healing characteristics. Metal-organic frameworks (MOFs), a subclass of coordinative polymers...
-
Metal implants in ostheosynthesis - construction solutions, materials and applications
PublikacjaThe aim of the article is to present two case studies on intramedullary nails. The research included the evaluation of the type of fracture and the analysis of microstructure, chemical composition and hardness of the implant material.
-
Morphology control through the synthesis of metal-organic frameworks
PublikacjaDesignable morphology and predictable properties are the most challenging goals in material engineering. Features such as shape, size, porosity, agglomeration ratio significantly affect the final properties of metal- organic frameworks (MOFs) and can be regulated throughout synthesis parameters but require a deep under- standing of the mechanisms of MOFs formation. Herein, we systematically summarize the effects of the indi- vidual...
-
Thermally induced formation of zinc oxide nanostructures with tailoring morphology during metal organic framework (MOF-5) carbonization process
Publikacja -
Heavy metals removal in the mechanical - biological wastewater treatment plant ''Wschod'' in Gdańsk. Usuwanie metali ciężkich w mechaniczno-biologicznej oczyszczalni ścieków Gdańsk ''Wschód''.
Publikacja.
-
Simultaneous Removal of Heavy Metals from Wastewater Using Modified Sodium Montmorillonite Nanoclay
Publikacja -
Synthesis of carbon nanotubes via chemical vapor deposition by using rareearth metals as catalysts
Publikacja -
An optimized system for sensor ontology meta-matching using swarm intelligent algorithm
PublikacjaIt is beneficial to annotate sensor data with distinct sensor ontologies in order to facilitate interoperability among different sensor systems. However, for this interoperability to be possible, comparable sensor ontologies are required since it is essential to make meaningful links between relevant sensor data. Swarm Intelligent Algorithms (SIAs), namely the Beetle Swarm Optimisation Algorithm (BSO), present a possible answer...
-
Class of 2020 in Poland: Students’ Mental Health during the COVID-19 Outbreak in an Academic Setting
Publikacja -
In Situ Micro-Observation of Surface Roughness and Fracture Mechanism in Metal Microforming of Thin Copper Sheets with Newly Developed Compact Testing Apparatus
Publikacja -
Explosive welding of metals.
PublikacjaPrzedstawiono wytwarzanie i zastosowanie łączników zgrzewanych wybuchowo oraz wpływ podłoża na ten proces.
-
Drug Testing and Analysis
Czasopisma -
Journal of Analysis and Testing
Czasopisma -
International Journal of Testing
Czasopisma -
GEOTECHNICAL TESTING JOURNAL
Czasopisma -
Language Testing in Asia
Czasopisma -
Materials Testing (MATERIALPRUFUNG)
Czasopisma -
JOURNAL OF TESTING AND EVALUATION
Czasopisma -
Deformation of thin metal and composite sheets by using anti-buckling fixture for large deformation under tension–compression cyclic loading
Publikacja -
Investigating COVID-19 active pharmaceutical ingredients (APIs) degradation using Peroxydisulfate/FeMnOx binary metal oxide/Ultrasound System
PublikacjaDegradation of Favipiravir using a hybrid system of peroxydisulfate, FeMnOx binary metal oxide, and ultrasound irradiation was studied. A novel catalyst was synthesized with deep eutectic solvent (DES). The effects of DES type on catalytic performance was evaluated and the catalysts were characterized using XRD, SEM, BET, XPS, and EDS. DES-based catalysts exhibited higher efficiency due to structure change, surface area enhancement...
-
Meta: Avaliacao
Czasopisma -
A Low-Profile Metal-backed Dipole Loaded with Closely Coupled Arc-shaped Open Stubs for On-metal Tag Design with Wide Frequency Tuning Capability
PublikacjaThis research has presented a single-layer metal-backed dipole antenna, which consists of a feedline loaded with two pairs of closely-coupled arc-shaped open stubs, for designing a metal-mountable tag that features tuning capability over a wide range of frequency. Here, the stubs can generate sufficient inductive reactance for bringing down the tag resonant frequency tunable in both the regulated UHF RFID passbands (North American...
-
Research into properties of wear resistant ceramic metal plasma coatings
Publikacja -
Diffusible hydrogen content in deposited metal of multilayer welded joints
PublikacjaThe article describes manufacturing technology of multilayer joints in terms of control the diffusible hydrogen content. Diffusible hydrogen content in deposited metal for multilayer welded joints made of covered rutile electrodes or covered cellulosic and basic electrodes was determined. It was found that after four beads, the diffusible hydrogen content decreases in the case of the first technology from 36 ml/100 g to 18 ml/100...
-
Pr-doped TiO2: The effect of metal content on photocatalytic activity
PublikacjaThe Pr-TiO2 nanoparticles were prepared by using the sol-gel method. As-prepared samples were characterized by BET measurements, X-ray powder diffraction analysis (XRD) and UV-Vis spectra. Visible and ultraviolet light photocatalytic activity of the sample was studied by photodegradation of phenol while considering the influence of the dopant concentration. TiO2 doped with 0.25 mol% of praseodymium showed the highest photocatalytic...
-
Metal accumulation in the human uterus varies by pathology and smoking status
Publikacja -
The Effect of Welding Conditions on Diffusible Hydrogen Content in Deposited Metal
PublikacjaThe article presents the results of a literature survey and preliminary tests which set out effects of welding conditions on the amount of diffusible hydrogen in deposited metal. Experiments were conducted by using rutile coated electrodes which generate high contents of diffusible hydrogen in deposited metal. The amount of diffusible hydrogen was determined by a glycerin test.Eleven factors were considered: the electrode angle,...
-
Rtęć jako najbardziej toksyczny metal w Zatoce Puckiej
PublikacjaMonografia obejmuje najważniejsze informacje o ekosystemie Zatoki Puckiej. Układ treści został przedstawiony tematycznie, co umożliwia śledzenie zmian przyczynowo -skutkowych pomiędzy głównymi składnikami ekosystemu akwenu. Publikacja składa się z trzech tomów:− Zatoka Pucka, tom I – aspekty geologiczne i fizyczne;− Zatoka Pucka, tom II – aspekty chemiczne;− Zatoka Pucka, tom III – aspekty świata ożywionego.
-
Transition Metal Oxides influence on phosphate and borate glasses structure
PublikacjaBorate and phosphate glasses possess many potential luminescence and optical applications. With their low melting point, they are one of the most often studied amorphous materials. In recent years these glasses, doped with transition metal oxides (TMO), gained much attention due to their tunable structural and thermal properties. Review of systems containing TMOs was presented. Additionally synthesis of binary MnO-P2O5 and MnO-B2O3...
-
Dynamics of Organic Cations in Switchable Quinuclidinium Metal Chloride Dielectrics
Publikacja -
Ellipsometric data analysis used in on-line metal passivation monitoring
Publikacja -
The (Bi,Pb)4Sr3Ca3Cu4Ox glass-ceramics: disordered metal and superconductor
PublikacjaAmorficzny materiał (Bi,Pb)4Sr3Ca3Cu4Ox wygrzewany w odpowiednich warunkach staje się granulastym metalem i nadprzewodnikiem. Może być uważany za silnie nieuporządkowany metal. Ma duży opór i zazwyczaj ujemny współczynnik temperaturowej zależności oporu. Nieuporządkowanie i granulasty charakter materiału ujawnia się również w jego właściwościach nadprzewodzących.
-
Lanthanide metal–organic frameworks: Structural, thermal and sorption properties
Publikacja -
Evaluation of specific capacity of poultry litter in heavy metal sorption
Publikacja -
Elipsometric data analysis used in on-line metal passivation monitoring
PublikacjaWykorzystano technikę elipsometrii monochromatycznej do opisu on-line warstw tlenkowych, elektroosadzanych na miedzi. Elipsometria jest w stanie dostarczyć informacji odnośnie grubości i współczynników załamania światła układów warstwowych, jednakże wymagane w tym celu jest zbudowanie matematycznego modelu odwzorowującego stałe optyczne układu badanego. W powyższej pracy przedyskutowane zostały różne metody dopasowywania modelu...
-
Metal Supported Solid Oxide Fuel Cells - Selected Aspects
PublikacjaW artykule przedstawiono wyniki badań nad tlenkowymi ogniwami paliwowymi zbudowanymi na stalowym interkonektorze.
-
Positron binding to alkali-metal hydrides: The role of molecular vibrations
PublikacjaThe bound vibrational levels for J=0 have been computed for the series of alkali-metal hydride molecules from LiH to RbH, including NaH and KH. For all four molecules the corresponding potential-energy curves have been obtained for each isolated species and for its positron-bound complex (e+XH). It is found that the calculated positron affinity values strongly depend on the molecular vibrational state for which they are obtained...
-
Syntheses and Structures of Transition Metal Complexes with Phosphanylphosphinidene Chalcogenide Ligands
PublikacjaThe reactivity of the phosphanylphosphinidene complex [(DippN)2W(Cl)(η2-P-PtBu2)]− (1) toward chalcogens (Ch = Se, S) was studied. Reactions of stoichiometric amounts of 1 with chalcogens in DME yielded monomeric tungsten complexes with phosphanylphosphinidene chalcogenide ligands of the formula tBu2P−P−Ch (Ch = Se (in 2) and S (in 5)), which can be regarded as products of the addition of a chalcogen atom to a P=W bond in starting...