Filters
total: 6251
filtered: 5648
-
Catalog
Chosen catalog filters
displaying 1000 best results Help
Search results for: DAYLIGHT ASSESSMENT METHODS
-
Methods of Incomplete and Uncertain Knowledge Acquisition in the Knowledge Processing Environemnt
PublicationThe authors in this paper present a concept of the environment to acquire and process knowledge about information technology. This solution is part of a project of which the objective is to build a system for the evaluation of IT tools and methodologies. Knowledge within this domain is always either uncertain or incomplete. Therefore, the authors focused on designing a dedicated algorithm for its acquisition and processing. One...
-
SMOTE-Based Homogeneous Ensemble Methods for Software Defect Prediction
Publication -
Improvement of damage detection methods based on experimental modal parameters
PublicationW pracy przedstwiono sposoby porawy czułości metod detekcji uszkodzeń wykorzystujacych eksperyentalne parametry modalne konstrukcji. Wykazano, że zastosowanie zawansowanych technik obróbki sygnałów pomiarowych pozwala zdecydowanie poprwaić skutecznośc znanych z literatury metod.
-
Optimising DNA binding to carbon nanotubes by non-covalent methods
Publication -
Alternative Methods of Preparation of Soluble Keratin from Chicken Feathers
PublicationHuge amount of keratinous waste, especially birds’ feathers, demands more value-added application instead of dumping. The present work reports the results of experiments aimed at preparing soluble keratin useful for novel bioproduct formation. The effect of thermo-chemical treatments with various reducing agents, i.e. 2-mercaptoethanol, dithiothreitol, sodium m-bisulphite, and sodium bisulphite, as well as sodium hydroxide, on...
-
Methods of estimating the cost of traffic safety equipment’s life cycle
Publicationn the article, the authors discuss the preliminary information necessary to determine the scope and direction of further research conducted within the project called “The influence of time and operating conditions on the durability and functionality of road safety elements”. The main objective of the project is to develop the concept of a method for optimizing the life cycle costs of road safety devices. The authors draw attention...
-
The effectivness of fault detection in common rail injectors examination methods
PublicationThe article presents the effectiveness tests of fault detection in common rail injectors. 40 injectors with different wear levels were tested. Testing was made on two test benches of a completely different design. Research includes comparison of accuracy, reproducibility and testability to detect specific defects. A device was created for visualization of the fuel injector spraying steam.
-
Determination of benzo(a)pyrene content in PM10 using regression methods
PublicationThe paper presents an attempt of application of multidimensional linear regression to estimation of an empirical model describing the factors influencing on B(a)P content in suspended dust PM10 in Olsztyn and Elbląg city regions between 2010 and 2013. During this period annual average concentration of B(a)P in PM10 exceeded the admissible level 1.5-3 times. Conducted investigations confirm that the reasons of B(a)P concentration...
-
Methods of Network Resource Provisioning for the Future Internet IIP Initiative
PublicationIn this paper, we present specification, design and implementation aspects of a network resource provisioning module introduced for the Polish Initiative of Future Internet called System IIP. In particular, we propose a set of novel LP optimization models of network resource provisioning designed to minimize the network resource consumption, either bandwidth or node’s computational power, as well as to maximize the residual capacity....
-
Methods for evaluating rated power of diesel-powered generator set
PublicationBasic concepts for evaluating rated power of generator sets powered by combustion engines are presented in this article. A relation between parameters of the engine and the generator are shown. Recommendations contained in the standards and technical literature are systematized. The scheme and methodology for evaluating rated power of the generator set, based on laboratory research, are suggested. Also, the main problems which...
-
Improved methods for stator end winding leakage inductance calculation
PublicationCalculating the stator end-winding leakage inductance, taking into account the rotor, is difficult due to the irregular shape of the end-winding. The end-winding leakage may distribute at the end of the active part and the fringing flux of the air gap. The fringing flux belongs to the main flux but goes into the end-winding region. Then, not all the magnetic flux occurring in the end region is the end-winding leakage flux. The...
-
Occurrence and Levels of Biogenic Amines in Beers Produced by Different Methods
PublicationThe concentration of biogenic amines (BAs) in beer depends, among other factors, on the activity of microorganisms, in particular lactic acid bacteria. In this work an analytical method based on derivatization with tosyl chloride and high-performance liquid chromatography-tandem mass spectrometry (HPLC-MS/MS) was used to determine 17 BAs in samples of commercially available beers, and to monitor the changes in concentration of...
-
Social Media in the Fashion Industry. Fundamentals, Strategy and Research Methods
PublicationThis book introduces social network fundamentals in the fashion domain. It addresses the creation of social media marketing plans, highlighting strategic approaches that allow fashion brands to differentiate themselves in the ephemeral and challenging fashion context. Through a variety of academic and professional sources and by sharing the results of their own research, the authors present research methodologies, including netnography,...
-
The comparative study of different methods of spectral analysis of electrochemical oscillations
PublicationOscylacje elektrochemiczne często połączone są z roztwarzaniem metali. One często wykazują niestacjonarny charakter. W związku z czym wydaje się konieczne wykonanie analizy w równoczesnej dziedzinie czasu i częstotliwości. Zaprezentowano porównanie trzech nowych metod: STFT, transformacji falkowej i rozkładu Wigner-Ville´a. Zalety tych metod zostały wypunktowane oraz wykazane zostały różnice pomiędzy analizą Fourierowską i technikami...
-
Comparing some convolution-based methods for creation of surround sound
PublicationW referacie przedstawiono eksperymenty związane z symulacją dźwięku dookólnego w sali koncertowej. W tym celu wykorzystano splot odpowiedzi impulsowej z danego wnętrza (wielokanałowe nagrania odpowiedzi impulsowej) z nagraniami z komory bezechowej. Uzyskany w ten sposób sygnał został następnie przypisany do odpowiednich kanałów w systemie dookólnym. Uzyskane w ten sposób nagrania były następnie porównywane w testach subiektywnych...
-
On application of the Case-Based Reasoning methods in ship automation design
PublicationW artykule przedstawiono metodę wnioskowania na podstawie przypadków oraz dwa przykłady jej zastosowania w projektowaniu statków. Pierwszy przykład dotyczy systemu projektowania koncepcyjnego statku. Drugi przykład odnosi się do projektowania układów automatyki okrętowej. Omówiono szczegółowo problemy doboru funkcji podobieństwa w metodzie wnioskowania na podstawie przypadków.
-
Optical excitation methods in active dynamic thermography in medical diagnostics.
PublicationArtykuł zawiera opis metod pobudzania cieplnego badanych obszarów ciała ludzkiego w technice aktywnej termografii dynamicznej. Jako źródła pobudzenia cieplnego mogą być stosowane lampy podczerwieni, lampy halogenowe dużej mocy, a także lasery. W artykule opisano również algorytmy obliczeń obrazów parametrycznych.
-
Methods for displacement and rotation measurements of individual Taylor-Schneebeli grains.
PublicationW artykule przedtawiono autorską metodę pomiaru przemieszczeń oraz obrotów cząstek ośrodka analogowego Taylor-Schneebeli oraz propozycję interpretacji badań.
-
Waveform relaxation and comparison methods for multistep boundary value problems
PublicationStosując metody o których mowa w tytule pracy, podano warunki dostateczne na istnienie i jednoznaczność rozwiązania układów równań różniczkowo-funkcyjnych z warunkami brzegowymi. Pokazano zbieżność tych metod do rozwiązania problemu. Otrzymane wyniki zilustrowano przykładami.
-
New Methods of Short-Circuit Current Limiting and Switching-off
PublicationPrzedstawiono wyniki badań symulacyjnych i eksperymentalnych hybrydowych indukcyjno-tyrystorowych ograniczników i wyłączników prądu zwarciowego. Impedancja dławika ogranicznika prądu jest wtrącana do obwodu zwarciowego dopiero w chwili, gdy prąd zwarciowy przekroczy wartość prądu wymuszonego w dławiku przez zewnętrzne źródło prądu. Ograniczanie dynamiki prądu zwarciowego jest bezzwłoczne. Układ nie generuje przepięć łączeniowych....
-
Application of time-frequency methods for analysis of dynamic silo flow
PublicationW artykule przedstawiono możliwość stosowania metod czasowo-częstotliwościowych w analizie dynamicznego przepływu materiału sypkiego w silosie. W pracy omówiono wyniki FT (Fourier Transform), STFT (Short Time Fourier Transform) oraz WT (Wavelet Transform)
-
The methods of fretting wear prevention in machine elements : chapter 9
PublicationOpisano skutki procesu frettingu w elementach maszyn i warunki ich wystąpienia. Przedstawiono przegląd metod zapobiegania zużyciu frettingowemu i jego ograniczania. Opisano laboratoryjne badania zużywania frettingowego wybranych skojarzeń w warunkach umożliwiających ograniczanie zużycia.
-
Implementation of non-local integral models into commercial FE methods
PublicationArtykuł omawia implementacje nielokalnych modeli typu całkowego do komercyjnych programów MES. Implementacje pokazano na przykładzie programu Abaqus.
-
Monitoring Steel Bolted Joints during a Monotonic Tensile Test Using Linear and Nonlinear Lamb Wave Methods: A Feasibility Study
PublicationThe structural integrity of steel bolted joints may be compromised due to excessive loading. Therefore, condition assessment and the detection of potential defects before they cause a failure have become a major issue. The paper is focused on the condition monitoring of a bolted lap joint subjected to progressive degradation in a tensile test. The inspection used Lamb waves propagated through the overlap area. Wave propagation...
-
Automatic Credibility Assessment of Popular Medical Articles Available Online
Publication -
Chapter 23. Fate assessment of ionic liquids in porous media
PublicationW ostatnich latach obserwowany jest wzrost zainteresowania zastąpieniem tradycyjnych lubrykantów cieczami jonowymi z uwagi na ich szczególne właściwości fizykochemiczne zwłaszcza brak lotności -istotny z punktu bezpieczeństwa stosowania. Ciecze jonowe, choć nielotne, są związkami stosunkowo toksycznymi w stosunku do mikroorganizmów i bezkręgowców. Z tego względu ich zachowanie się w środowisku oraz parametry transportu powinny...
-
Assessment of usefulness of different tacks in laparoscopic ventral hernia repair
PublicationLaparoscopic ventral hernia repair is becoming a popular technique with good results and fast postoperative recovery. The mesh is placed directly under the peritoneum and anchored with transabdominal sutures and tacks. However, the ideal size of the mesh covering the hernia orifice is know, nor the ideal type or amount of tacks has to be described.
-
Assessment of evaporator tubes corrosion in low-emission steam boilers
PublicationW artykule przedstawiono wyniki badań rur ekranowych(16Mo3) kotła niskoemisyjnego po jednym roku i dwóch latach eksploatacji. Powierzchnie rur pokryte zostały warstwami natryskiwanymi cieplne - pojedynczą ze stopu 70%Ni 30%Cr i podwójną Ni-30Cr /Al2O3. Rury bez powłok natryskiwanych wykazywały pocienienie ze względu na działanie korozji siarkowej oraz korozyjnego oddziaływania warstwy stopionych soli. Pojedyncza warstwa 70%Ni 30%Cr...
-
Assessment of cavitation erosion damage of laser remelted the SUPERSTON alloy
PublicationW artykule przedstawiono wpływ obróbki laserowej w warunkach kriogenicznych na mikrostrukturę stopu SUPERSTON po badaniach kawitacyjnych. Badania odporności kawitacyjnej przeprowadzono na stanowisku z wirującą tarczą w IMP PAN Gdańsk. Określono kinetykę ubytku masy próbek podczas testu kawitacyjnego dla stopu odlanego i nadtopionego laserowo.
-
Quality assessment of varistor ZnO structures by resonant ultrasound spectroscopy
PublicationWarystory sa wytwarzane z tlenku cynku ZnO jako cylindrycznie uformowane struktury, a ich jakość zależy od zmieniających się uwarunkowań technologicznych na etapach formowania ich kształtu oraz spiekania. W związku z tym są one testowane w końcowej fazie produkcji, a elementy wadliwe się odrzuca. Proponujemy testowanie jakości struktur ZnO we wcześniejszej fazie ich wytwarzania w celu wyeliminowania elementów wadliwych z dalszej,...
-
MULTI-CRITERIA ASSESSMENT SYSTEM FOR ARCHITECTURAL DESIGN IN PRACTICE AND TEACHING
Publication -
Assessment of sources of uncertainty in macrophyte surveys and the consequences for river classification
Publication -
Blood pressure variability: Emerging role in risk assessment and therapeutics
Publication -
Assessment of cervical range of motion in patients after axis fracture
Publication -
Assessment of FSW Welds Made of Aluminum Alloy AW7075-T651.
PublicationThis paper summarizes the results of experimental studies in which the aluminum alloy AW7075-T651 was friction stir welded (FSW) using various combinations of process parameters (rotational - R and travel speed - T). Mechanical properties of the test welds were assessed by using static tensile test and Vickers hardness measurement. The temperature of the welded plates was monitored during welding by means of thermocouples placed...
-
Assessment of organic coating degradation via local impedance imaging
PublicationThe paper presents a new approach to organic coating condition evaluation at micrometer scale using localized impedance measurements. It is based on atomic force microscopy (AFM) in contact mode. Impedance is measured between conductive AFM tip and metal substrate covered with organic coating. A single-frequency voltage perturbation signal is applied between the electrodes and current response signal is registered. As the tip is...
-
Assessment of water quality based on multiparameter fiber optic probe
Publication -
Ship Collision Risk Assessment Based on Collision Detection Algorithm
Publication -
Assessment of a critical area for a give-way ship in a collision encounter
Publication -
The assessment of students’ knowledge regarding melanoma and sun-protection habits
Publication -
Tools for an Extended Risk Assessment for Ropax Ship-Ship Collision
Publication -
Odour nuisance assessment of the food industry wastewater treatment plant
Publication -
Assessment of the Impact of Loss-of-Retention Fees on Green Infrastructure Investments
Publication -
Expert system for automatic classification and quality assessment of singing voices
Publication.
-
Expert system for automatic classification and quality assessment of singing voices
Publication.
-
Assessment of the Impact of Split Storage within Modular Multilevel Converter
Publication -
Platelets redox balance assessment: Current evidence and methodological considerations
Publication -
Assessment of the Water Needs of Fruit Plants in the Perspective of Climate Change
Publication -
Selected issues of the reliability and operational assessment of a fire alarm system
Publication -
Research on and Assessment of the Reliability of Railway Transport Systems with Induction Motors
Publication