Filters
total: 11065
filtered: 9792
-
Catalog
Chosen catalog filters
displaying 1000 best results Help
Search results for: FRACTOGRAPHIC ANALYSIS
-
Methods of electrochemical noise analysis for investigation of corrosion processes
PublicationKorozja elektrochemiczna może być oceniana za pomocą przpływu ładunków między korodującym metalem a elektrolitem. Zwykle, przpływ ładunku obserwuje się w układzie trzech elektrod jako fluktuacje prądu i napięcia (szumy elektrochemiczne). Na podstawie analizy szumów elektrochemicznych można wykrywać różne rodzaje korozji. Korozja jednorodna jest oceniana za pomocą wartości rezystancji polaryzacyjnej występującej między metalem a...
-
Sampling of atmospheric precipitation and deposits for analysis of atmospheric pollution
PublicationPrzedstawiono przegląd technik i przyrządów pomiarowych stosowanych w celu pobierania próbek mokrej i mgielnej depozycji (mgła, woda z chmur, szron, szadź, rosa). Przedstawiono również informacje literaturowe na temat oznaczania związków nieorganicznych i organicznych w próbkach opadów i osadów atmosferycznych z zastosowaniem odpowiednich technik pomiarowych.
-
Dynamic and tomography analysis of granular flow in cylindrical shell
PublicationW pracy przedstawiono wyniki badań ekperymentalnych dotyczących efektów dynamicznych występujących podczas przepływu materiałów sypkich w silosie cylindrycznym.
-
A brief note on entire fracture surface topography parameters for 18Ni300 maraging steel produced by LB-PBF after LCF
PublicationThe concept of entire fracture surface investigation is helpful in explaining fatigue phenomena. In this paper, this method has been applied for 18Ni300 maraging steel using a 3D measurement system. Before post-mortem analysis, the specimens produced by laser beam powder bed fusion (LB-PBF) were tested under low-cycle fatigue (LCF) for eight strain amplitudes in the interval 0.3% to 1.0%. The attention was placed on the relationship...
-
Comparative analysis of mechanical conditions in bone union following first metatarsophalangeal joint arthrodesis with varied locking plate positions: A finite element analysis
PublicationFirst metatarsophalangeal joint arthrodesis is a typical medical treatment performed in cases of arthritis or joint deformity. The gold standard for this procedure is arthrodesis stabilisation with the dorsally positioned plate. However, according to the authors’ previous studies, medially positioned plate provides greater bending stiffness. It is worth to compare the mechanical conditions for bone formation in the fracture callus...
-
Shift-Msplit* Estimation in Deformation Analyses
Publication -
Network analyses with the use of spatial databases
Publication -
COMPARATIVE ANALYSES OF INTERNATIONALIZATION OF KAZAKHSTAN ENTERPRISES
PublicationThis paper presents the instruments of internationalization of enterprises operating within the Eurasian Economic Union. Research contains answers of 108 enterprises exporters located in the Republic of Kazakhstan. The purpose of the paper is to show the main forms of the internationalization of enterprises in Kazakhstan. The paper also presents the following instruments of enterprises’ internationalization including: indirect...
-
Elemental composition analysis of Pistacia lentiscus L., leaves collected from Mitidja plain in Algeria using instrumental neutron activation analysis (INAA) technique
Publication -
Performance Analysis of Developed Multimodal Biometric Identity Verification System
PublicationThe bank client identity verification system developed in the course of the IDENT project is presented. The total number of five biometric modalities including: dynamic handwritten signature proofing, voice recognition, face image verification, face contour extraction and hand blood vessels distribution comparison have been developed and studied. The experimental data were acquired employing multiple biometric sensors installed...
-
Modal analysis of railway current collectors using Autodesk Inventor
PublicationThe paper presents the results of modal analysis of railway current collector type 160EC. In the first place, the analysis was carried out analytically for a simplified two lumped mass pantograph model. Then numerical analysis was conducted in the Autodesk Inventor (AI) on the prepared multibody model using the AI modal analysis algorithm, which is based on the finite element method (FEM). Model elements which are most relevant...
-
Elastoplastic nonlinear FEM analysis of FGM shells of Cosserat type
PublicationThe paper is a continuation of [1] where the formulation of the elastic constitutive law for functionally graded materials (FGM) on the grounds of nonlinear 6-parameter shell theory with the 6th parameter (the drilling degree of freedom) was presented. Here the formulation is extended to the elasto-plastic range. The material law is based on Cosserat plasticity and employs the well-known Tamura-Tomota-Ozawa (TTO) [2] mixture...
-
Emotion Recognition - the need for a complete analysis of the phenomenon of expression formation
PublicationThis article shows how complex emotions are. This has been proven by the analysis of the changes that occur on the face. The authors present the problem of image analysis for the purpose of identifying emotions. In addition, they point out the importance of recording the phenomenon of the development of emotions on the human face with the use of high-speed cameras, which allows the detection of micro expression. The work that was...
-
Analysis of Transparent Concrete as an Innovative Material Used in Civil Engineering
PublicationSince the dawn of history concrete has been, right behind stone and brick, one of the oldest building materials. The ancient Romans took advantage of its opportunities. They constructed amazing architectural objects, which survived centuries as whole buildings or parts of them. Concrete is so ubiquitous, that when we are walking in a newer districts of cities we are virtually surrounded by concrete from everywhere. Sometimes...
-
Analysis of size and shape of abrasive micrograins in lapping of assembly joints
PublicationPrzedstawiono skomputeryzowana analizę wielkości i kształtu mikroziaren ściernych. W badaniach mikroziaren węglika boru, węglika krzemu i elektrokorundu zastosowano mikroskopie optyczna oraz specjalistyczne oprogramowanie MultiScan v.6.08
-
New Methods of Spectral Analysis of Current Oscillations of Electrochemical Processes
Publication -
Impedance analysis of Portevin-Le Chatelier effect on aluminium alloy
Publication -
Application of Discrete Wavelet Transform in the Analysis of Nonlinear Chemical System
Publication -
Nonlinear principal component analysis of the tidal dynamics in a shallow sea
Publication -
Adapting the pinch point analysis to improve the ORC design process
PublicationPinch point analysis can be adapted so as to assist in the early stages of designing the ORC systems. Typically used in determining the working parameters of heat exchangers, it can be employed to improve the heat fitting between the source of heat and the working fluids of the ORC system. To attain the parametric match, an algorithm was built enabling quick estimation of the possible heat reception by the specific working fluid....
-
Comparative Analysis of Two Polish Hyperbolic Systems AEGIR and JEMIOLUSZKA
PublicationGlobal Navigation Satellite System (GNSS) is seen by terrorists or hostile countries as a high value target. Volpe Center report contains the following statement: “During the course of its development for military use and more recent extension to many civilian uses, vulnerabilities of Global Navigation Satellite Systems (GNSS) – in the United States the Global Positioning System (GPS) – have become apparent. The vulnerabilities...
-
MODEL OF MULTILEVEL STOCHASTIC ANALYSIS OF ROAD SAFETY ON REGIONAL LEVEL
PublicationIn this paper multilevel approach to the issue of road safety level on the road network of European regions, classified as NUTS 2 in statistical databases of the European Union, has been presented. Following the pattern of many publications on road safety it has been assumed that the risk calculated as the number of death casualties in road accidents per 100,000 inhabitants of a given region has Poisson distribution. Therefore,...
-
Wavelet Transform Analysis of Temperature Modulated Gas Sensor Response
PublicationThe aim of the study was to evaluate whether it is possible to extract the information about the gas concentration despite the influence of humidity. Commercial semiconductor sensor response was examined under the application of a periodic temperature change. The data was collected using measurement protocol for different concentrations of ammonia at specified levels of relative humidity. In this work we focused on the evaluation...
-
Selection of derivatisation agents for chlorophenols determination with multicriteria decision analysis
PublicationThe paper shows very systematic method of selection of derivatisation agents for a given group of analytes. In this study 8 derivatisation agents are assessed for their capability to derivatise 8 chlorophenols. Multicriteria decision analysis is used to combine many objectives of derivatisation agents selection into single, easy to be interpreted numerical value. Three basic analyses were performed to obtain rankings with the aims...
-
FEM ANALYSIS AND EXPERIMENTAL TESTS OF RIGID RISER HANGING SYSTEM
PublicationThe article presents the analysis, project, and experimental examination of an original rigid riser for Coil Tubing Pipes. The principle of riser operation is based on the use of friction forces. The research included the FEM analysis of the designed riser, calculations of the required bolt tensions, and checking the effect of the clamping force on stress distribution in the pipeline. The results of computer simulation were verified...
-
Analysis of the Impact of Charging Electric Cars on the Power System Load
PublicationThe paper presents ways of integrating electric cars with the power system. In connection with this, daily load curves in the average working day have been developed in the G2V (Grid-to-Vehicle) and V2G (Vehicle-to-Grid) variants. The G2V solution consists in unidirectional energy flow from the power system to a vehicle’s battery. The V2G solution consists in bi-directional energy exchange between the power system and electric...
-
FE analysis of support-specimen interaction of compressive experimental test
PublicationThe objective of this work is to investigate the support-specimen interaction during the compressive experimental testing of stiffened plates. The interaction is analyzed employing the nonlinear Finite Element Method using the commercial software ANSYS. The connection between the stiffened plate and testing supports is modelled with the use of contact elements, where several possible interaction scenarios are investigated, and...
-
Analysis of the macrostructure of the fuel spray atomized with marine engine injector
PublicationOne of the main problem influencing the combustion process in the cylinder of the marine engine is an fuel spray phenomena. The parameters describing the shape of the fuel spray are named macro parameters. This article presents the research results of the macrostructure parameters of the fuel spray atomized with the marine engine injector. The research were carried out by optical visualization measurement method of Mie scattering....
-
Application of molecularly imprinted polymers in analytical chiral separations and analysis
PublicationOver the last two decades the process of development and application of a new types of molecular imprinted polymer (MIP) sorbents in the field of analytical chemistry have been widely described in the literature. One of the new trends in analytical chemistry practice is the use of new types of MIP sorbents as specific sorption materials constituting the stationary phase in advanced separation techniques. The following review paper...
-
Analysis of ship's magnetic field with consideration of inner ferromagnetic devices
PublicationThis paper presents computer simulations of ship’s magnetic signatures. The influence of ship’s inner ferromagnetic devices on the signature was presented. The magnetic fields of the ship’s model were calculated in Opera 3D 18R2. The model was built from thin plates. The new, thin plate boundary condition was introduced on all ship’s surfaces.
-
Analysis and evaluation of grouping methods for effective cutting tool operation
PublicationThis article presents the possibilities for using cluster analysis in the assignment of machine tools in automated manufacturing systems. Based on the similarity of manufacturing processes in the system, cutting tools have been grouped. The objective was to obtain groups of similar objects, which could potentially ensure the reduction of the frequency and time of setups, optimizing the maintenance of tool resources and improving...
-
The Application of Vibration Recording and Analysis in Tribological Research on Sliding Friction
PublicationThe paper reports on a tribological research on the macroscopic manifestation and characteristics of sliding friction. The aim of the task was to measure friction in lubricated sliding contacts and test the interactions between the environment (the test rig) and the experimental friction contact. Friction-induced vibrations were observed and studied as a manifestation of the process. The typical set of velocity and force/torque...
-
Timber Frame Houses with Different Insulation Materials - Seismic Analysis
PublicationThe aim of this article is to present results of a dynamic numerical analysis focused on the response of two timber frame building structures exposed to seismic excitations. The first structure was insulated with mineral wool, while the second one with polyurethane foam. Specifications and technology involved in the models' construction are based on the previously conducted experimental study, upon which numerical structural models...
-
An algorithm for enhancing macromodeling in finite element analysis of waveguide components
PublicationAn algorithm for enhancing the finite element method with local model order reduction is presented. The proposed technique can be used in fast frequency domain simulation of waveguide components and resonators. The local reduction process applied to cylindrical subregions is preceded by compression of the number of variables on its boundary. As a result,the finite element large system is converted into a very compact set of linear...
-
Multiresolution analysis and adaptive estimation on a sphere using stereographic wavelets
PublicationWe construct an adaptive estimator of a density function on d dimensional unit sphere Sd (d ≥ 2), using a new type of spherical frames. The frames, or as we call them, stereografic wavelets are obtained by transforming a wavelet system, namely Daubechies, using some stereographic operators. We prove that our estimator achieves an optimal rate of convergence on some Besov type class of functions by adapting to unknown smoothness....
-
Discovering Rule-Based Learning Systems for the Purpose of Music Analysis
PublicationMusic analysis and processing aims at understanding information retrieved from music (Music Information Retrieval). For the purpose of music data mining, machine learning (ML) methods or statistical approach are employed. Their primary task is recognition of musical instrument sounds, music genre or emotion contained in music, identification of audio, assessment of audio content, etc. In terms of computational approach, music databases...
-
The potential of LC–MS technique in direct analysis of perfume content
PublicationPerfumes are products that consist of a wide range of natural and synthetic compounds. Due to complex composition, the determination of their ingredients is a difficult task. Most of the perfume components are either volatile or semi-volatile; however, most of the attention has been paid to volatile ones, and thus, gas chromatography or electronic noses are generally used. Nevertheless, in this study, liquid chromatography coupled...
-
Analysis and improvement attempt of prof. Alan Fowler’s negotiation game
PublicationThe main goal of the following article is to design an improved version of the negotiation game created by prof. Alan Fowler (Fowler, 1997). I have tried to achieve this by constructing four separate versions of the game which represent different approaches while preserving rules, chosen basic technical assumptions and the simplicity of the base game. Each version of the game is supposed to i.a. make it less obvious, create new...
-
Analysis and interpretation of radiometric signals in a liquid-gas bubble flow
PublicationThe article presents the analysis of signals from a radiometric system consisting of two scintillation probes and two gamma radiation sealed sources. Calculations and interpretation were carried out for the bubble flow of the water-air mixture in the horizontal pipeline. The analysis of the obtained signals was done in time and frequency domain. In the frequency domain, a range of usable frequencies was identified, which were associated...
-
Quantitative Analysis of Flavonoids in the Flowers and Leaves of Ficaria verna Huds.
Publication -
Analysis of Keratoconus genetic factors within Keratoconus Loci and mtDNA
Publication -
QSPR analysis of some agonists and antagonists of α-adrenergic receptors
Publication -
Errors analysis of differential single-frequency geo-positioning algorithm
Publication -
Shotgun Lipidomic Analysis for Differentiation of Niche Cold Pressed Oils
Publication -
CFD analysis of jet flows ejected from different nozzles
Publication -
New aspects of the use of Optical Theorem in the analysis of microcavity lasers
Publication -
Investigation of the reliability of local strain analysis by means of the triangle modelling
Publication -
Irregular variations in GPS time series by probability and noise analysis
Publication -
The dynamic analysis of a cracked Timoshenko beam by the spectral element method
Publication -
Ellipsometric data analysis used in on-line metal passivation monitoring
Publication